Ruijie RG-PF2920-DPBOX-P Series Manuel d'installation et d'exploitation

RG-PF2920-DPBOX-P Series

Switch

Hardware Installation and Reference Guide

Document version: V1.04

Date: 2023-08-03

All rights are reserved in this document and this statement.

Any reproduction, excerption, backup, modification, transmission, translation or commercial use of this

document or any portion of this document, in any form or by any means, without the prior written consent of

Ruijie Networks is prohibited.

Trademark and are owned by Ruijie Networks.

All other trademarks or registered trademarks mentioned inthis document are owned by their respectiveowners.

Disclaimer

The products, services, or features you purchase are subject to commercial contracts and terms. Some or all

of the products, services or features described in this document may not be within the scope of your purchase

or use. Unless otherwise agreed in the contract, Ruijie Networks does not make any express or implied

statement or guarantee for the content of this document.

Due to product version upgrades or other reasons, the content of this document will be updated from time to

time. Ruijie Networks reserves the right to modify the content of the document without any notice or prompt.

This manual is for reference only. Ruijie Networks endeavors to ensure content accuracy and will not shoulder

any responsibility for losses and damages caused due to content omissions, inaccuracies or errors.

Preface

Intended Audience

This document is intended for:

Network engineers

Technical support and servicing engineers

Network administrators

Technical Support

Ruijie Networks website: https://www.ruijienetworks.com/

Technical support website: https://ruijienetworks.com/support

Case portal: https://caseportal.ruijienetworks.com

Community: https://community.ruijienetworks.com

Technical support mailbox: se[email protected]

Live chat: https://www.ruijienetworks.com/rita

Conventions

1. Signs

The signs used in this document are described as follows:

Warning

An alert that calls attention to important rules and information that if not understood or followed can result in

data loss or equipment damage.

Caution

An alert that calls attention to essential information that if not understood or followed can result in function

failure or performance degradation.

Note

An alert that contains additional or supplementary information that if not understood or followed will not lead to

serious consequences.

Specification

An alert that contains a description of product or version support.

2. Note

The manual offers configuration information (including model, port type and command line interface) for

indicative purpose only. In case of any discrepancy or inconsistency between the manual and the actual version,

the actual version prevails.

Hardware Installation and Reference Guide Product Description

- 1 -

1 Product Description

The RG-PF2920-DPBOX-P is the simplified optical Ethernet (SOE) switch released by Ruijie Networks for all-

optical network scenarios. Theswitch connects to the uplink hybrid cable and provides downlink 1000MEthernet

port, and supports PoE for external power supply.

Table 1-1 Configuration of the RG-PF2920-DPBOX-P

Model

10/100/1000M

Base-T Ethernet

Electrical Port

SFP

Port

Available

PoE Power

Dimensions (W

x D x H)

Cooling

RG-

PF2920-

DPBOX-

30 W

120 mm x 40

mm x 28.7 mm

(4.72 in. x 1.57

in. x 1.13 in.)

Natural heat

dissipation for

fanless design

Note

1000Base-T is downward compatible with 100Base-T.

1.2 RG-PF2920-DPBOX-P

Table 1-2 Technical Specifications of the RG-PF2920-DPBOX-P

Model

RG-PF2920-DPBOX-P

CPU

Built-in CPU and single-core processor

BOOTROM

N/A

Flash Memory

N/A

SDRAM

N/A

Supported Optical

Module

1000base-X supported only

See Appendix B.

The supported optical module types may update without prior notification.

Please contact Ruijie Networks for any updates.

SFP Port

1000Base-X

Power Supply

Rated voltage range: 44 V DC to 57 V DC

Rated current: 0.75 A

EEE

Not supported

Hardware Installation and Reference Guide Product Description

- 2 -

PoE

Maximum overall PoE output power: 30 W

Ethernet electrical ports support PoE.

Maximum Power

Consumption

With PoE load: 33 W

Without PoE load: 3 W

Operating

Temperature

Rack deployment: 0ºC to 45ºC (32°F to 113°F) at the altitude between 0 m

to 1,800 m (0 ft. to 5905.51 ft.)

Desktop or ELV box deployment: 0ºC to 40ºC (32°F to 104°F) at the

altitude between 0 m to 1,800 m (0 ft. to 5905.51 ft.)

At the altitude between 1,800 m (5905.51 ft.) and 5,000 m (16404.2 ft.),

every time the altitude increases by 220 m (721.79 ft.), the maximum

temperature decreases by 1°C (1.8°F).

Storage

Temperature

–40°C to +70°C (–40°F to +158°F)

Operating

Humidity

10% to 90% RH (non-condensing)

Storage Humidity

5% to 95% RH (non-condensing)

Fan Module

Natural heat dissipation for fanless design

Intelligent

Temperature

Control

Temperature alarm and overheat protection

EMC Standard

GB/T 9254.1

Safety Standard

GB 4943.1

Dimensions (W x

D x H)

120 mm x 40 mm x 28.7 mm (4.72 in. x 1.57 in. x 1.13 in.)

Weight

0.2 kg (0.44 lbs) (including the package)

Hardware Installation and Reference Guide Product Description

- 3 -

Nameplate format:

Warning

In a domestic environment, this product may cause radio interference in which case the user may be required

to take adequate measures.

1.2.2 Product Appearance

The front panel of the RG-PF2920-DPBOX-P is equipped with one 10/100/1000MBase-T Ethernet port and one

SFP port. The switch is powered through the 54V_DC port.

Product label information

Hardware Installation and Reference Guide Product Description

- 4 -

Figure 1-2 Appearance of the RG-PF2920-DPBOX-P

Hardware Installation and Reference Guide Product Description

- 5 -

Figure 1-3 Rear Panel of the RG-PF2920-DPBOX-P

Note:

1. 10/100/1000Base-T Ethernet port with

auto-negotiation

2. DC power port

3. SFP port

4. Power supply LED

5. Ethernet electrical port LED

6. Ethernet electrical port PoE LED

7. SFP port LED

Hardware Installation and Reference Guide Product Description

- 6 -

1.3 Power Supply

The RG-PF2920-DPBOX-P uses DC input. The rated values are as follows:

Rated voltage range: 44 V DC to 57 V DC

Rated current: 0.75 A

1.4 Heat Dissipation

The RG-PF2920-DPBOX-P adopts natural heat dissipation to ensure that it works properly in a specified

environment. For the RG-PF2920-DPBOX-P, maintain sufficient clearance on both sides of the chassis and

above the chassis for air circulation. Dust the device every three months to avoid blocking ventilation openings

on the housing.

1.5 LEDs

LED

Panel

Identification

Status

Description

Status LED

PWR

Off

The switch is not powered on.

Solid green

The power supply is normal.

Ethernet

electrical port

LED

LAN

Off

The port is not connected.

Solid green

The port works at the rate of

10/100/1000 Mbps.

Blinking green

The port is sending or receiving

data at the rate of 10/100/1000

Mbps.

Ethernet

electrical port

PoE LED

POE

Off

PoE of the port is disabled.

Solid green

PoE of the port is enabled.

SFP port

LED

SFP

Off

The port is not connected.

Solid green

The port is connected.

Blinking green

The port is sending or receiving

data.

Hardware Installation and Reference Guide Preparing for Installation

- 7 -

2 Preparing for Installation

2.1 Safety Precautions

Warning

To avoid personal injury and device damage, carefully read the safety precautions before you install the

RG-PF2920-DPBOX-P.

The following safety precautions may not cover all possible dangers.

2.1.1 Mounting

Avoid exposing the device to high temperatures, dust, or harmful gases. Do not install the device in

environments that are flammable or explosive. Keep the device away from sources of electromagnetic

interference (EMI), such as large radar stations, radio stations, and substations. Do not subject the device to

unstable voltage, vibrations, or excessive noise.

The installation site should be free from water flooding, seepage, dripping, or condensation.

Select the installation site considering communication network planning, technical requirements for

communication equipment, as well as factors such as climate, hydrology, geology, earthquake risk, electrical

power, and transportation.

Cut off all power supplies and unplug all power cords before mounting the switch in a rack or removing the

switch from a rack.

2.1.2 Handling

Avoid handling the device frequently.

Cut off all the power supplies and unplug all power cords before moving or handling the switch.

2.1.3 Electricity

Observe local regulations and specifications during electric operations. Only qualified personnel can perform

such operations.

Before installing the device, check whether there are hidden risks in the operating environment of the device.

For example, check whether the power socket is grounded and whether the ground is wet.

Determine the location of the indoor emergency power supply switch before installing the device. When an

accident occurs, immediately cut off all power supplies.

Do not place the device in a wet position, and keep the device away from liquid.

Warning

Improper or incorrect electric operations may cause a fire, electric shock, and other accidents, and lead to

severe and fatal personal injury and device damage.

Table des matières

Autres manuels Ruijie Changer

Ruijie

Ruijie S8600E Series Manuel

Ruijie

Ruijie RG-NBS3200 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-N18000-XH Series Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-NBS5100-24GT4SFP-P Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-S5300-E Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-ES109DS Manuel utilisateur

Ruijie

Ruijie RG-S5750-E Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-S6930-2C Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-ES100 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-S6250-48XS8CQ Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-S7808C Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-NBS3100 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie XS-S1920 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-S7800C Series Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-ES106D-P V2 Manuel utilisateur

Ruijie

Ruijie Reyee RG-NBS5200-48GT4XS-UP Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-S6510-4C Series Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-NBS Series Manuel utilisateur

Ruijie

Ruijie RG-S6510 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-S5310-E Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-NBS Series Manuel utilisateur

Ruijie

Ruijie Reyee RG-ES106D-P Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-CS85 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-ES206GS-P Series Manuel d'installation et d'exploitation

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Manuel utilisateur