Outback RC4341PA Manuel utilisateur
Photographs are not to scale.
Specifications subject to change
without prior notice.
Assembly and Operating Instructions for Outback®
Magnum 3 Gas BBQ
WARNING
For outdoor use only. Not for commercial use.
Read instructions before using the appliance. Failure to follow instructions could
result in death, serious bodily injury, and/or property loss.
Warning: accessible parts may be very hot. Keep young children and pets away.
Do not move the appliance during use.
Turn off the gas supply at the gas bottle after use.
Any modification of the appliance, misuse, or failure to follow the instructions may be
dangerous and will invalidate your warranty. This does not affect your statutory rights.
Retain these instructions for future reference.
Leak test annually, and whenever the gas bottle is removed or replaced. Check that the
hose connections are tight and leak test each time you reconnect the gas bottle.
For Flare-up control please refer to the ‘OPERATION’ section of this manual.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open barbecue lid or hood.
4. If odour continues, discontinue use and
contact your local dealer.
FOR YOUR SAFETY
1. Do not store or use petrol or other flammable
vapours or liquids in the vicinity of this or any
other appliance.
2. A gas bottle not connected for use shall not be
stored in the vicinity of this or any other
appliance.
0359
RC4341PA
2
Parts List
Quantities vary according to model purchased. Specifications subject to change without prior notice. For
more details on hardware, please see ‘Hardware Reference Diagram’.
CODE PART QTY Magnum 3 Gas BBQ
HOOD
A1 Hood (Pre-Assembled to Body) 1
A2 Hood Handle 1
A3 Heat Indicator 1
A4 Warming Rack 1
BODY
B1 Cooking Grill 2
B2 Flame Tamer 3
B3 Barbecue Body 1
B4 Knob 3
B5 Control Panel 1
B6 Burner 3
B7 Drip Tray 1
B8 Drip Tray Left Bracket 1
B9 Drip Tray Right Bracket 1
B10 Side burner valve, Hose and Regulator Assembly 1
TROLLEY
C1 Side Burner Shelf 1
C2 Side Burner Base 1
C3 Ignition Button 1
C4 Side Burner 1
C5 Side Burner Electrode 1
C6 Side Burner Grid 1
C7 Side Burner Knob 1
C8 Side Shelf 1
C9 Hook Rail 1
C10 Tool Hook 3
C11 Left Front Leg 1
C12 Left Rear Leg 1
C13 Right Front Leg 1
C14 Right Rear Leg 1
C15 Bottle Opener 1
C16 Front Screen 1
C17 Trolley Base 1
C18 Axle 1
C19 Wheel 2
C20 Hubcap 2
HARDWARE
D1 M5x15 Bolt 4
D2 Washer 4
D3 M5 Nut 4
D4 M6x10 Bolt 19
D5 M6x15 Bolt 12
D6 M6x145 Bolt 8
D7 Spacer 8
D8 M6 Nut 4
D9 M4x10 Bolt 2
D10 Locknut 2
D11 Wing Nut 1
Pre-Assembled Component
3
Parts Diagrams
Quantities vary according to model purchased. Specifications subject to change without prior notice. For
more details on hardware, please see hardware pack page.
C12C11
B10
A1
B1
A3
A2
B2
B4
B6
C8
C20
C15
C19
C14
C16
B5
B3
C18
C1 B9
B8
C13
D10
C17
C6
C5
C7
C3
C4
D11
C2
C9
C10
B7
A4
4
Hardware Reference Diagram
Specifications subject to change without prior notice.
D1,D2,D3
D4
D6,D7
D5,D8
D5
D9
M4X10 Bolts （2 pcs）
5
Assembly
IMPORTANT!
TOOLS NEEDED FOR ASSEMBLY: Medium size flat blade or Phillips/Crosspoint screwdriver,
adjustable spanner or metric spanner set.
The assembly of this barbecue at least requires 2 people.
Remove any internal components or packaging from the barbecue body.
Whilst every care is taken in the manufacture of this product, care must be taken during assembly in
case sharp edges are present.
Please read the Important Information section carefully before assembly and use of your
barbecue.
1
2
Attach the Left Front Leg (C11) and Right Front Leg (C13) onto the Trolley Base (C17) using
the M6x15 Bolts (D5x4pcs) as shown.
Attach the Left Rear Leg (C12) and Right Rear Leg (C14) onto the Trolley Base (C17) using
the M6x15 Bolts (D5x4pcs) as shown.
C13
C17
C11
D5
C17
C14
C12
D5
6
3
Unscrew the Locknuts (D10) from both ends of the Axle (C18). Slide the axle through the
corresponding holes in the left legs. Slide the Wheels (C19) over each end of the axle.
Secure the wheels into place with the locknuts. Place the Hubcaps (C20) onto the outsides
of the wheels.
4
Insert M6x145 Bolts (D6x8pcs) through the trolley legs, the Spacers (D7x8pcs), and keep the
tip of the bolts inside the spacers. While holding the barbecue body into position (2 people
required), screw the bolts into the barbecue body as shown.
CAUTION! Care must be taken to ensure the hood or lid does not fall open
unexpectedly or becomes damaged when it is set on the ground.
D6 D7
C19
C18
D10C20
7
6
Attach the Bottle Opener (C15) to the right front leg using a M6x10 Bolts (D4).
5
D4
C15
Attach the Front Screen (C16) to the Front Left / Right Legs as shown.
(Rear view of the barbecue trolley.)
C16
8
Attach the Drip Tray Left Bracket (B8) to barbecue body using M5x15 Bolts (D1x2pcs), Washers
(D2x2pcs) and M5 Nuts (D3x2pcs) as shown. Repeat above process for Drip Tray Right Bracket
(B9).
NOTE: Ensure that the big tabs of the brakets which stop the drip tray are located at the
front of the barbecue.
8
7
Attach the Side Burner Shelf (C1) to the left front / rear Legs using M6x10 Bolts (D4x8pcs).
FRONT
REAR
B8D1 D2 D3
FRONT REAR
C1
D4
9
10
9
Attach the side burner valve onto the side burner base using M4x10 Bolts (D9x2pcs) as shown.
C3
C2
D5
Unscrew the pre-assembled nut of the Ignition Button (C3). Insert the ignition button through the
Side Burner Base (C2) and secure with the pre-assembled nut.
Carefully lay the side burner base into the side burner shelf, then fixing it by using M6x15 Bolts
(D5x4pcs) and M6 Nuts (D8x4pcs) as shown.
D8
D9
Pre-assembled Nut
10
12
11
C7
Press the Side Burner Knob (C7) onto side burner valve stem.
Unscrew the Wing Nut (D11) from the Side Burner (C4). Insert the wire of Side Burner Electrode
(C5) into the hole at the side burner base. Feed the venturi tube of the side burner through the hole
in bottom of side burner base as shown, then fix it and the side burner electrode onto side burner
base using the wing nut. Make sure that the end of venturi tube is set over the gas outlet of side
burner valve.
Step②
Step①
Step③
Step④
C4
D11
C5
Table des matières
Autres manuels Outback Gril
Outback
Outback Meteor MT-H4461-3 Manuel utilisateur
Outback
Outback Omega 100 Manuel utilisateur
Outback
Outback Hunter THG3302PD Manuel utilisateur
Outback
Outback Saracen Manuel utilisateur
Outback
Outback THG3302PC Manuel utilisateur
Outback
Outback THG3710SS-3 Manuel utilisateur
Outback
Outback Omega 100 Manuel utilisateur
Outback
Outback Spectrum 2 Burner Manuel utilisateur
Outback
Outback Jupiter 4S Manuel utilisateur
Outback
Outback Omega 200 Manuel utilisateur
Outback
Outback OUT371036 Manuel utilisateur
Outback
Outback Cook Dome 571 Manuel utilisateur
Outback
Outback Omega 100 Manuel utilisateur
Outback
Outback Modern Classic Trooper Manuel utilisateur
Outback
Outback Ranger 3 Manuel utilisateur
Outback
Outback Party Select 6 Burner Gas BBQ FS5680 Manuel utilisateur
Outback
Outback Meteor MT-H4430-3 Manuel utilisateur
Outback
Outback Phoenix 4 Burner Black Manuel utilisateur
Outback
Outback Excelsior 3 Manuel utilisateur
Outback
Outback THG2710 Manuel utilisateur
