SMC Networks SMC7901BRA5 Manuel utilisateur

USER GUIDE

ADSL2 BARRICADE™

1-Port ADSL/ADSL2+ Router

SMC7901BRA5

No. 1, Creation Road III,

Hsinchu Science Park,

30077, Taiwan, R.O.C.

TEL: +886 3 5770270

Fax: +886 3 5780764

1-Port ADSL/ADSL2+ Router

User Guide

September 2011

Pub. # 149xxxxxxxxx

SMC-UG-0911-01

Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable.

However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or

other rights of third parties which may result from its use. No license is granted by implication or

otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications

at any time without notice.

SMC Networks, Inc.

No. 1 Creation Road III,

Hsinchu Science Park,

30077, Taiwan, R.O.C.

Trademarks:

SMC is a registered trademark; and Barricade, EZ Switch, TigerStack, TigerSwitch, and TigerAccess

are trademarks of SMC Networks, Inc. Other product and company names are trademarks or

registered trademarks of their respective holders.

– 4 –

WARRANTY AND PRODUCT REGISTRATION

To register SMC products and to review the detailed warranty statement,

please refer to the Support Section of the SMC Website at http://

www.smc.com.

– 5 –

COMPLIANCES

FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the following

measures:

◆Reorient or relocate the receiving antenna

◆Increase the separation between the equipment and receiver

◆Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected

◆Consult the dealer or an experienced radio/TV technician for help

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate

this equipment.

FCC - PART 68

This equipment complies with Part 68 of the FCC rules and the

requirements adopted by the ACTA. On the bottom of this equipment is a

label that contains, among other information, a product identifier in the

format US: 1KRDL09BSMC7800A. If requested, this number must be

provided to the telephone company.

This equipment uses the following USOC jacks: RJ-11.

The REN is useful to determine the quantity of devices you may connect to

your telephone line and still have those entire devices ring when your

telephone number is called. In most, but not all areas, the sum of the REN

OMPLIANCES

– 6 –

of all devices connected to one line should not exceed five (5.0). To be

certain of the number of devices you may connect to you line, as

determined by the REN, you should contact your local telephone company

to determine the maximum REN for your calling area.

If your equipment causes harm to the telephone network, the telephone

company may discontinue your service temporarily. If possible, they will

notify you in advance. But if advance notice is not practical, you will be

notified as soon as possible. You will be informed of your right to file a

complaint with the FCC. Your telephone company may make changes in its

facilities, equipment, operations or procedures that could affect the proper

functioning of your equipment. If they do, you will be notified in advance to

give you an opportunity to maintain uninterrupted telephone service.

If you experience trouble with this telephone equipment, please contact

please contact our company at the numbers shown on back of this manual

for information on obtaining service or repairs. The telephone company

may ask that you disconnect this equipment from the network until the

problem has been corrected or until you are sure that the equipment is not

malfunctioning.

This equipment may not be used on coin service provided by the telephone

company. Connection to party lines is subject to state tariffs.

REN (RINGER EQUIVALENT NUMBERS) STATEMENT

Notice: The Ringer Equivalence Number (REN) assigned to each terminal

device provides an indication of the maximum number of terminals allowed

to be connected to a telephone interface. The termination on an interface

may consist of any combination of devices subject only to the requirement

that the sum of the Ringer Equivalence Numbers of all the devices does not

exceed 5.

ATTACHMENT LIMITATIONS STATEMENT

Notice: This equipment meets telecommunications network protective,

operational and safety requirements as prescribed in the appropriate

Terminal Equipment Technical Requirements document(s). This is

confirmed by marking the equipment with the Industry Canada certification

number. The Department does not guarantee the equipment will operate to

the user's satisfaction.

Before installing this equipment, users should ensure that it is permissible

to be connected to the facilities of the local telecommunications company.

The equipment must also be installed using an acceptable method of

connection. The customer should be aware that compliance with the above

conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative

designated by the supplier. Any repairs or alterations made by the user to

this equipment, or equipment malfunctions, may give the

telecommunications company cause to request the user to disconnect the

equipment.

Users should ensure for their own protection that the electrical ground

connections of the power utility, telephone lines and internal metallic water

OMPLIANCES

– 7 –

pipe system, if present, are connected together. This precaution may be

particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves,

but should contact the appropriate electric inspection authority, or

electrician, as appropriate.

CE MARK DECLARATION OF CONFORMANCE FOR EMI AND SAFETY (EEC)

SMC contact for these products in Europe is:

SMC Networks Europe,

C/Fructuós Gelabert 6-8, 2o, 2a,

Edificio Conata II,

08970 - Sant Joan Despí, Barcelona, Spain.

This information technology equipment complies with the requirements of

the Council Directive 2004/108/EC on the Approximation of the laws of the

Member States relating to Electromagnetic Compatibility and 2006/95/EC

for electrical equipment used within certain voltage limits and the

Amendment Directive 93/68/EEC. For the evaluation of the compliance

with these Directives, the following standards were applied:

RFI Emission: ◆Limit according to EN 55022:2007, Class A/B

◆Limit for harmonic current emission according to

EN 61000-3-2:2006, Class A

◆Limitation of voltage fluctuation and flicker in low-

voltage supply system according to EN 61000-3-

3:2005

Immunity: ◆Product family standard according to EN 55024:2001

+ A2:2003

◆Electrostatic Discharge according to IEC 61000-4-

2:2008

◆Radio-frequency electromagnetic field according to

IEC 61000-4-3:2007

◆Electrical fast transient/burst according to IEC 61000-

4-4:2004

◆Surge immunity test according to IEC 61000-4-

5:2005

◆Immunity to conducted disturbances, Induced by

radio-frequency fields: IEC 61000-4-6:2008

◆Power frequency magnetic field immunity test

according to IEC 61000-4-8:2001

LVD: ◆Voltage dips, short interruptions and voltage

variations immunity test according to IEC 61000-4-

11:2004

◆EN60950-1 :2006+A11 :2009

OMPLIANCES

– 8 –

ENVIRONMENTAL STATEMENT

The manufacturer of this product endeavours to sustain an

environmentally-friendly policy throughout the entire production process.

This is achieved though the following means:

◆Adherence to national legislation and regulations on environmental

production standards.

◆Conservation of operational resources.

◆Waste reduction and safe disposal of all harmful un-recyclable by-

products.

◆Recycling of all reusable waste content.

◆Design of products to maximize recyclables at the end of the product’s

life span.

◆Continual monitoring of safety standards.

END OF PRODUCT LIFE SPAN

This product is manufactured in such a way as to allow for the recovery and

disposal of all included electrical components once the product has reached

the end of its life.

MANUFACTURING MATERIALS

There are no hazardous nor ozone-depleting materials in this product.

DOCUMENTATION

All printed documentation for this product uses biodegradable paper that

originates from sustained and managed forests. The inks used in the

printing process are non-toxic.

– 9 –

ABOUT THIS GUIDE

PURPOSE This guide gives specific information on how to install the ADSL Gateway

Router and its physical and performance related characteristics. It also

gives information on how to operate and use the management functions of

the ADSL Gateway Router.

AUDIENCE This guide is for users with a basic working knowledge of computers. You

should be familiar with Windows operating system concepts.

CONVENTIONS The following conventions are used throughout this guide to show

information:

OTE

Emphasizes important information or calls your attention to related

features or instructions.

AUTION

Alerts you to a potential hazard that could cause loss of data, or

damage the system or equipment.

ARNING

Alerts you to a potential hazard that could cause personal injury.

REVISION HISTORY This section summarizes the changes in each revision of this guide.

SEPTEMBER 2011 REVISION

This is the first revision of this guide.

– 13 –

CONTENTS

WARRANTY AND PRODUCT REGISTRATION 4

COMPLIANCES 5

ABOUT THIS GUIDE 9

FIGURES 10

CONTENTS 13

TABLES 17

SECTION I GETTING STARTED 18

1INTRODUCTION 19

Features and Benefits 19

Description of Hardware 20

Power Connector 22

Power Button 22

Reset Button 22

2INSTALLING THE ROUTER 23

Package Contents 23

System Requirements 23

Cable Connections 24

Powering On 25

Configuring the TCP/IP Protocols 25

SECTION II WEB CONFIGURATION 28

3SYSTEM CONFIGURATION 29

Using the Web Interface 29

Home Page 30

Setup Wizard 33

Table des matières

Autres manuels SMC Networks Routeur réseau

SMC Networks

SMC Networks SMCFS1601 - FICHE TECHNIQUE Instructions d'utilisation et de sécurité

SMC Networks

SMC Networks 7904BRB3 FICHE Instructions d'utilisation et de sécurité

SMC Networks

SMC Networks TigerAccess SMC7824M/VSW Guide d'installation

SMC Networks

SMC Networks 24/16 Manuel utilisateur

SMC Networks

SMC Networks SMC-EZ1026DT Manuel utilisateur

SMC Networks

SMC Networks SMC Barricade Plus SMC7004WFW Manuel utilisateur

SMC Networks

SMC Networks 7204BRB Manuel utilisateur

SMC Networks

SMC Networks EZ Switch SMC-EZ1024DT Manuel utilisateur

SMC Networks

SMC Networks BR21VPN - annexe 1 Manuel utilisateur

SMC Networks

SMC Networks Barricade SMC7004ABR Manuel utilisateur

SMC Networks

SMC Networks Barricade SMC7908VoWBRA Manuel utilisateur

SMC Networks

SMC Networks FS1601 Manuel utilisateur

SMC Networks

SMC Networks SMC6824M Manuel de programmation

SMC Networks

SMC Networks 2304WBR-AG Manuel utilisateur

SMC Networks

SMC Networks BR14VPN - annexe 1 Manuel utilisateur

SMC Networks

SMC Networks 7904WBRA-N FICHE Guide d'installation

SMC Networks

SMC Networks FS5 - annexe 1 Manuel utilisateur

SMC Networks

SMC Networks FS26 Manuel utilisateur

SMC Networks

SMC Networks EZ Switch SMCGS1610 Manuel utilisateur

SMC Networks

SMC Networks 7401BRA V.2 Manuel utilisateur

SMC Networks

SMC Networks SMCWBR14-N5 Manuel utilisateur

SMC Networks

SMC Networks SMC6752AL2 Manuel utilisateur

SMC Networks

SMC Networks Barricade Cable/DSL Router Manuel utilisateur

SMC Networks

SMC Networks Barricade g SMC2804WBRP-G Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité