Siemens TMM-1 Manuel utilisateur

P/N 315-092099-6

Installation Instructions

Model TMM-1

Telephone Master Module

INTRODUCTION

The optional Model TMM-1 Telephone Master

Module from Siemens Industry, Inc. provides

firefighters with an emergency telephone

system for communications with remote loca-

tions. The TMM permits five telephones to be

off-hook at the same time with minimal loss of

quality in the sound. This module also has a

warden’s page feature that permits paging

through the speaker zones from the master

telephone as well as from remote locations.

(See Figure 1.)

The push-to-talk button on the TMM-1 Tele-

phone Master module connects the red master

telephone to the MXLV system through the

telephone riser. It also provides the signal for

the warden’s page. The warden’s page is

controlled by the ACM-1 and selected by a

VSM-1 module. For more information about the

MXLV system, refer to the MXL/MXLV Manual,

P/N 315-092036.

INSTALLATION

(Refer to Figure 2)

To mount the TMM-1 module:

1. Mount the TMM-1 on the MKB-2 panel to

the right side of the keyboard/annunciator

display (as viewed from the front).

2. Remove the black filler plate on the right

side of the keyboard/annunciator display

and discard.

3. From the front of the panel, insert the TMM-1

studs through the holes in the MKB-2 panel,

and from the rear of the panel secure the

studs with the three No. 8 nuts supplied.

4. Mount the electronics assembly to the rear of

the TMM-1 housing by placing it over the four

snap studs on the side of the rear. Be sure

that the 14 pin connector (P3) is at the bottom

of the assembly. Then press down on the

board to seat it firmly. (Refer to Figure 3.)

Figure 1

TMM-1 Module

Siemens Industry, Inc.

Building Technologies Division

Florham Park, NJ

Siemens Building Technologies, Ltd.

Fire Safety & Security Products

2 Kenview Boulevard

Brampton, Ontario

L6T 5E4 Canada

INSTALLING THE TMM-1

(Refer to Figure 2)

Install the cables from the module to the

paired connectors as follows:

1. Connect the two wire cable from the hole at

the rear of the telephone housing to P2 on the

left of the PC board mounted on the TMM.

2. Connect the four wire cable provided (P/N

600-180364) between P1 at the top of the

TMM-1 PC board and P5 on the TBM-1, which

is located on the right in the system backbox.

3. Connect the 14 position ribbon cable provided

(P/N 555-192236) between P3 on the TMM-1

and P1 on the adjacent ACM-1 module.

ELECTRICAL RATINGS

Figure 2

Mounting the TMM-1 Module

P/N 315-092099-6

Figure 3

Installing the TMM-1 Module

tnerruCeludoMCDV5evitcAAm0

tnerruCeludoMCDV42evitcAAm14

tnerruCeludoMCDV42ybdnatSAm02

Autres manuels Siemens Unité de contrôle

Siemens

Siemens SINAMICS S Series Manuel utilisateur

Siemens

Siemens SINUMERIK 840D sl Manuel utilisateur

Siemens

Siemens Simatic S7-1500 Manuel utilisateur

Siemens

Siemens SINAMICS S120 Document technique

Siemens

Siemens TC45 Manuel utilisateur

Siemens

Siemens SIMATIC CPU 1515SP PC2 F Manuel utilisateur

Siemens

Siemens SIMATIC IM 153-2 Manuel utilisateur

Siemens

Siemens SIMATIC S7 3964 Manuel d'instructions

Siemens

Siemens Cerberus Pyrotronics NIM-1M Manuel utilisateur

Siemens

Siemens SINUMERIK 840D sl Manuel de la liste des pièces

Siemens

Siemens SINUMERIK 840D sl Manuel du propriétaire

Siemens

Siemens SIMOTION D4 Series Manuel utilisateur

Siemens

Siemens XC10 Series Mode d’emploi

Siemens

Siemens SENTRON ATC6500 Manuel utilisateur

Siemens

Siemens FT2018-U1 Manuel utilisateur

Siemens

Siemens OCM-16 Manuel utilisateur

Siemens

Siemens SIRIUS 3TK2834 Manuel utilisateur

Siemens

Siemens SIMATIC S5 Manuel utilisateur

Siemens

Siemens QAW910 Manuel utilisateur

Siemens

Siemens RMB795B Manuel de l'opérateur

Siemens

Siemens SINUMERIK 808D Manuel utilisateur

Siemens

Siemens LAL1.25 Manuel utilisateur

Siemens

Siemens Simatic S7-1500/ET 200MP Manuel utilisateur

Siemens

Siemens FDCI223 Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur