Pickering 4x-727A Manuel utilisateur

pickeringtest.com

Issue 1.1 July 2022

4x-727A/728A/729A User Manual

PXI/PXIe Expandable RF Matrix Module

Page (II) PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

Page (II) REED RELAY MODULE 40-110/115/120/125

pickering

No part of this publication may be reproduced, transmitted, transcribed, translated or stored in any form, or by

any means without the written permission of Pickering Interfaces.

Technical details contained within this publication are subject to change without notice.

ISO 9001

Reg No. FM38792

Page (III)

PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

Page (III)

REED RELAY MODULE 40-110/115/120/125

pickering

TECHNICAL SUPPORT

For Technical Support please contact Pickering Interfaces either by phone, the website or via e-mail.

WARRANTY

All products manufactured by Pickering Interfaces are warranted against defective materials and workmanship for a period of

three years, excluding programmable power supplies, from the date of delivery to the original purchaser. Any product found to be

defective within this period will, at the discretion of Pickering Interfaces be repaired or replaced.

Products serviced and repaired outside of the warranty period are warranted for ninety days.

Extended warranty and service are available. Please contact Pickering Interfaces by phone, the website or via e-mail.

ENVIRONMENTAL POLICY

Pickering Interfaces operates under an environmental management system similar to ISO 14001.

Pickering Interfaces strives to full all relevant environmental laws and regulations and reduce wastes and releases to the

environment. Pickering Interfaces aims to design and operate products in a way that protects the environment and the health and

safety of its employees, customers and the public. Pickering Interfaces endeavours to develop and manufacture products that can

be produced, distributed, used and recycled, or disposed of, in a safe and environmentally friendly manner.

Worldwide Technical Support and Product Information

pickeringtest.com

Germany

Tel: +49 89 125 953 160

E-mail: [email protected]

Sweden

Tel: +46 340-69 06 69

E-mail: [email protected]

USA

Tel: (West) +1 541 471 0700

Tel: (East) +1 781 897 1710

E-mail: [email protected]

Czech Republic

Tel: +420 558 987 613

E-mail: [email protected]

France

Tel +33 9 72 58 77 00

E-mail [email protected]

Pickering Interfaces Headquarters

Stephenson Road Clacton-on-Sea CO15 4NL United Kingdom

Tel: +44 (0)1255-687900

E-Mail: [email protected]

China

Tel: +86 4008 799 765

E-mail: [email protected]

Page (IV) PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

Page (IV) REED RELAY MODULE 40-110/115/120/125

pickering

MEANING / DESCRIPTION SYMBOL

PROTECTIVE EARTH (GROUND)

To identify any terminal which is intended for connection to an external conductor for

protection against electric shock in case of a fault, or the terminal of a protective earth

(ground) electrode.

DANGEROUS VOLTAGE

To indicate hazards arising from dangerous voltages.

WARNING / CAUTION

An appropriate safety instruction should be followed or caution to a potential hazard

exists.

Refer to the relevant instructions detailed within the product manual.

HEAVY

If this product is heavy reference should be made to the safety instructions for

provisions of lifting and moving.

STATIC SENSITIVE

To indicate that static sensitive devices are present and handling precautions should

be followed.

SAFETY SYMBOLS

PRODUCT SAFETY

The following safety symbols may be used on the product and throughout the product documentation.

Page (V)

PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

Technical Support and Warranty................................................III

Product Safety .............................................................................IV

Contents (this page)....................................................................V

Warnings and Cautions ..............................................................VII

Section 1

Technical Specication...............................................................1.1

Section 2

Technical Description .................................................................2.1

Functional Description..........................................................2.1

Section 3

Installation....................................................................................3.1

Pre Operation Checks...........................................................3.1

Hardware Installation ............................................................3.2

Software Installation .............................................................3.2

Testing Operation ..................................................................3.3

Section 4

Programming Guide....................................................................4.1

Programming Options For Pickering PXI/PXIe Modules ...4.1

Matrix Module Architecture ..................................................4.2

Programming The Matrix Module.........................................4.4

Using Pickering Drivers in LabVIEW ...................................4.8

Section 5

Connector Information................................................................5.1

Section 6

Trouble Shooting .........................................................................6.1

Section 7

Maintenance Information............................................................7.1

Switching System Test Tools ...............................................7.1

Relay Lookup Tables.............................................................7.1

CONTENTS

Page (VI) PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

THIS PAGE INTENTIONALLY BLANK

Page (VII)

PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

Page (VII)

REED RELAY MODULE 40-110/115/120/125

pickering

WARNINGS AND CAUTIONS

WARNING - HAZARDOUS ENVIRONMENTS SYMBOL

atmospheres. If the product is to be used in hazardous environments we recommend that the user

ensures suitable protective measures are taken.

WARNING - DANGER OF ELECTRIC SHOCK SYMBOL

This module may contain hazardous voltages. Before removing the module from the rack remove all

supplies and disconnect user I/O signals.

Unused slots in the host chassis are populated with blanking plates to prevent access to user

I/O signals that may be present. Blanking panels are available to order from Pickering in a variety

of slot widths. If the product is not used in this manner for example by using an extender card then

additional care must be taken to avoid contact with exposed signals.

CAUTION - HANDLING OF ELECTROSTATIC-SENSITIVE DEVICES SYMBOL

Certain semiconductor devices used in this equipment are liable to damage due to static voltage.

Observe the following precautions when handling these devices in their unterminated state, or

sub-assemblies containing these devices:

1. Persons removing sub-assemblies from equipment using these devices must be earthed by a

wrist strap and a resistor at the point provided on the equipment.

2. Soldering irons used during the repair operations must be low voltage types with earthed tips and

isolated from the mains voltage by a double insulated transformer.

3. Outer clothing worn must be unable to generate static charges.

anti-static bags.

CAUTION - PRODUCT DOCUMENTATION SYMBOL

and understood before attempting to install or operate the product.

SAFETY INSTRUCTIONS

All cleaning and servicing requires the equipment to be isolated and disconnected from the power source and user I/O

signals (refer to the Maintenance Section).

• Appropriate manual handling procedures should be followed as dictated by the weight of the individual module or

the combined weight of the modules & chassis.

• Should a fault occur with the module or chassis, immediately isolate and disconnect the incoming power to the

chassis and the user I/O signals.

• Ensure the equipment is installed, operated and maintained by trained and authorised personnel.

• For suitably equipped products in the event of an emergency press the red “emergency stop” button situated on

the front of the unit.

Page (VIII) PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

THIS PAGE INTENTIONALLY BLANK

Page 1.1

PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering SECTION 1 - TECHNICAL SPECIFICATION

SECTION 1 - TECHNICAL SPECIFICATION

The 40-727A/728A/729A (PXI) and 42-727A/728A/729A

(PXIe) are high density RF matrix modules suitable for

switching up to 300 MHz in 50 Ω or 100 MHz in 75 Ω. They

are available in 50 Ω or 75 Ω versions with SMB connectors

or in 50 Ω versions with a multiway connector. They provide

a simple and scalable bidirectional matrix for RF signals

and are intended for the construction of high performance

switching systems. All X and Y connections have isolation

switches. These can be used to disconnect the matrix from

the test ﬁxture to maximize isolation and RF performance.

Updated Product

These modules are based on the established 40-727/8/9. As

well as having PXIe options, they use Pickering reed relays

throughout giving improved operation speed and reliability.

yAvailable as PXI or PXIe Modules

y16x4, 16x2 & 8x4 RF Coaxial Matrices

y300 MHz Usable Bandwidth (50 Ω)

y50 Ω & 75 Ω Versions Available

yEasy to Use Loop Thru Option Allows Unlimited

X Axis Expansion

yHigh Density SMB & Multiway Connector Versions

y75 Ω Version Suitable for Telecoms & Video Switching

yVISA & IVI Drivers Supplied for Windows

yPXI Versions Supported by PXI or LXI Chassis

ySelected Builds Supported by

eBIRST

™

y3 Year Warranty

Microwave Multiplexer (Part No. 4x-729A)

in 8x4 Format without Loop-thru

40-727A-002-L

RF Matrix Module

with MS-M

Multi-way Coaxial

Connector

Y4-LT

Y3-LT

Y2-LT

Y1-LT

Loop-Thru

Crosspoint

Isolation

Switches

Loop-Thru &

Isolation Switches

Crosspoint

Isolation

Switches

Microwave Multiplexer (Part No. 4x-729A)

in 8x4 Format with Loop-thru

pickeringtest.com

4x-727A/728A/729A

PXI/PXIe Expandable RF Matrix

Issue 1.1 July 2022

Page 1.2 PXI/PXIe Expandable RF Matrix Module 4x-727A/728A/729A

pickering

SECTION 1 - TECHNICAL SPECIFICATION

Matrix Operation

The 4x-727A/728A/729A are designed for X

to Y connections with maximum bandwidth.

They can also support X to X connections in

the same module or between multiple

modules (using loop-thru option) - see user

manual.

They are based on the same architecture

as the popular 40-725 RF matrix, but have

optional Y loop-thru allowing

easy expansion with minimum loss of

bandwidth.

X10

X11

X12

X13

X14

X15

X16

Crosspoint

Isolation

Switches

X10

X11

X12

X13

X14

X15

X16

Isolation

Switches

Crosspoint

X10

X11

X12

Y4-LT

Y3-LT

Y2-LT

Y1-LT

Loop-Thru

X13

X14

X15

X16

Isolation

Switches

Crosspoint

Loop-Thru &

Isolation Switches

X10

X11

X12

Y2-LT

Y1-LT

Loop-Thru

X13

X14

X15

X16

Crosspoint

Isolation

Switches

Loop-Thru &

Isolation Switches

40-727A-001-L

16x4 RF Matrix Module with

SMB Connectors and

Loop-thru on Flying Leads

Microwave Multiplexer (Part No. 4x-728A)

in 16x2 Format Without Loop-thru

Microwave Multiplexer (Part No. 4x-728A)

in 16x2 Format With Loop-thru

Microwave Multiplexer (Part No. 4x-729A)

in 16x4 Format Without Loop-thru

Microwave Multiplexer (Part No. 4x-729A)

in 16x4 Format With Loop-thru

4x-727A/728A/729A

pickeringtest.com Page 2

PXI/PXIe Expandable RF Matrix

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Pickering Unité de contrôle

Pickering

Pickering 40-880 Manuel utilisateur

Pickering

Pickering 40-534 Manuel utilisateur

Pickering

Pickering PXI 40-145 Manuel utilisateur

Pickering

Pickering 60-553 Manuel utilisateur

Pickering

Pickering 40-540 Manuel utilisateur

Pickering

Pickering PXI 40-795-001 Manuel utilisateur

Pickering

Pickering 40-559 Manuel utilisateur

Pickering

Pickering 40-500 Manuel utilisateur

Pickering

Pickering 40-574 Manuel utilisateur

Pickering

Pickering 40-296 Manuel utilisateur

Pickering

Pickering Pxi 41-750 Manuel utilisateur

Pickering

Pickering 41-761 Manuel utilisateur

Pickering

Pickering 40-884A Manuel utilisateur

Pickering

Pickering 40-870 Manuel utilisateur

Pickering

Pickering 45-541 Manuel utilisateur

Pickering

Pickering 40-545 Manuel utilisateur

Pickering

Pickering 45-542 Manuel utilisateur

Pickering

Pickering BRIC Series Manuel utilisateur

Pickering

Pickering PXI 30 A Manuel utilisateur

Pickering

Pickering PXI BRIC 40-595A Manuel utilisateur

Pickering

Pickering 40-527A Manuel utilisateur

Pickering

Pickering PXI BRIC 40-569B Manuel utilisateur

Pickering

Pickering Pxi 41-660 Manuel utilisateur

Pickering

Pickering Module Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur