Olympia electronics POWER LIGHT Series Manuel utilisateur

GENERAL o

These luminaires are used indoors (ta 40 C)

where emergency light is needed. Each

luminaire must be permanently connected to

mains power supply. In normal operation the

power indicator lights and the charge indicator

blinks to show that the batteries are in

charging condition. In case of a mains

power supply failure the power and the

charge indicators turns off and the luminaire

will light the spot lamps automatically in

emergency mode. When the mains power

supply is restored the device turns to normal

operation.

INSTALLATION

To install the luminaire follow the installation

instructions οn page 3.

OPERATION

When the device is powered from the mains,

thecharge indicator blinks and confirms the

charging of the batteries. When the batteries

are charged, it lights constantly. If it does not

light, probably, the batteries are disconnected.

If it does not light and the batteries are

connected, then contact the technician. As

long as the charge indicator blinks, the

batteries of the luminaire are charging and in

this period, any autonomy test must be

avoided. When the charging circle is

complete, the indicator lights continuously (it

can be used as an indication of a power

interruption). The batteries charging is done

by an 3 stages

technological advanced procedure, to ensure

the appropriate and full charging of the

batteries.

The power indicator confirms the proper

connection to the mains. The TEST button,

has a dual use. If pressed instantlly while the

device is connected to the mains, the device

simulates the power interruption, by lighting

the lamps for 3''. In this way,we can control

the driver circuit of the lamps and the lamps as

indicated in paragraph 3in the text below.

Dimming option

When the voltage is interrupted, with

corresponding pressings of the button, we can

choose the illumination of 100%, 50%, 33% or

turned off, either to increase the autonomy time

or not to consume the battery power

unnecessarily. This option is canceled when the

networkisrestored.

ΑΤΤΕΝΤΙΟΝ!!!

1. Operations for installation, maintainance or

testing must be done by authorized personel

only.

Page 1 from 3

GRL-22``POWER LIGHT`` SERIES NON-MAINTAINED EMERGENCY LUMINAIRE

923022100_09_006

Bayblend FR3010, transparent polycarbonate

TECHNICAL CHARACTERISTICS(for LED MODULE Specs. see page 2)

OPERATION TEMPERATURE RANGE

RELATIVE HUMIDITY

EXTERNAL DIMENSIONS

CONSTRUCTION MATERIALS

TYPICAL WEIGHT

GUARANTEE

OPERATION VOLTAGE

MAXIMUM POWER CONSUMPTION

BATTERY (Pb)

CHARGING TIME

INDICATIONS - CONTROLS

BATTERY PROTECTION

MINIMUM AUTONOMOUS DURATION

DEGREES OF COVER PROTECTION

PRODUCED IN ACCORDANCE WITH

EMERGENCY ILLUMINATION

LIGHT SOURCE

<24h

Power indicator, battery charge indicator, TEST button

From overcharge and deep discharge

IP42

5 to 40 C

Up to 95%

3 years (1 year for the battery)

White LEDs

EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3

302 x 103 x 230 mm

220-240V AC/50-60Hz

600 min

12V/7Ah

710lm

16VA

3400gr.

Thank you for your trust in our products

Olympia Electronics - European manufacturer

Page 2 from 2

2. The device must be connected to the

mains power supply thru a fuse dependent by

the total amount of the line’s power load.

3. It is sugested to check every month the

indication LED for battery charging, and by

pushing instantly the TEST button to check

the emergency cirquit and the lamps. If the

luminaire does not light

4. It is sugested to check every 6 months the

minimum autononous duration by

disconnecting the mains power supply. Count

the time that the lamps light and in case of

less time than the minimum autonomous

duration the batteries must be replaced. If the

measured time is considerably less than the

minimum autonomous duration

The replacement of the battery and

the light source must be done using parts of

the same type, by the manufacturer or by a

competent person.

contact the installer.

contact the

installer.

t i

in battery recycling

points. Do not incinerate.

Battery replacement.

It can be done only by a competent person

and after the mains interruption.

1. Follow the step 2 of the installation

procedure.

2. Disconnect the cables and remove the old

battery.

3. Connect the new battery with the same type

(step 3of the installation procedure) and place

it in the position of the old one.

4. Follow the step 5 of the installation

procedure and power the device..

In case of inactive use for a period greater

than 2 months, disconnect the battery by

pulling out the battery’s connector.

6. I s not allowed to discard batteries in to

common trash bins, they must be

discarded only

923022100_09_006

NOTE: LED= Light Emitting Diode

LABELING EXPLANATION:

X: Self contained

0: Non Maintained (*)

A: Including test device

G: Internally illuminated

600:10 hours duration

Note!! The installer should fill in, on the specification label,

the letter Gif the luminaire is used as a safety sign.

6X00 0AG

(*) Non Maintained operation: The luminaire lights its illumination source, only in power supply’s

failure.

Maintained operation: The luminaire lights its illumination source, when it is powered by the mains

power supply or not.

The light source contained in this luminaire shall only be replaced by the manufacturer, or his

agent, or a similar qualified person.

NOTE! The light source is non-user replaceable.

ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ LED

Olympia Electronics Α.Ε.

50 °C max. across the board

3011129

GRL-22

20.3-25.2V

5.46W

Manufacturer

Model Number

Voltage Range

Connections

Nominal Power

Temperature (tc) Cable connection between main pcb and led module

Page 3 from 3 923022100_09_006

INSTALLATION PROCEDURE (For wall mounting only)

1. Install the included mounting accessories to hook the device from the mounting holes (fig. 1).

2. Unfasten the 4 mounting screws to remove the front plastic cover (fig. 1).

3. Make sure that the battery’s cables are connected to the respective poles. Black cable to (-) pole

and red cable to (+) pole.

4. Install the included cable gland or the rubber o-ring. Pass thru the mains cable and stabilize it by

fastening the cable gland. Connect the wires to the terminal blocks Lfor live wire and Νfor

neutral.

5. Refit with care the front plastic cover, by fastening the 4 mounting screws (tightening torque

1Nm).

WARNING!!

After the installation has finished, charge the batteries for at least 24 hours so as to obtain

the rated autonomous duration.

Fig.1

Mounting holes

TEST

button

Charge

indicator Power

indicator

power

Test On-off

charge

Cover retaining screws

WARRANTY

Olympia Electronics guarantees the quality, condition and operation of the goods. The period of

warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,

which accompanies each product. This warranty ceases to exist if the buyer does not follow the

technical instructions included in official documents given by Olympia Electronics or if the buyer

modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia

Electronics has fully agreed to them in writing. Products that have been damaged can be returned to

the premises of our company for repair or replacement, as long as the warranty period is valid.

Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge

the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or

not the buyer the transportation cost.

HEAD OFFICE

72nd km. O.N.R. Thessaloniki-Katerini

P.C. 60300 P.O. Box 06 Εginio Pierias Greece

www.olympia-electronics.gr

[email protected]

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels olympia electronics Lanterne

olympia electronics

olympia electronics GRL-29 WP Manuel utilisateur

olympia electronics

olympia electronics WEATHER LIGHT Series Manuel utilisateur

olympia electronics

olympia electronics GR-490/WP/ADR Manuel utilisateur

olympia electronics

olympia electronics GR-220/DUO/M Manuel utilisateur

olympia electronics

olympia electronics BAU LIGHT Series Manuel utilisateur

olympia electronics

olympia electronics GR-290/M Manuel utilisateur

olympia electronics

olympia electronics GRL-37/90/ADR Manuel utilisateur

olympia electronics

olympia electronics GR-2110 Manuel utilisateur

olympia electronics

olympia electronics WEATHER LIGHT Series Manuel utilisateur

olympia electronics

olympia electronics OLY-1004 Manuel utilisateur

olympia electronics

olympia electronics Power Light Series Manuel de l'opérateur

olympia electronics

olympia electronics POWER LIGHT Series Manuel utilisateur

olympia electronics

olympia electronics GR-8/leds Manuel utilisateur

olympia electronics

olympia electronics BAU LIGHT Series Manuel utilisateur

olympia electronics

olympia electronics GR-270 Manuel utilisateur

olympia electronics

olympia electronics GR-8/leds Manuel utilisateur

olympia electronics

olympia electronics GR-108/12L/90 Manuel utilisateur

olympia electronics

olympia electronics GRL-38/90/M Manuel utilisateur

olympia electronics

olympia electronics GR-579/L/90/WP Manuel utilisateur

olympia electronics

olympia electronics GR-490/ADR Manuel utilisateur

olympia electronics

olympia electronics OLY-1004/WP/ADR Manuel utilisateur

olympia electronics

olympia electronics LLB-26/90 Manuel utilisateur

olympia electronics

olympia electronics OLY-500 Manuel utilisateur

olympia electronics

olympia electronics GR-290/WP/M Manuel utilisateur

Manuels Lanterne populaires d'autres marques

KYOWA

KYOWA KW-9114 Manuel utilisateur

Stahl

Stahl ECOLUX 6610 Series Manuel utilisateur

SNOWJOE

SNOWJOE SUNJOE 24V-LGT500-CT Manuel utilisateur

PRG

PRG VARI LITE VL5 Manuel utilisateur

Raytec

Raytec VARIO2 series Manuel utilisateur

ENSA

ENSA LEDBT18WS2 Manuel utilisateur

LUG

LUG OFFICE LB LED N/T Manuel utilisateur

GE Wallighter 250 Manuel utilisateur

Draper

Draper RLEDL19/B Manuel utilisateur

Green Lighting

Green Lighting TRI-SENSOR GL4612LU Manuel utilisateur

Panasonic

Panasonic EY3741B57 Manuel utilisateur

Clas Ohlson

Clas Ohlson LCC8T Manuel utilisateur

Coolon

Coolon WDN-140 Manuel utilisateur

Holiday Travel

Holiday Travel 834873 Manuel utilisateur

BEGA

BEGA 84 036 Manuel utilisateur

BEGA

BEGA 33 596 Manuel utilisateur

Dale Tiffany

Dale Tiffany GT701162 Manuel utilisateur

Wagan

Wagan Brite Nite Pop-Up USB Lantern Manuel utilisateur