MATSONIC MS9087C Manuel utilisateur

This publication, photographs, illustrations and software are under

the protection of international copyright laws and all rights

reserved. It does not allow any reproduction of this manual,

content and any materials contained herein without the written

consent of the authentic manufacturer.

The information in this manual is subject to change without notice.

The manufacturer does neither represent nor warrant the contents

hereof; and specifically disclaims any implied warranties of

merchantability or fitness for any particular purpose. Furthermore,

the manufacturer reserves the right to revise and change this

publication from time to time, without the obligation of notifying

any person of such revision or changes.

Trademarks

IBM, VGA, and PS/2 are registered trademarks of International

Business Machines.

Intel, Pentium/II/III, Pentium 4, Celeron and MMX are registered

trademarks of Intel Corporation.

Microsoft, MS-DOS and Windows 98/ME/NT/2000/XP are

registered trademarks of Microsoft Corporation.

PC-cillin is a trademark of Trend Micro Inc.

AMI is a trademark of American Megatrends Inc.

It has been acknowledged that other brands or product names in

this manual are trademarks or the properties of their respective

owners.

MS9087C Series, V1.0

I865PE/October 2003

Table of Contents

Trademark .............................................................................. I

Static Electricity Precautions.............................................III

Pre-Installation Inspection.................................................III

Chapter 1: Introduction...........................................................1

Key Features.......................................................................2

Package Contents................................................................5

Chapter 2: Mainboard Installation..........................................6

Mainboard Components.......................................................7

I/O Ports.............................................................................7

Installing the Processor........................................................8

Installing Memory Modules .................................................9

Jumper Settings .................................................................11

Install The Mainboard........................................................11

Connecting Optional Devices.............................................13

Install Other Devices.........................................................15

Expansion Slots ................................................................17

Chapter 3: BIOS Setup Utility...............................................18

Introduction ...................................................................... 18

Running the Setup Utility............…………………………...19

Standard CMOS Setup Page...............................................20

Advanced Setup Page........................................................21

Features Setup Page...........................................................22

Power Management Setup Page..........................................23

PCI/Plug and Play Setup Page............................................24

BIOS Security Features Setup Page....................................25

CPU PnP Setup Page .........................................................26

Hardware Monitor Page.....................................................27

Load Optimal Defaults.......................................................27

Save Changes and Exit ...................................................... 28

Discard Changes and Exit. ................................................28

Chapter 4:About the Software & CD-ROM ............................29

Utility Software Reference.................................................30

Hyper Threading CPU.......................................................31

III

Static Electricity Precautions

Static electricity could damage components on this mainboard.

Take the following precautions while unpacking this mainboard

and installing it in a system.

1. Don’t take this mainboard and components out of their original

static-proof package until you are ready to install them.

2. While installing, please wear a grounded wrist strap if possible.

If you don’t have a wrist strap, discharge static electricity by

touching the bare metal of the system chassis.

3. Carefully hold this mainboard by its edges. Do not touch those

components unless it is absolutely necessary. Put this

mainboard on the top of a static -protection package with

component side facing up while installing.

Pre-Installation Inspection

1. Inspect this mainboard whether there are any damages to

components and connectors on the board.

2. If you suspect this mainboard has been damaged, do not

connect power to the system. Contact your mainboard vendor

about those damages.

Notice:

Owing to Microsoft’s certifying schedule is various to every

supplier, we might have some drivers not certified yet by

Microsoft. Therefore, it might happen under Windows XP that a

dialogue box (shown as below) pop out warning you this

software has not passed Windows Logo testing to verify its

compatibility with Windows XP. Please rest assured that our RD

department has already tested and verified these drivers. Click

the “Continue Anyway” button and go ahead the installation.

Chapter 1

Introduction

This mainboard has a Socket-478 supporting Intel

Pentium 4/Hyper Threading Technology processorswith

Front-Side Bus (FSB) speeds up to 800MHz. Hyper Threading

Technology, designed to take advantage of the multitasking

features in Windows XP, gives you the power to do more things at

once.

This mainboard integrates the Intel 865PE Northbridge along with

Intel 82801EB I/O Controller Hub (ICH5) chipsets that supports

the Serial ATA —a new interface for high-performance and

mainstream desktop PCs; the built-in USB 2.0 providing higher

bandwidth, implementing Universal Serial Bus Specification

Revision 2.0 and is compliant with UHCI 1.1 and EHCI 0.95.

This mainboard supports AC 97 Audio Codec and provides Ultra

DMA 33/66/100 functionIt has one 8xAGP, one CNR

(Communications and Networking Riser) and five 32-bit PCI slots.

There is a full set of I/O ports including two PS/2 ports for mouse

and keyboard, one serial port, one parallel port and maximum eight

USB2.0 ports –four back-panel ports and onboard USB connectors

USB3/USB2 providing four extra ports by connecting the

Extended USB Module to the mainboard.

This mainboard is a Full ATX mainboard and has power

connectors for an ATX power supply.

Note: You must initiate the HT CPU function through

BIOS setup. It is strongly recommended you

refer to Page 31for relative details.

Key Features

This mainboard has these key features:

Socket-478 Processor

♦Supports Intel Pentium 4 series CPU with Hyper

Threading Technology

♦Supports up to 800 MHz Front-Side Bus

Hyper-Threading technology enables the operating

system into thinking it’s hooked up to two processors,

allowing two threads to be run in parallel, both on

separate ‘logical’ processors within the same physical

processor.

Chipset

There are Intel 865PE Northbridge and Intel 82801EB I/O

Controller Hub (ICH5) in the chipsets in accordance withan

innovative and scalable architecture with proven reliability and

performance. Here is a list of the chipset arrangement and their

respective features:

♦Supports either an integrated graphics device (IGD) or an

external graphics device on AGP. The AGP interface

supports 1X/4X/8X AGP data transfers and 4X/8X AGP

Fast Writes.

♦Supports 3GB of system memory and has a maximum

bandwidth of 6.4 GB/s using DDR400 in dual-channel

mode.

♦Integrates an Ultra ATA 100 controller, two Serial ATA

host controllers, one EHCI host controller, and four UHCI

host controllers supporting eight external USB 2.0 ports.

♦PCI Bus Interface: supports PCI Revision 2.3 Specification

♦Integrated LAN Controller: WfM 2.0 and IEEE802.3

Compliant

♦Integrated Serial ATA Host Controller: Independent DMA

operation and Data Transfer Rate up to 1.5 Gb/s (150

MB/s)

Memory Support

♦Three 184-pin DIMM sockets for DDR SDRAM memory

modules

♦Supports DDR400 memory bus

♦Maximum installed memory is 3GB

AC97 Audio Codec

♦6-CH hardware architecture allows multi-channelsouth

bridge to playback 6CH audio

♦IntelAC’97 (REV. 2.2) compatible, meeting Microsoft

PC2001 requirements

♦Built-in earphone buffer and internal PLL, the latter saving

additional crystal

♦Line-in/rear out share the same jack; Center/bass share the

MIC jack

♦CRL3D: HRTF based BS3D compatible audio engine

Expansion Options

The mainboard comes with the following expansion options:

♦Five 32-bit PCI slots

♦One 8x AGP slot

♦One Communications Network Riser (CNR) slot

Onboard IDE

♦Two IDE Connectors

♦Supports PIO (Programmable Input/Output) and DMA

(Direct Memory Access) modes

♦Supports IDE Ultra DMA bus mastering with transfer rates

of 33/66/100 MB/sec

Serial ATA

♦Two Serial ATA Connectors

♦Transfer rate exceeding best ATA (~150 MB/s) with

scalability to higher rates

♦Low pin count for both host and devices

Onboard I/O Ports

The mainboard has a full set of I/O ports and connectors:

♦Two PS/2 ports for mouse and keyboard

♦One serial port

♦One parallel port

♦Eight USB2.0 ports (four back-panel ports, onboard USB

connectorsUSB2/USB3 providing four extra ports

♦Audio jacks for microphone, line-in and line-out

Fast Ethernet LAN (optional)

♦10 Mb/s and 100 Mb/s operation

♦Integrated Fast Ethernet MAC, physical chip, and

transceiver onto a single chip

♦Supports 10Mb/s and 100Mb/s N-way auto-negotiation

♦Support ACPI power management

♦Full Duplex Flow Control (IEEE 802.3x) and Half/Full

duplex capability

USB 2.0

♦Compliant with Universal Serial Bus Specification

Revision 2.0

♦Compliant with Intel’s Enhanced Host Controller

Interface Specification Revision 0.95

♦Compliant with Universal Host Controller Interface

Specification Revision 1.1

♦PCI multi-function device consists of two UHCI Host

Controllercores for full-/low-speed signaling and one

EHCI Host Controllercore for high-speed signaling

♦Root hub consists 4 downstream facing ports with

integrated physical layer transceivers shared by UHCI and

EHCIHost Controller

♦Support PCI-Bus Power Management Interface

Specification release 1.1

♦Legacy support for all downstream facing ports

BIOS Firmware

This mainboard uses AMI BIOS that enables users to configure

many system features including the following:

♦Power management

♦Wake-up alarms

♦CPU parameters and memory timing

♦CPU and memory timing

The firmware can also be used to set parameters for different

processor clock speeds.

Bundled Software

♦PC-Cillin 2002 provides automatic virus protection under

Windows 98/ME/NT/2000/XP

♦Adobe Acrobat Reader V5.0 is the software to help users

read .PDF files.

Dime nsions

♦Full ATX form factor of 305 x 244 mm

Note: Hardware specifications and software items

are subject to change without notification.

Package Contents

Your mainboard package contains the following items:

qThe mainboard

qThe User’s Manual

qOne diskette drive ribbon cable (optional)

qOne IDE drive ribbon cable

qThe Software support CD

Optional Accessories

You can purchase the following optional accessories for this

mainboard.

qThe Extended USB module

qThe CNR v.90 56K Fax/Modem card

qThe Serial ATA cable (optional)

Note: You can purchase your own optional accessories from

the third party, but please contact your local vendor on

any issues of the specification and compatibility.

Chapter 2Mainboard Installation

To install this mainboard in a system, please follow these

instructions in this chapter:

qIdentify the mainboard components

qInstall a CPU

qInstall one or more system memory modules

qMake sure all jumpers and switches are set correctly

qInstall this mainboard in a system chassis (case)

qConnect any extension brackets or cables to connectors on the

mainboard

qInstall peripheral devices and make the appropriate

connections to connectors on the mainboard

Note:

1. Before installing this mainboard, make sure jumper JP1 is

under Normal setting. See this chapter for information about

locating JP1 and the setting options.

2. Never connect power to the system during installation;

otherwise, it may damage the mainboard.

Table des matières

Autres manuels MATSONIC Carte mère

MATSONIC

MATSONIC MS8318E Series Manuel utilisateur

MATSONIC

MATSONIC MS7057CT Manuel utilisateur

MATSONIC

MATSONIC MS7192SM Manuel utilisateur

MATSONIC

MATSONIC MS7117C Manuel utilisateur

MATSONIC

MATSONIC MS7188DSeries Manuel utilisateur

MATSONIC

MATSONIC MS9147C Series Manuel utilisateur

MATSONIC

MATSONIC MS-5120 Manuel utilisateur

MATSONIC

MATSONIC MS7308E Series Manuel utilisateur

MATSONIC

MATSONIC MS7191SM Manuel utilisateur

MATSONIC

MATSONIC MS8157E Manuel utilisateur

MATSONIC

MATSONIC MS6393E Manuel utilisateur

MATSONIC

MATSONIC MS7012D Manuel utilisateur

MATSONIC

MATSONIC MS9138E Series Manuel utilisateur

MATSONIC

MATSONIC MS6383E Manuel utilisateur

MATSONIC

MATSONIC MS7177C Manuel utilisateur

MATSONIC

MATSONIC MS7157C Manuel utilisateur

MATSONIC

MATSONIC MS9007C Manuel utilisateur

MATSONIC

MATSONIC MS9317E Series Manuel utilisateur

MATSONIC

MATSONIC MS7080SG Manuel utilisateur

MATSONIC

MATSONIC MS7057C Manuel utilisateur

MATSONIC

MATSONIC MS7101C Manuel utilisateur

MATSONIC

MATSONIC MS9077C Manuel utilisateur

MATSONIC

MATSONIC MS9017C Manuel utilisateur

MATSONIC

MATSONIC MS8137C Manuel utilisateur

Manuels Carte mère populaires d'autres marques

DFI

DFI SD170 Manuel utilisateur

ASROCK

ASROCK ROMED8-2T Manuel utilisateur

Asus

Asus P2L97A Manuel utilisateur

Winmate

Winmate IC70 Manuel utilisateur

Asus

Asus MES-B Manuel utilisateur

Grantech

Grantech SYS8F377VGGA-3OMN Manuel utilisateur

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuel utilisateur

Gigabyte

Gigabyte GA-9IVDT Manuel utilisateur

Texas Instruments

Texas Instruments ADS8372EVM Manuel utilisateur

Commell

Commell MS-C73 Manuel utilisateur

IBT Technologies

IBT Technologies MB860 Manuel utilisateur

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur

Biostar

Biostar M7VIT Bravo Instructions d'utilisation et d'installation

Intel

Intel D33217CK Manuel utilisateur

Asus

Asus F1A55-M LX PLUS R2.0 Manuel utilisateur

EPC

EPC EPC9147C Manuel utilisateur

Asus

Asus EX-B760M-V5 D4 Manuel utilisateur

EPOX

EPOX MU-8KHA0010 Manuel utilisateur