Marking on the devices
Danger of fire and short-circuit
•Do not operate the device with wet hands.
•Clean the equipment only in the way described in Maintaining Your Microphone
•Take care to avoid dropping the equipment. Make sure that the device is properly
fastened and reliably mounted. If the device has been dropped, have it inspected
by a skilled technician before you switch it on again.
•Should the equipment be damaged or defective, or if you notice a scorching
smell, remove the batteries immediately. DO not operate the device with a
damaged housing and do not repair the device yourself. Have the device only
repaired by a skilled service person.
•Always keep your device in good condition, as specified on these instructions for
use.
•Do not tamper with or alter the internal components of the microphone.
Danger of suffocation caused by small parts
•Keep the device out of the reach of children and pets.
Precautionary measure when using the batteries.
•Batteries/power packs, if inappropriately handled, can run out or explode.
•Please observe the following notes on safety when handling batteries to be used
in this device:
•Use only batteries mentioned in these operating instructions.
•Do not discard of the batteries in a fire and do not expose them to direct heat.
•To avoid damage to the product, you must make sure that you remove the
batteries, if you do not use the product over a long period of time, or if the
batteries have been discharged.
•If battery fluid meets skin or clothes, rinse it off immediately with fresh water.
Features:
•Broadcast recording quality microphone for clear, precise audio
•Super-cardioid polar pick-up pattern
•Lower Noise and Higher Sensitivity
•Two step High Pass Filter (flat, 80Hz)
•Three position level control (-10dB, 0, +20dB)
•1/4” Threaded Mount
•3.5 Output Plug
•Durable ABS Construction
