Troubleshooting
recorded
Make sure that two fresh AA batteries are installed and correctly
oriented in the battery compartment.
Make sure the power switch on the microphone is set to the ON
position and the LED indicator is on.
Make sure that 3.5mm mini plug is connected to the correct
AUDIO INPUT jack on the device to which you are recording.
distorted
Make sure the 3.5mm mini plug is fully plugged into the audio
input jack of your camera or recorder.
If your camera or device has an input control, decrease the mic
gain (audio input level) on your camera until the meter reads
slightly below peak level at the lowest point of the audio.
Reposition the BY-BM3030 further away from the sound source.
The recording
level is too low
If your camera or device has an input control, increase the mic
gain (audio input level) on your camera until the meter reads
slightly below peak level at the loudest point of the audio.
Reposition the BY-BM3030 closer to the sound source.
Make sure the microphone boost is switched off, move away
from the subject, consult camera owner´s manual for audio
recording settings.
stuck in the
camera’s shoe
Make sure the locking wheel is fully loosened.
Maintaining your microphone
•Keep your microphone away from dust, moisture, or water.
•To clean the housing, wipe with a dry micro-fibre cloth to remove dust.
•Store your microphone in the included pouch to protect it from dirt and dust.
Important safety information
•Make sure that you follow all safety notes.
•Keep these instructions for use in a safe place. If you sell the equipment or pass it
on someone else, you should also pass on these instructions for use.
