Billion BiPAC 5200 RC Manuel utilisateur

BiPAC 5200 RC

ADSL2+ Firewall Router

Quick Start Guide

Billion BiPAC 5200 RC ADSL2+ Firewall Router

Package Contents

BiPAC 5200 RC ADSL2+ Firewall Router

CD containing the on-line manual

RJ-11 ADSL/ telephone cable

Ethernet (CAT-5 LAN) cable

Power adapter

Quick Start Guide

Splitter/ Micro-filter (Optional)

Attention

Warning

PLEASE READ T

HE QUICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON THE

CD-ROM.



Do not use the

router

in high humidity or high temperatures.

Do not use the same power source for the router as other

equipment.

Do not open or repair the case yourself. If the router is too hot,

turn off the power immediately and have it repaired at a qualified

service center.



Avoid using this

product

and all

accessories

outdoors.



Place the router on a stable surface.

Only use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

Quick Start Guide

Hardware Overview

BiPAC 5200 RC

The Front LEDs

The Rear Ports

Connect to a

telephone network /

ADSL using the

provided RJ-11 cable.

Lit red when power is

ON. Lit green when

the system is ready.

Lit red when WAN port fails

to get IP address. Lit green

when WAN port gets IP

address successfully.

Lit Green when the

device is successfully

connected to an ADSL

DSLAM. (“Line sync”).

Connect to a home / office

network device (eg. PC) of

100Mbps or 10Mbps with

the supplied UTP Ethernet

cable (CAT-5).

Power ON /

OFF switch.

When the device power is on, press to reset

or to restore its factory default setting.

Press 1-3 seconds to reset the device. Press

6 seconds and above to restore the device

factory default setting. Caution: After

pressing the RESET button for more than 6

seconds, to be sure you power cycle the

device again.

nnect with

the supplied

power adapter.

Blink when data is being

Transmitted / Received. Lit

off when the connection

not present.

Billion BiPAC 5200 RC ADSL2+ Firewall Router

Hardware Connection

BiPAC 5200 RC

Hardware Installation

1. Power Connection

Plug the supplied power adapter into

the wall jack and the other side to the router.

Please note that the plug type may differ according to country.

2. LAN Connection

Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the

other side to the PC’s Ethernet interface.

Quick Start Guide

3. ADSL Connection

Connect the supplied RJ-11 phone cable to the router’s ADSL port, and the other

side to the phone jack on the wall.

4. Splitter/ Micro-filter Connection

Splitter / Micro-filters are important for ADSL installation, they help ensure that

high-frequency signals are directed to the ADSL modem, and low-frequency

signals are directed to the telephone or other analog voice-channel device to

prevent inter-modulation distortion and get good speeds and stable ADSL sync

rate.

a) Splitter connection

If the installation has only a single telephone and a single ADSL modem, then a

splitter can be employed.

b) Micro-filter connection

If the installation has several telephones or other analog devices, then an internal

micro-filter can be employed at each analog device.

Billion BiPAC 5200 RC ADSL2+ Firewall Router

Setup Utility

After you complete the hardware installation insert CD into the CD Drive to run the setup utility.

The setup utility will auto-run. Follow the step-by-step configuration wizard & it will guide you to

setting up the basic network configuration.

Connecting to the Router

1. Open the web browser and type http://192.168.1.254 in the browser's address box. This

number is the default IP address for this router. Press Enter.

2. A username and password window will appear. The default username is “admin”,

password is “admin”. Press OK to proceed.

3. You will get a status report web page and main menu screen.

Please see the relevant sections of user manual for detailed instructions on how to

configure your router.

Troubleshooting

1. None of the LEDs are on when you turn on the router.

Check the connection between the adapter and the router. If the error persists, you may have

a hardware problem. In this case you should contact technical support.

2. Can’t ping any PCs on the LAN.

Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC

connected. If it is off, check the cables between your router and the PC. Make sure you have

uninstalled any software firewall for troubleshooting. Verify that the IP address and the subnet

mask are consistent between the router and the workstations.

3. Frequent loss of ADSL linesync (disconnections).

Ensure that all other devices connected to the same telephone line as your router (e.g.

telephones, fax machines, analogue modems) have a line filter connected between them and

the wall socket (unless you are using a Central Splitter or Central Filter installed by a qualified

and licensed electrician), and ensure that all line filters are correctly installed and the right

way around. Missing line filters or line filters installed the wrong way around can cause

problems with your ADSL connection, including causing frequent disconnections. If you have

a back-to-base alarm system you should contact your security provider for a technician to

make any necessary changes.

Product Support and Contact Information

Most problems can be solved by referring to the Troubleshooting section in the User’s Manual.

If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer

where you purchased this product.

Contact Billion

WORLDWIDE

http://www.billion.com

Billion Product Registration

Billion is committed to before and after sales customer services. You will get the most out of your Billion's products

after registration. Please register online at http://www.billion.com/register to receive valuable services and support

from us.

BiPAC 5200 RC V100EN

Table des matières

Autres manuels Billion Routeur réseau

Billion

Billion BIPAC-5100W Manuel utilisateur

Billion

Billion BiPAC 7402VL Manuel utilisateur

Billion

Billion BiPAC 7402G Manuel utilisateur

Billion

Billion BEC MX-1000 Manuel utilisateur

Billion

Billion BiPAC 7700N Manuel utilisateur

Billion

Billion BiPAC 7820NZ Manuel utilisateur

Billion

Billion BiPAC 7404VOX Manuel utilisateur

Billion

Billion BiPAC 5200S Series Manuel utilisateur

Billion

Billion BiPAC 7300G RA Manuel utilisateur

Billion

Billion BiPAC 7560G Manuel utilisateur

Billion

Billion BiPAC 7300G RA Manuel utilisateur

Billion

Billion BiPAC 6404VGP R3 Manuel utilisateur

Billion

Billion BiPAC 711C2 Manuel utilisateur

Billion

Billion BiPAC 5210G RC Manuel utilisateur

Billion

Billion BiPAC 7402NX Manuel utilisateur

Billion

Billion BiPAC 7402(G)X(L) Series Manuel utilisateur

Billion

Billion BiPAC 7401VGP Manuel utilisateur

Billion

Billion BiPAC 6200NXL Manuel du propriétaire

Billion

Billion BiPAC 2072 Manuel utilisateur

Billion

Billion BiPAC 7100SG Manuel utilisateur

Billion

Billion BiPAC 8700NEXL R2 Manuel utilisateur

Billion

Billion BiPAC 8501 Manuel utilisateur

Billion

Billion BiPAC 7401V(G)PX Manuel utilisateur

Billion

Billion BiPAC 8700AX-1600 Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité

LevelOne

LevelOne FBR-1416 Manuel utilisateur