AWS AC-650 Manuel utilisateur

American Weigh Scales, Inc.

AC-650 (650x0.1g)

AC-100 (100x0.01g) User Manual

Digital Pocket Scale

AC-Series

Zero

g

AC-Series Manual

Thank you for purchasing the American Weigh AC-

Series digital pocket scale. Please read all operating

instructions carefully before use. Scales are precision

instruments and should always be handled with proper

care. To ensure years of reliable service, keep these

simple tips in mind:

• Do not exceed the scales maximum capacity.

Overloading your scale can permanently damage it!

• Avoid exposure to extreme heat or cold. Scales

perform best at normal room temperature. If

temperatures have changed dramatically, recalibration

may be necessary.

• Allow your scale to warm up for 30-60 seconds

before performing calibration (if available).

• Store your scale in a clean, dry location. Dust, dirt,

and moisture can accumulate on the weighing sensors

and electronics causing innacuracy or malfunction.

• Avoid using your scale in close proximity to strong

radio wave emitting devices such as computers, cash

registers, and cordless phones.

• Always weigh on a at and level surface, free from

vibrations and drafts. The corner of a room is usually

the most stable.

• Gently apply all items to be weighed. Do not drop

items onto the weighing platform.

• Avoid dropping your scale. The warranty does not

cover damage due to rough treatment or overload.

I. SCALE OPERATION

Place the scale on a horizontal at surface.

1. Press the [ ] key to turn the scale on.

2. Wait until “0.0” or “0.00” is displayed.

3. Place the object(s) on the weighing platform.

4. By pressing the [ M ] key, you can switch between

weighing units.

5. The removable covers can also be used as

weighing trays.

II. TARE WEIGHING

1. Turn on the scale as described above.

2. Place a tray or container on the scale platform.

3. Press the [ T ] button. “0.0” or “0.00” will be

displayed.

4. You can now add items to the container or tray to

obtain just the weight of the contents.

5. When the container is removed, a negative number

will be displayed. Press [ T ] again to zero the scale.

III. CALIBRATION

This scale has come pre-calibrated at the factory. Only

re-calibrate if you are experiencing trouble weighing.

AC-650 uses a 500g calibration weight

AC-100 uses a 100g calibration weight

1. Turn the scale OFF.

2. Press and hold the [ M ] and [ ] keys together

until the display shows a random number (ISN #).

3. Make sure nothing is on the platform and press the

[ ] key once.

4. The display will show “Zero” followed by the

required calibration weight.

5. Place the required weight (not included) on the

center of the platform and press the [ ] key again.

6. The display will show “CAL” then “PASS”.

Calibration is complete! You can turn off the scale.

IV. TROUBLESHOOTING

The primary reasons for inaccuracy or malfunction

are low batteries, incorrect calibration, overload or

operating on an unstable surface. Please keep this in

mind and maintain and operate your scale properly.

This scale is a precise instrument and must be

handled with the utmost care and caution.

[Display] Elimination of errors

[Lo] Change the batteries.

[OUE2] Recalibrate the scale as shown above.

[O_Ld] You are overloading the scale. Remove the

excessive load immediately!

[UnST] Use the scale in a more stable position

Model AC-650 AC-100

Capacity 650g / 22.93oz / 20.90ozt / 418.0dwt 100g / 3.528oz / 500ct / 1543gn

Resolution 0.01g /0.001oz / 0.05ct / 0.2gn 0.1g / 0.001oz/ 0.05ct / 0.2gn

Weighing Units g, oz, ozt dwt g, oz, ct, gn

Calibration Weight (not Included) 500g 100g

Platform Dimensions (inches) 2.2 x 2.9” Stainless Steel

Scale Dimensions (inches) 2.6 x 4.2 x 0.8”

Power 2 x AAA Batteries (included)

Warranty 10 Year Warranty

Specications

Ce manuel convient aux modèles suivants

1

Table des matières

Manuels Échelle populaires d'autres marques

Gima

Gima Glass Body Fat Analyzer Manuel de la liste des pièces

Seca

Seca 374 Manuel utilisateur

TEC

TEC TEC SL59 SERIES Manuel utilisateur

Axis

Axis B/E Series Manuel utilisateur

Alecto

Alecto ACW-40 Manuel utilisateur

Rice Lake

Rice Lake MSI-4260 IS Manuel utilisateur

IKA

IKA RCT basic safety control Manuel utilisateur

ADE

ADE M20011 Manuel utilisateur

Duronic

Duronic KS3000 Manuel utilisateur

Digi

Digi SM-720 Manuel utilisateur

Cardinal

Cardinal CS Series Manuel utilisateur

Korona

Korona Kastella Manuel utilisateur

A&D

A&D FC-50Ki Manuel utilisateur

BDA

BDA CAMARGUE Manuel utilisateur

Tanita

Tanita HD-357 Manuel utilisateur

Leifheit

Leifheit 03173 Manuel utilisateur

Lumme

Lumme LU-1340 Manuel utilisateur

Fidelity Electronics

Fidelity Electronics G2e Manuel utilisateur