Advantech POC-S155 Manuel utilisateur

POC-S155

Slim Point of Care Terminal with

15" TFT LCD

User Manual

POC-S155 User Manual ii

The documentation and the software included with this product are copy-

righted 2004 by Advantech Co., Ltd. All rights are reserved. Advantech

Co., Ltd. reserves the right to make improvements in the products

described in this manual at any time without notice. No part of this man-

ual may be reproduced, copied, translated or transmitted in any form or

by any means without the prior written permission of Advantech Co., Ltd.

Information provided in this manual is intended to be accurate and reli-

able. However, Advantech Co., Ltd. assumes no responsibility for its use,

nor for any infringements of the rights of third parties, which may result

from its use.

Acknowledgements

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows and MS-DOS are registered trademarks of

Microsoft Corp.

All other product names or trademarks are properties of their respective

owners.

Part No. 2006S15500 1st Edition

Printed in Taiwan February 2005

iii

Product Warranty (1 year)

Advantech warrants to you, the original purchaser, that each of its prod-

ucts will be free from defects in materials and workmanship for two years

from the date of purchase.

This warranty does not apply to any products which have been repaired or

altered by persons other than repair personnel authorized by Advantech,

or which have been subject to misuse, abuse, accident or improper instal-

lation. Advantech assumes no liability under the terms of this warranty as

a consequence of such events.

Because of Advantech’s high quality-control standards and rigorous test-

ing, most of our customers never need to use our repair service. If an

Advantech product is defective, it will be repaired or replaced at no

charge during the warranty period. For out-of-warranty repairs, you will

be billed according to the cost of replacement materials, service time and

freight. Please consult your dealer for more details.

If you think you have a defective product, follow these steps:

1. Collect all the information about the problem encountered. (For

example, CPU speed, Advantech products used, other hardware

and software used, etc.) Note anything abnormal and list any

onscreen messages you get when the problem occurs.

2. Call your dealer and describe the problem. Please have your man-

ual, product, and any helpful information readily available.

3. If your product is diagnosed as defective, obtain an RMA (return

merchandize authorization) number from your dealer. This allows

us to process your return more quickly.

4. Carefully pack the defective product, a fully-completed Repair and

Replacement Order Card and a photocopy proof of purchase date

(such as your sales receipt) in a shippable container. A product

returned without proof of the purchase date is not eligible for war-

ranty service.

5. Write the RMA number visibly on the outside of the package and

ship it prepaid to your dealer.

POC-S155 User Manual iv

1.1 FCC Class B

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harm-

ful interference when the equipment is operated in a residential environ-

ment. This equipment generates, uses and can radiate radio frequency

energy. If not installed and used in accordance with this user's manual, it

may cause harmful interference to radio communications.

Note that even when this equipment is installed and used in accordance

with this user's manual, there is still no guarantee that interference will

not occur. If this equipment is believed to be causing harmful interference

to radio or television reception, this can be determined by turning the

equipment on and off. If interference is occurring, the user is encouraged

to try to correct the interference by one or more of the following mea-

sures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment to a power outlet on a circuit different from that

to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Warning Any changes or modifications made to the equipment

which are not expressly approved by the relevant stan-

dards authority could void your authority to operate the

equipment.

Caution Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recom-

mended by the manufacturer. Dispose of used batteries

according to the manufacturer’s instructions.

1.2 Packing List

Before installing your Point of Care Terminal, ensure that the following

materials have been received:

• POC-S155 series Point of Care Terminal

• User's manual

• Accessories for POC-S155

• Y-shaped adapter for PS/2 mouse and keyboard

• Power cord (1.8 m) - USA type (UK, German types are available on

request)

• "Drivers and Utilities" CD-ROM disc

• Mounting kits and packet of screws

• External DC adapter (Manufacturer: SINPRO Model no.: MPU50-108

or Manufacturer: XPiQ Inc. Model no.: PCM80PS24)

1.3 Additional Information and Assistance

1. Visit the Advantech websites at www.advantech.com or

www.advantech.com.tw where you can find the latest information about

the product.

2. Contact your distributor, sales representative, or Advantech's customer

service center for technical support if you need additional assistance.

Please have the following information ready before you call:

• Product name and serial number

• Description of your peripheral attachments

• Description of your software (operating system, version, application

software, etc.)

• A complete description of the problem

• The exact wording of any error messages

Warning To prevent electric shock, Do not remove cover.

No user serviceable parts inside, refer servicing to qual-

ified personnel.

POC-S155 User Manual vi

• This equipment is a source of electromagnetic waves. Before use

please, make sure that there are not EMI sensitive devices in its sur-

rounding which may malfunction therefore.

1.4 Safety Instructions

1. Read these safety instructions carefully.

2. Keep this User's Manual for later reference.

3. Disconnect this equipment from any AC outlet before cleaning. Use a

damp cloth. Do not use liquid or spray detergents for cleaning.

Warning Only use the Power adapter

Manufacturer: SINPRO Model no.: MPU50-108

Input voltage: 100-240 VAC, 47-63 Hz, 1.35 A

Output voltage: +24 VDC, 2.08 A max.

Manufacturer: XPiQ Inc. Model no.: PCM80PS24

Input voltage: 100-240 VAC, 47-63 Hz, 1.1-0.45 A

Output voltage: +24 VDC, 3.33 A max.

2. Use a 3 V @ 195 mA lithium battery (Model No.

BR2032)

3. Packing: please carry the unit with both hands, handle

with care

4. Our European representative:

Advantech Europe GmbH

Kolberger Straße 7

D-40599 Düsseldorf, Germany

Tel: 49-211-97477350

Fax: 49-211-97477300

5. Maintenance: to properly maintain and clean the sur-

faces, use only approved products or clean with a dry

applicator

vii

4. For plug-in equipment, the power outlet socket must be located near

the equipment and must be easily accessible.

5. Keep this equipment away from humidity.

6. Put this equipment on a reliable surface during installation. Dropping it

or letting it fall may cause damage.

7. The openings on the enclosure are for air convection. Protect the equip-

ment from overheating. DO NOT COVER THE OPENINGS.

8. Make sure the voltage of the power source is correct before connecting

the equipment to the power outlet.

9. Position the power cord so that people cannot step on it. Do not place

anything over the power cord.

10. All cautions and warnings on the equipment should be noted.

11. If the equipment is not used for a long time, disconnect it from the

power source to avoid damage by transient overvoltage.

12. Never pour any liquid into an opening. This may cause fire or electri-

cal shock.

13. Never open the equipment. For safety reasons, the equipment should

be opened only by qualified service personnel.

14. If one of the following situations arises, get the equipment checked by

service personnel:

• a. The power cord or plug is damaged.

• b. Liquid has penetrated into the equipment.

• c. The equipment has been exposed to moisture.

• d. The equipment does not work well, or you cannot get it to work

according to the user's manual.

• e. The equipment has been dropped and damaged.

• f. The equipment has obvious signs of breakage.

15. DO NOT LEAVE THIS EQUIPMENT IN AN UNCONTROLLED

ENVIRONMENT WHERE THE STORAGE TEMPERATURE IS

BELOW -20° C (-4° F) OR ABOVE 60° C (140° F). THIS MAY DAM-

AGE THE EQUIPMENT.

16. If your computer is losing dramatic time or the BIOS configuration

reset to default, the battery has no power.

POC-S155 User Manual viii

17. IMPROPER INSTALLATION OF VESA MOUNTING CAN

RESULT IN SERIOUS PERSONAL INJURY! VESA mount installation

should be operated by professional technician, please contact the service

technician or your retail if you need this service.

18. CLASSIFICATION:

• Supply Class I adapter

• No applied part

• IPX0

• Continuous Operation

• Not AP or APG category

19. Disconnect device: Appliance inlet.

20. Follow the national requirement to dispose unit.

21. Maintenance: to properly maintain and clean the surfaces, use only

the approved products or clean with a dry applicator.

22. Contact information:

No.1, Alley 20, Lane 26, Reuiguang Road Neihu District, Taipei,

Taiwan 114, R.O.C.

TEL: (02)27927818

Caution 1. Do not replace battery yourself. Please contact a qual-

ified technician or your retail.

2 .The computer is provided with a battery-powered real-

time clock circuit. There is a danger of explosion if battery

is incorrectly replaced. Replace only with same or equiv-

alent type recommended by the manufacture. Discard

used batteries according to the manufacturer’s instruc-

tions

23.

24. This equipment shall not be used for life support system.

25. Accessory equipment connected to the analog and digital interfaces

must be in compliance with the respective nationally harmonized IEC

standards (i.e. IEC 60950 for data processing equipment, IEC 60065 for

video equipment, IEC 61010-1 for laboratory equipment, and IEC 60601-

1 for medical equipment.) Furthermore all configurations shall comply

with the system standard IEC 60601-1-1. Everybody who connects addi-

tional equipment to the signal input part or signal output part configures a

medical system, and is therefore, responsible that the system complies

with the requirements of the system standard IEC 60601-1-1. The unit is

for exclusive interconnection with IEC 60601-1 certified equipment in

the patient environment and IEC 60XXX certified equipment outside of

the patient environment. If in doubt, consult the technical services depart-

ment or your local representative.

26. User not to contact SIP/SOPs and the patient at the same time.

27. The sound pressure level at the operator's position according to IEC

704-1:1982 is no more than 70dB(A).

DISCLAIMER This set of instructions is given according to IEC

704-1. Advantech disclaims all responsibility for

the accuracy of any statements contained herein

POC-S155 User Manual x

Table des matières

Autres manuels Advantech Terminal tactile

Advantech

Advantech EP-55XX-AR10 Manuel utilisateur

Advantech

Advantech TREK-723 Manuel utilisateur

Advantech

Advantech WebOP-3000 Series Manuel utilisateur

Advantech

Advantech PIT-1701 Manuel utilisateur

Advantech

Advantech ADAM-3952/PMA Manuel utilisateur

Advantech

Advantech TPC-1240 Manuel utilisateur

Advantech

Advantech ADAM-3600-C2G Series Manuel utilisateur

Advantech

Advantech PPC-V106 Manuel utilisateur

Advantech

Advantech WP-5530-PD10 Manuel utilisateur

Advantech

Advantech UPOS-211 Manuel utilisateur

Advantech

Advantech TREK-725 Manuel utilisateur

Advantech

Advantech TREK-722 Manuel utilisateur

Advantech

Advantech MT-100 Manuel utilisateur

Advantech

Advantech ADAM-3968M/PMA Manuel d'installation et d'exploitation

Advantech

Advantech POC-S198 Manuel utilisateur

Advantech

Advantech TREK-773 Manuel utilisateur

Advantech

Advantech POC-WP21 Series Manuel utilisateur

Advantech

Advantech USC-360 Manuel d'installation et d'exploitation

Advantech

Advantech POC-176 Manuel utilisateur

Advantech

Advantech POC-S196 Manuel utilisateur

Advantech

Advantech POC-S199 Series Manuel utilisateur

Advantech

Advantech HIT-W101C Manuel d'instructions

Advantech

Advantech ProFlat IDP31-190-P35HIB1E Manuel utilisateur

Advantech

Advantech WP-75**-**10/40 Manuel utilisateur

Manuels Terminal tactile populaires d'autres marques

Wincor Nixdorf

Wincor Nixdorf iPOS plus Advanced Manuel utilisateur

Ingenico

Ingenico AXIUM EX4000 Manuel utilisateur

Heisei Electronics

Heisei Electronics Q-POS 815 Manuel utilisateur

Amano

Amano MTX-15 Manuel utilisateur

FLOWBIRD

FLOWBIRD CWT Compact Touch Manuel utilisateur

Demco

Demco SP7 Manuel utilisateur

Lathem

Lathem PC600 Series Manuel utilisateur

Partner

Partner MF-2352 Manuel utilisateur

NCR

NCR RealPOS 7460-2 Manuel

Simrad

Simrad MS50 Instructions de montage

Unitech

Unitech MR350 MKII Guide de démarrage rapide

Jungheinrich

Jungheinrich WMT 210 Manuel utilisateur

Motorola

Motorola MTP850 Manuel utilisateur

YASKAWA

YASKAWA 62H-MDC0 Manuel utilisateur

MVG industries

MVG industries NeptuLink Manuel utilisateur

Price Industries Limited

Price Industries Limited FDC Manuel d'instructions

Honeywell

Honeywell TemaKey Manuel utilisateur

EBN

EBN BPC65-B-A16G Manuel utilisateur