Advantech HIT-W18 Series Manuel utilisateur

User Manual

HIT-W18 Series

Healthcare Infotainment

Terminal

HIT-W18 User Manual ii

The documentation and the software included with this product are copyrighted 2011

by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right

to make improvements in the products described in this manual at any time without

notice. No part of this manual may be reproduced, copied, translated or transmitted

in any form or by any means without the prior written permission of Advantech Co.,

Ltd. Information provided in this manual is intended to be accurate and reliable. How-

ever, Advantech Co., Ltd. assumes no responsibility for its use, nor for any infringe-

ments of the rights of third parties, which may result from its use.

Acknowledgements

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows and MS-DOS are registered trademarks of Microsoft Corp.

All other product names or trademarks are properties of their respective owners.

Declaration of Conformity

FCC Class B

Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interfer-

ence to radio or television reception, which can be determined by turning the equip-

ment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Part No.2008W18100 Edition 1

Printed in Taiwan September 2011

Warning! Any changes or modifications made to the equipment which are not

expressly approved by the relevant standards authority could void your

authority to operate the equipment.

Caution! Danger of explosion if battery is incorrectly replaced. Replace only with

the same or equivalent type recommended by the manufacturer. Dis-

pose of used batteries according to the manufacturer's instructions.

iii HIT-W18 User Manual

Technical Support and Assistance

1. Visit the Advantech web site at www.advantech.com/support where you can find

the latest information about the product.

2. Contact your distributor, sales representative, or Advantech's customer service

center for technical support if you need additional assistance. Please have the

following information ready before you call:

–Product name and serial number

–Description of your peripheral attachments

–Description of your software (operating system, version, application software,

etc.)

–A complete description of the problem

–The exact wording of any error messages

Safety Instructions

1. Read these safety instructions carefully.

2. Keep this User Manual for later reference.

3. Disconnect this equipment from any AC outlet before cleaning. Use a damp

cloth. Do not use liquid or spray detergents for cleaning.

4. For plug-in equipment, the power outlet socket must be located near the equip-

ment and must be easily accessible.

5. Keep this equipment away from humidity.

6. Put this equipment on a reliable surface during installation. Dropping it or letting

it fall may cause damage.

7. The openings on the enclosure are for air convection. Protect the equipment

from overheating. DO NOT COVER THE OPENINGS.

8. Make sure the voltage of the power source is correct before connecting the

equipment to the power outlet.

9. Position the power cord so that people cannot step on it. Do not place anything

over the power cord.

10. All cautions and warnings on the equipment should be noted.

11. If the equipment is not used for a long time, disconnect it from the power source

to avoid damage by transient overvoltage.

12. Never pour any liquid into an opening. This may cause fire or electrical shock.

13. Never open the equipment. For safety reasons, the equipment should be

opened only by qualified service personnel.

14. If one of the following situations arises, get the equipment checked by service

personnel:

a. The power cord or plug is damaged.

b. Liquid has penetrated the equipment.

c. The equipment has been exposed to moisture.

d. The equipment does not work well, or you cannot get it to work according to

the user's manual.

e. The equipment has been dropped and damaged.

Warning! 1. Input voltage rated 18-19 VDC, 3 A (DC Mode).

2. Packing: please carry the unit with both hands, handle with care.

3. Maintenance: to properly maintain and clean the surfaces, use only

approved products or clean with a dry applicator.

HIT-W18 User Manual iv

f. The equipment has obvious signs of breakage.

15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE

STORAGE TEMPERATURE MAY GO BELOW -20° C (-4° F) OR ABOVE 60° C

(140° F). THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT

SHOULD BE IN A CONTROLLED ENVIRONMENT.

16. If your computer clock loses a significant amount of time or the BIOS configura-

tion resets to default, the battery has no power.

17. CLASSIFICATION:

–Supplied by Class I adapter

–No applied parts

–Continuous operation

–No AP or APG category

18. Follow national requirements to dispose of unit.

19. Maintenance: To properly maintain and clean the surfaces, use only approved

products or clean with a dry cloth.

20. Contact information:

No.1, Alley 20, Lane 26, Rueiguang Road Neihu District, Taipei, Taiwan 114,

R.O.C

TEL: (02) 2792-7818

21.

22. This equipment is not to be used as a life support system.

23. Accessory equipment connected to the analog and digital interfaces must be in

compliance with the respective nationally harmonized IEC standards (i.e. IEC

60950 for data processing equipment, IEC 60065 for video equipment, IEC

61010-1 for laboratory equipment, and IEC 60601-1 for medical equipment.)

Furthermore all configurations must comply with the system standard IEC

60601-1-1. Anyone who connects additional equipment to the signal input part

or signal output part is configuring a medical system, and is therefore, responsi-

ble that the system complies with the requirements of the system standard IEC

60601-1-1. The unit is for exclusive interconnection with IEC 60601-1 certified

equipment in the patient environment and IEC 60XXX certified equipment out-

Caution! 1. Do not replace power adaptor yourself. Please contact a qualified

technician or your retail.

2. The computer is provided with a battery-powered real-time clock

circuit. There is a danger of explosion if battery is incorrectly

replaced. Replace only with same or equivalent type recom-

mended by the manufacture. Discard used batteries according to

the manufacturer’s instructions

3. Cleaning: During normal use of the HIT-W151 may become soiled

and should, therefore, be cleaned regularly. Agents: Alcohol or

water.

4. End of Product: for Environmental protection, please follow

national requirements to dispose of unit.

v HIT-W18 User Manual

side of the patient environment. If in doubt, consult the technical services

department or your local representative.

24. A user must not allow SIP/SOPs and the patient to come into contact with one

another at the same time.

25. The sound pressure level at theoperator's position according to IEC 704-1:1982

is no more than 70dB (A).

DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech

disclaims all responsibility for the accuracy of any statements contained herein.

Explanation of Graphical Symbols

Caution! Use suitable mounting apparatus to avoid risk of injury.

Note! Attention, please thoroughly consult the accompanying documentation.

Note! Environmental protection

Follow national requirements to dispose of unit.

IEC 60878 and ISO 3864-B.3.6 : Warning: dangerous voltage.

ISO 7000-0434 : Attention, consult ACCOMPANYING DOCUMENTS.

ISO 7000-1641 : Follow operating instructions or Consult instructions for use.

IEC 60417 -5009 : SANDY-BY.

IEC 60417-5031 : Direct current.

HIT-W18 User Manual vi

Disposing of your old product

Within the European Union

EU-wide legislation, as implemented in each Member State,

requires that waste electrical and electronic products carrying the

mark (left) must be disposed of separately from normal household

waste. This includes monitors and electrical accessories, such as

signal cables or power cords. When you need to dispose of your

display products, please follow the guidance of your local authority,

or ask the shop where you purchased the product, or if applicable,

follow any agreements made between yourself. The mark on elec-

trical and electronic products only applies to the current European

Union Member States.

vii HIT-W18 User Manual

Contents

Chapter 1 Introduction..........................................1

1.1 Overview...................................................................................................2

1.2 System Configuration................................................................................4

Chapter 2 Hardware Description .........................5

2.1 General Specifications ..............................................................................6

2.1.1 Standard PC Functions.................................................................6

2.1.2 Flat Panel Interface.......................................................................6

2.1.3 Module Feature.............................................................................6

2.1.4 Power Environmental....................................................................7

2.2 Mechanical Specifications.........................................................................7

2.2.1 Mechanical Specifications (Terminal)...........................................7

2.2.2 Mechanical Specifications (Terminal with Handset) .....................8

2.2.3 Mechanical Drawing for Button and Rear I/O .............................10

2.3 External View..........................................................................................10

2.3.1 Front View...................................................................................10

2.3.2 Side View....................................................................................11

2.3.3 Rear View ...................................................................................12

Chapter 3 Software Description.........................13

3.1 Windows XP Embedded Software Specifications...................................14

Chapter 4 Design Requirements........................15

4.1 Environmental Specifications..................................................................16

4.2 Reliability.................................................................................................16

Chapter 5 Installation..........................................17

5.1 Terminal Installation................................................................................18

5.2 Handset Installation.................................................................................19

5.3 Remote Controller Installation.................................................................20

5.4 Arm Installation .......................................................................................21

Appendix A Annex..................................................23

A.1 Annex......................................................................................................24

HIT-W18 User Manual viii

Chapter 1

1Introduction

This chapter briefly introduces the

HIT-W18 Series product.

Sections include:

Overview

System Configuration

HIT-W18 User Manual 2

1.1 Overview

The HIT-W18 Series Patient Infotainment Terminal is a standard product from Advan-

tech with Windows XP Embedded OS built-in. In addition to providing hospital bed-

side patient information, remote monitoring, and care functions, the CPU and the

LAN-enabled architecture of the HIT-W18 Series terminal also serves as an inte-

grated hospital gateway device. The HIT-W18 Series equipped with an Intel Atom

processor, 18.5 W touchscreen, onboard Ethernet, and audio, plays a key role as a

hospital bedside care and monitoring solution. It connects the service calls and LED

light signals of a hospital room through the LAN to the hospital administration center

or nurse station.

Table des matières

Autres manuels Advantech Terminal tactile

Advantech

Advantech TPC-1240 Manuel utilisateur

Advantech

Advantech USC-360 Manuel d'installation et d'exploitation

Advantech

Advantech UPOS-3150 Manuel utilisateur

Advantech

Advantech WebOP-3000 Series Manuel utilisateur

Advantech

Advantech POC-WP21 Series Manuel utilisateur

Advantech

Advantech POC-S175 Manuel utilisateur

Advantech

Advantech MT-100 Manuel utilisateur

Advantech

Advantech ProFlat IDP31-190-P35HIB1E Manuel utilisateur

Advantech

Advantech UPOS-211 Manuel utilisateur

Advantech

Advantech POC-155 Manuel utilisateur

Advantech

Advantech POC-195 Manuel utilisateur

Advantech

Advantech UbiQ-480 Manuel utilisateur

Advantech

Advantech TREK-722 Manuel utilisateur

Advantech

Advantech TREK-723 Manuel utilisateur

Advantech

Advantech PPC-V106 Manuel utilisateur

Advantech

Advantech PPC-V106 Manuel utilisateur

Advantech

Advantech POC-W213L Series Manuel utilisateur

Advantech

Advantech POC-S196 Manuel utilisateur

Advantech

Advantech ADAM-3600-C2G Series Manuel utilisateur

Advantech

Advantech EP-55XX-AR10 Manuel utilisateur

Advantech

Advantech PIT-1701 Manuel utilisateur

Advantech

Advantech POC-S198 Manuel utilisateur

Advantech

Advantech ADAM-3968M/PMA Manuel d'installation et d'exploitation

Advantech

Advantech POC-W152 Manuel utilisateur

Manuels Terminal tactile populaires d'autres marques

Wincor Nixdorf

Wincor Nixdorf iPOS plus Advanced Manuel utilisateur

Ingenico

Ingenico AXIUM EX4000 Manuel utilisateur

Heisei Electronics

Heisei Electronics Q-POS 815 Manuel utilisateur

Amano

Amano MTX-15 Manuel utilisateur

FLOWBIRD

FLOWBIRD CWT Compact Touch Manuel utilisateur

Demco

Demco SP7 Manuel utilisateur

Lathem

Lathem PC600 Series Manuel utilisateur

Partner

Partner MF-2352 Manuel utilisateur

NCR

NCR RealPOS 7460-2 Manuel

Simrad

Simrad MS50 Instructions de montage

Unitech

Unitech MR350 MKII Guide de démarrage rapide

Jungheinrich

Jungheinrich WMT 210 Manuel utilisateur

Motorola

Motorola MTP850 Manuel utilisateur

YASKAWA

YASKAWA 62H-MDC0 Manuel utilisateur

MVG industries

MVG industries NeptuLink Manuel utilisateur

Price Industries Limited

Price Industries Limited FDC Manuel d'instructions

Honeywell

Honeywell TemaKey Manuel utilisateur

EBN

EBN BPC65-B-A16G Manuel utilisateur