Technoline WS 9132 Manuel utilisateur

EN1

WS9132 Manual

Environmental reception effects

The station obtains the accurate time with wireless technology. Same as all wireless

devices, the reception is maybe affected by the following circumstances:

long transmitting distance

nearby mountains and valleys

near freeway, railway, airports, high voltage cable etc.

near construction site

among tall buildings

inside concrete buildings

near electrical appliances (computers, TV’s, etc) and metallic structures

inside moving vehicles

Place the station at a location with optimal signal, i.e. close to a window and away from

metal surfaces or electrical appliances.

Precautions

This main unit is intended to be used only indoors.

Do not subject the unit to excessive force or shock.

Do not expose the unit to extreme temperatures, direct sunlight, dust or humidity.

Do not immerse in water.

Avoid contact with any corrosive materials.

Do not dispose this unit in a fire as it may explode.

Do not open the inner back case or tamper with any components of this unit.

EN2

Batteries safety warnings

Use only alkaline batteries, not rechargeable batteries.

Install batteries correctly by matching the polarities (+/-).

Always replace a complete set of batteries.

Never mix used and new batteries.

Remove exhausted batteries immediately.

Remove batteries when not in use.

Do not recharge and do not dispose of batteries in fire as the batteries may explode.

Ensure batteries are stored away from metal objects as contact may cause a short

circuit.

Avoid exposing batteries to extreme temperature or humidity or direct sunlight.

Keep all batteries out of reach from children. They are a choking hazard.

Use the product only for its intended purpose!

Consideration of duty according to the battery law

Old batteries do not belong to domestic waste because they could

cause damages of health and environment. You can return used

batteries free of charge to your dealer and collection points. As

end-user you are committed by law to bring back needed batteries to

distributors and other collecting points!

Consideration of duty according to the law of electrical devices

This symbol means that you must dispose of electrical devices

separated from the General household waste when it reaches the end of

its useful life. Take your unit to your local waste collection point or

recycling centre. This applies to all countries of the European Union,

and to other European countries with a separate waste collection system.

EN3

Hereby, Technotrade declares that this product WS 9132 is in compliance with the essential

requirements and other relevant provisions of Directive 2014/53/EU and ROHS 2011/65/EC.

The original EU declaration of conformity may be found at:

www.technoline.de/doc/4029665091327

Features:

DCF Radio controlled time function

12/24 hour format

Daily Alarm Function

Snooze function (OFF or 1~60min)

Low battery indicator

Maximum /minimum value record of temperature and humidity

Temperature in °C or °F

Outdoor thermometer ice alert

Humidity measurable range: 20%RH ~ 95%RH

Temperature:

—Indoor temperature measurement ranges: -9.9°C (14.2°F) ~ 50°C (122°F)

—Outdoor temperature measurement ranges: -25°C (-13°F) ~ 50°C (122°F)

Remote Sensor:

—Wall Mount or Table Stand

—3 Channels selectable

—433.92MHz RF transmitting frequency

—30 meter transmission range in an open area

Weather forecasting function

EN4

Power Supply:

Weather Station:

Battery: 2 x LR03 AAA

Remote Sensor:

Battery: 2 x LR06 AA

Weather Station Appearance

EN5

Part A –Weather station

A1: Time

A2: Indoor temperature and humidity

A3: Ice alert icon

A4: Radio Controlled Icon

A5: DST icon

A6: Weather forecast pattern

A7: Outdoor temperature

A8: Operation buttons

A9: Stand cover

A10: Battery door

Part B –Remote sensor

B1: Transmit indicate LED

B2: Battery door

B3: Channel switch

B4: Reset button

EN6

Initial operation:

Open the Weather Station battery compartment cover

Insert 2 x AAA batteries observing polarity [ “+” and “ –“ marks]

When you insert the batteries, all icons on the LCD display will light up for 3 seconds, you

will hear a beep tone and the station detects indoor temperature & humidity.

The Weather Station will now start to make a connection to the outdoor remote sensor.

This operation takes about 3 minutes and is displayed by a flashing reception RF

antenna symbol in the “OUTDOOR” display area on the receiver.

Open Wireless Outdoor Sensor battery compartment cover, Insert 2 x AA batteries

observing polarity [ “+” and “–“ marks].

After receiver has created a connection to the outdoor remote sensor, After 3 minutes it

will enter the Radio control time receive mode.

Reception of the DCF signal:

The clock will automatically search the DCF (radio controlled time) signal after 3 minutes

of any restart or changing of new fresh batteries. The radio mast icon starts to flash.

At 1:00 /2:00 / 3:00 am, the clock automatically carries out the synchronization procedure

with the DCF signal to correct any deviations to the exact time. If the synchronization

attempt is unsuccessful (the radio mast icon disappears from the display), the system will

automatically attempt another synchronization at the next full one hour. This procedure is

repeated automatically up to total 5 times.

To start manual DCF signal reception, press and hold the “ ”button for 3

seconds. If no signals received within 7 minutes, then the DCF signal search stops (the

radio mast icon disappears) and start again at the next full one hour.

EN7

During RC reception，to stop searching radio signal, press the “” button once.

Please note:

A flashing radio mast icon indicates that the DCF signal reception has started

A continuously displayed radio mast icon indicates that the DCF signal was received

successfully

We recommend a minimum distance of 2.5 meters to all sources of interference, such as

televisions or computer monitors

Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In

such extreme circumstances, place the system close to the window.

During the DCF reception mode, only the “ ” button has a function, other buttons

are not functional, If you want to carry out other functions of operation, please press

“ ” button to exit the DCF receiving mode.

Manual settings:

Press and hold the “ ”, 12/24HR start to flash. Now use “+” and “-” buttons to set

the set 12 or 24 hour mode.

Press the “ ”button to confirm your setting. The time zone start to flash. Now use

“+” and “-” buttons set a time zone (-12 to +12). For example for UK, the time zone is

-01, for Germany it is 00.

Press the “ ”button to confirm your setting, the Hour display starts to flash. Now

use “+” and “-”buttons to set the hour.

EN8

Press the “ ”button to confirm your setting, the Minute display starts to flash. Now

use “+” and “-”buttons to set the minute.

Press the “ ”button to confirm your setting, the temperature unit starts to flash.

Now use “+” and “-” buttons to choose between °C or °F temperature unit.

Press the “ ”button to confirm your setting, the barometric pressure unit starts to

flash, Now use “+” and “-”buttons to set the barometric pressure unit in mB/hPa or inHg.

Press the “ ”button to confirm your setting, the barometric pressure data starts to

flash. Now use “+” and “-”buttons to set the barometric pressure data according to the

local relative air pressure.

If not changed, the value corresponds to the absolute air pressure.

Press the “ ”button to confirm your setting, the weather forecast pattern starts to

flash. Now use “+” and “-”buttons to set the weather forecast pattern according to the

current weather..

Press the “ ”button to confirm your setting and to end the setting procedures, the

display will return to the normal mode.

Please note:

If there is no valid operation within 20 seconds, the station will automatically return to

normal time mode from the set mode.

Setting the alarm:

Press “ ” button once, LCD displays the “ ” icon, the alarm function is ON.

Then press “ ” button once, the “ ” icon will disappears from the display, the

alarm function is OFF.

Press once “ ” button, LCD display alarm time, then press and hold “ ”

button for 3 seconds until the hour of alarm time starts to flash. Use the “+” and “-”

EN9

buttons to set the hour.

Press “ ”button to confirm your setting. The minute of the alarm time starts to

flash. Use the “+” and “-” buttons to set the minute.

Press “ ”button to confirm your setting. The snooze time starts to flash. Use the

“+” and “-”buttons to set the snooze time. The snooze time can be set from OFF to 60

minutes.

Press “ ”button to confirm your setting and to end the setting procedure.

Please note:

If there is no valid operation within 20 seconds, the station will automatically return to

normal time mode from the alarm time set mode.

The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In

this case the alarm will be repeated automatically after 24 hours.

Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst

the alarm signal is heard.

Switching off the alarm signal

Press any button except the “SNOOZE/LIGHT” button to stop the alarm signal. It is not

necessary to reactivate the alarm. It switches itself automatically to the alarm time which

has already been set.

Snooze function

When the alarm is ringing, press the “SNZ” button the alarm mode to get to snooze mode.

The alarm signal sounds again after already been set. If OFF was selected in the

SNOOZE time setting, the alarm will not repeat.

EN10

RF Transmission Procedure:

The weather station automatically starts receiving transmission from outdoor thermo

sensor after batteries inserted.

The remote sensor will automatically transmit temperature signal to the Weather Station

after batteries inserted.

If the Weather Station failed to receive transmission from outdoor sensor (“- -.-”display on

the LCD), press and hold the “-/CH”button for 3 seconds to receive transmission

manually. RF icon “ ” flashes on the LCD of the Weather Station to receive the

remote sensor.

If the weather station is used with 2 or 3 transmitters, press “-/CH” button shortly to

display CH2, CH3 or cyclic display.

Press "+/C H "

Press "+/C H " Press "+/C H " Press "+/C H "

Autom atic Autom atic

Autom atic

5S 5S

Maximum/minimum temperature/humidity

Press “MEM” button once, the LCD will display maximum value of temperature/ humidity.

If the “MEM” button is pressed again the minimum value is displayed.

While displaying MAX or MIN values, there is “MAX” or “MIN” on the LCD.

Press „-/CH“ button

Press „-/CH“

Table des matières

Autres manuels Technoline Station météorologique

Technoline

Technoline DCF-77 Manuel utilisateur

Technoline

Technoline WS 9257 Manuel utilisateur

Technoline

Technoline WS 9765 Manuel utilisateur

Technoline

Technoline WS9132 Manuel utilisateur

Technoline

Technoline WS 6449 Manuel utilisateur

Technoline

Technoline WS9470 Manuel utilisateur

Technoline

Technoline WT 171 Manuel utilisateur

Technoline

Technoline WS 9060 Manuel utilisateur

Technoline

Technoline WS9050 Manuel utilisateur

Technoline

Technoline WS 6870 Manuel utilisateur

Technoline

Technoline WS 6832 Manuel utilisateur

Technoline

Technoline WS9252 Instructions d'installation

Technoline

Technoline WS 9170 Manuel utilisateur

Technoline

Technoline WS 9274 Manuel utilisateur

Technoline

Technoline WS6850 Manuel utilisateur

Technoline

Technoline WS 6449 Manuel utilisateur

Technoline

Technoline WS 6830 Manuel utilisateur

Technoline

Technoline WS 9040 Manuel utilisateur

Technoline

Technoline WS6446 Manuel utilisateur

Technoline

Technoline WS9620 Manuel utilisateur

Technoline

Technoline WS 9750 Manuel utilisateur

Technoline

Technoline WS 9130 Manuel utilisateur

Technoline

Technoline WS 8005 Manuel utilisateur

Technoline

Technoline WS9135 Manuel utilisateur

Manuels Station météorologique populaires d'autres marques

Auriol

Auriol AHFL 433 A1 Manuel utilisateur

NexSens

NexSens G2-HYDROMET Manuel utilisateur

Hyundai

Hyundai WS 2202 Manuel utilisateur

IROX

IROX HBVR761 UV-X Manuel utilisateur

La Crosse Technology

La Crosse Technology C86371 Manuel utilisateur

ADE

ADE WS 1711 Manuel utilisateur

Auriol

Auriol z29592 Manuel utilisateur

Auriol

Auriol 296289 Manuel utilisateur

Hyundai

Hyundai WS 2266 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-2210 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-811561 Manuel utilisateur

Ventus

Ventus W177 Manuel utilisateur

National Geographic

National Geographic VA Colour RC Manuel utilisateur

Renkforce

Renkforce 1208067 Manuel utilisateur

Levenhuk

Levenhuk Discovery Report WA40 Manuel utilisateur

Instant Transmission

Instant Transmission MA 10410 Manuel utilisateur

Lutron Electronics

Lutron Electronics PHB-318 Manuel utilisateur

WAREMA

WAREMA EWFS Weather station eco Manuel utilisateur