Peerless-AV SS560DPB Mode d’emploi

Installation and Assembly: 32" - 65" Flat Panel

Display Stand

Models: SS560DPB, SS560DPS

ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerlessmounts.com

Max UL Load Capacity:

160 lb (72.5 kg) display

2 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

NOTE: Read entire instruction sheet before you start installation and assembly.

Table of Contents

Parts List.................................................................................................................................................................................3

Assembling Cart.....................................................................................................................................................................4

Installing Adapter Plate...........................................................................................................................................................5

Mounting Flat Panel Display...................................................................................................................................................7

Cable Management................................................................................................................................................................8

Tools Needed for Assembly

• phillips screwdriver

• Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US

customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact

your local distributor.

• This product should only be installed by someone of good mechanical aptitude, and fully understands

these instructions.

• Never exceed the Maximum UL Load Capacity on page 1.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws ﬁrmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding

power.

• The stand is not afﬁxed or secured to the ﬂoor, and may therefore tip over and/or fall if display and/or stand is

shaken or hit. Always monitor children and do not let children play alone around stand as they could get hurt by a

falling display. Not recommended for use in areas with heavy trafﬁc.

• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal

injury.

WARNING

3 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

Before you begin, make sure all parts shown are included with your product.

Parts List SS560DPB SS560DPS

Description Qty. Part Number Part Numbe

column bracket 1 009-1419 009-1419

Badapter plate 1 009-1599 009-1599

Ccolumn base 1 009-1415 009-1415

Dcolumn 2 009-1418 009-5451

E5/16"-18 x 3/8" socket cap screws 4 520-1693 520-2693

F1/4-20 x 12mm socket screws 4 520-2325 520-2325

G5/16 x 1/4" set screw 4 520-9566 520-9566

H4mm allen wrench 1 560-9646 560-9646

I3/16" allen wrench 1 560-0071 560-0071

Parts may appear slightly different than illustrated.

A B C

EFG

H I

Adapter Bracket Fasteners

M5 x 12 mm (4)

(520-1027)

M5 x 25 mm (4)

(520-9543)

M6 x 12 mm (4)

(520-1128)

M6 x 25 mm (4)

(520-1208)

.75" spacer (4)

(540-1059)

Multi-washer (4)

(580-1398)

M8 x 25 mm (4)

(520-1031)

M8 x 12 mm (4)

(520-9571)

4 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

Insert columns (D) over column base supports (C)

and align cable management holes. Secure columns

to column base supports using four 5/16" socket

screws (E). Tighten screws using 3/16" allen

wrench (I).

FRONT VIEW REAR VIEW

Lock column bracket (A) in place by installing

four 5/16" set screws (G). Tighten screws against

columns (D) using 4mm allen wrench (H).

Insert column bracket (A) over columns (D) and

adjust to desired height. 43

Insert two 1/4-20 x 12mm socket screws (F) into

column bracket (A) using 4mm allen wrench (H),

leaving 3/16" of exposed thread as shown in detail 1.

CABLE MANAGEMENT

HOLES

DETAIL 1

3/16"

5 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

To prevent scratching the display, set a cloth on a ﬂat, level surface that will support the weight of the display. Place

display face side down. If display has knobs on the back, remove them to allow the adapter plates to be attached.

Place adapter plate (B) on back of display, align to holes, and center on back of display as shown below. Attach the

adapter plates to the back of the display using the appropriate combination of screws, multi-washers, and spacers

as shown in ﬁgure 5.1 or 5.2.

NOTE: Top and bottom mounting holes on display must be used for attaching brackets.

NOTE: Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.

NOTE: For ﬂat back displays proceed to step 5-1. For bump-out or recessed back display skip to step 5-2.

NOTE: "X" dimensions should be equal.

NOTES:

• The number of fasteners used will vary, depending

upon the type of display.

• Multi-washers and spacers may not be used,

depending upon the type of display.

• Use the corresponding hole in the multi-washer that

matches your screw size as shown.

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

MULTI-WASHER

Installing Adapter Plate

• Tighten screws so adapter plate is ﬁrmly attached. Do not tighten with excessive force. Overtightening can cause

stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become

detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

• If screws don't get three complete turns in the display inserts or if screws bottom out and adapter plate is still not

tightly secured, damage may occur to display or product may fail.

WARNING

6 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

Attaching Display using VESA 100, 200 or VESA 300 Mounting Pattern

• If screws don't get three complete turns in the display inserts or if screws bottom out and adapter plate is still not

tightly secured, damage may occur to display or product may fail.

WARNING

If you have any questions, please call Peerless customer care at 1-800-865-2112.

Select the screws from the bafﬂed fastener pack that best ﬁt your display. Begin with the shortest length screw,

hand thread through multi-washer and adapter plate (B)into display as shown below. Screw must make at least

three full turns into the mounting hole and ﬁt snug into place. Do not overtighten. If screw cannot make three full

turns into the display, select a longer length screw from the bafﬂed fastener pack. Repeat for remaining mounting

holes and tighten screws.

NOTE: Spacers may not be used, depending upon the type of display.

Select the screws from the bafﬂed fastener pack that best ﬁt your display. Begin with longer length screw, hand

thread through multi-washer, adapter plate (B) and spacer in that order into display as shown below. Screw must

make at least three full turns into the mounting hole and ﬁt snug into place. Do not overtighten. If screw cannot

make three full turns into the display, select a longer length screw from the bafﬂed fastener pack. Repeat for

remaining mounting holes and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

5-1

5-2

DISPLAY

ﬁg. 5.1

MULTI-WASHER

SCREW

MULTI-WASHER

SCREW

ﬁg. 5.2

SPACER

7 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

Mounting Flat Panel Display

Attach adapter plate (B) onto 1/4-20 screws of

column bracket (A).

2° Backward Tilt 5° Forward TiltNo Tilt

Insert two 1/4-20 x 12mm screws (F) into holes indicated below for desired display orientation. Tighten all screws

using 4mm allen wrench (H).

8 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

Run cables through columns (D) using cable management holes.

CABLE

MANAGEMENT

HOLES D

Cable Management

All other brand and product names are trademarks or registered trademarks of their respective owners.

Peerless Industries, Inc.

2300 White Oak Circle

Aurora, Il 60502

www.peerlessmounts.com

9 of 9 ISSUED: 09-08-11 SHEET #: 009-9055-5 07-25-12

Peerless Industries, Inc. (“Peerless”) warrants to original end-users of Peerless® products will be free from defects in material and workmanship, under normal

use, for a period of ﬁve years from the date of purchase by the original end-user (but in no case longer than six years after the date of the product’s manufacture).

At its option, Peerless will repair or replace, or refund the purchase price of, any product which fails to conform with this warranty.

In no event shall the duration of any implied warranty of merchantability or ﬁtness for a particular purpose be longer than the period of the applicable

express warranty set forth above. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

This warranty does not cover damage caused by (a) service or repairs by the customer or a person who is not authorized for such service or repairs by Peerless,

(b) the failure to utilize proper packing when returning the product, (c) incorrect installation or the failure to follow Peerless’ instructions or warnings when installing,

using or storing the product, or (d) misuse or accident, in transit or otherwise, including in cases of third party actions and force majeure.

In no event shall Peerless be liable for incidental or consequential damages or damages arising from the theft of any product, whether or not secured

by a security device which may be included with the Peerless® product. Some states do not allow the exclusion or limitation of incidental or consequential

damages, so the above limitation or exclusion may not apply to you.

This warranty is in lieu of all other warranties, expressed or implied, and is the sole remedy with respect to product defects. No dealer, distributor, installer or other

person is authorized to modify or extend this Limited Warranty or impose any obligation on Peerless in connection with the sale of any Peerless® product.

This warranty gives speciﬁc legal rights, and you may also have other rights which vary from state to state.

LIMITED FIVE-YEAR WARRANTY

www.peerlessmounts.com

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels peerless-AV Support TV

peerless-AV

peerless-AV PFL635 Manuel utilisateur

peerless-AV

peerless-AV SmartMount SA746PU Manuel utilisateur

peerless-AV

peerless-AV ACC-V1500X Manuel utilisateur

peerless-AV

peerless-AV LCZ-3F419B Mode d’emploi

peerless-AV

peerless-AV LCZ-4F4G30B Mode d’emploi

peerless-AV

peerless-AV PLP-UNM Mode d’emploi

peerless-AV

peerless-AV Paramount PT660 Manuel utilisateur

peerless-AV

peerless-AV SFL624 Manuel utilisateur

peerless-AV

peerless-AV DS509 Mode d’emploi

peerless-AV

peerless-AV PF660 Manuel utilisateur

peerless-AV

peerless-AV SA771P Mode d’emploi

peerless-AV

peerless-AV SmartMount SA771PU Manuel utilisateur

peerless-AV

peerless-AV SAX762PU Mode d’emploi

peerless-AV

peerless-AV ST650P-M Manuel utilisateur

peerless-AV

peerless-AV KIP740 Manuel utilisateur

peerless-AV

peerless-AV FPZ-655 Mode d’emploi

peerless-AV

peerless-AV SmartMount SA735P Mode d’emploi

peerless-AV

peerless-AV SUA765PU Mode d’emploi

peerless-AV

peerless-AV DS-S555-3X2 Manuel utilisateur

peerless-AV

peerless-AV Designer Series Manuel utilisateur

peerless-AV

peerless-AV ACCXT200 Mode d’emploi

peerless-AV

peerless-AV YBTLU Manuel utilisateur

peerless-AV

peerless-AV SUF660P Manuel utilisateur

peerless-AV

peerless-AV ECMU-01-I-S Mode d’emploi

Manuels Support TV populaires d'autres marques

Ergotron

Ergotron Neo Flex Cantilever UHD Manuel utilisateur

StarTech.com

StarTech.com FPCEILBTB Manuel utilisateur

VonHaus

VonHaus 05/038 Manuel utilisateur

Techlink

Techlink ECHO TV Manuel utilisateur

Sandstrom

Sandstrom SSTVMC12X Manuel utilisateur

Sony

Sony SU-WL700 Mode d’emploi

ICW

ICW SCACC18 Manuel utilisateur

LG WM-L640V Manuel utilisateur

Gembird

Gembird WM-65ST-01 Manuel utilisateur

ERARD

ERARD FiTUP XXL 035320 Manuel utilisateur

PEERLESS

PEERLESS PLCK-1 Mode d’emploi

Kanto

Kanto RCF180 Manuel utilisateur

GEM

GEM GEM GP001 Manuel utilisateur

Gladiator Joe

Gladiator Joe GJ0A0053 Manuel utilisateur

Vivotek

Vivotek AM-105 Manuel utilisateur

Vivo

Vivo VESA STAND-VAD1B Manuel utilisateur

AmazonBasics

AmazonBasics B07QG3LMG4 Manuel utilisateur

Secura

Secura QLF210 Manuel utilisateur

peerless-AV SS560DPB Mode d’emploi

Manuels Support TV populaires d'autres marques