Panasonic EYFMA1B Manuel utilisateur

© Panasonic Corporation 2015. All rights reserved.

Unauthorized copying and distribution is a violation

of law.

Order Number PTD1512E08CE

Cordless Impact Wrench

Model No. EYFMA1B

Model No. EYFMA1J

Model No. EYFMA1JR

Europe

TABLE OF CONTENTS

PAGE PAGE

1 Warning -------------------------------------------------------------- 2

2 Specifications ----------------------------------------------------- 2

3 Troubleshooting Guide ----------------------------------------- 3

4 Service Fixture and Adjustment----------------------------- 6

5 Disassembly and Assembly Instructions ---------------- 9

6 Measurements and Adjustments---------------------------15

7 Schematic Diagram ---------------------------------------------16

8 Wiring Connection Diagram ---------------------------------17

9 Exploded View and Replacement Parts List -----------18

2

1Warning

Caution:

• Pb free solder has a higher melting point that standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please

use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder-

ing iron, please be careful not to heat too long.

• Pb free solder will tend to splash when heated too high (about 1100°F / 600°C).

2 Specifications

3

3 Troubleshooting Guide

4

5

6

4 Service Fixture and Adjustment

4.1. Check Parts Identify Procedure

7

8

9

5 Disassembly and Assembly Instructions

5.1. Disassembly Instructions

Ref. No. 1A Procedure 1A Removal of Fixation cover.

1. Remove four screws where tightening fixation cover.

2. Pull off the fixing cover assembly.

3. Once removing the fixing cover, the driving shaft assembly may come

out.

Ref. No. 1B Procedure 1A 1B Removal of Anvil.

1. Pull the anvil out from the fixation cover.

10

Ref. No. 1C Procedure 1A 1B 1C Removal of Housing.

1. Remove nine housing screws.

2. Then open the housing A and B.

NOTE:

When opening the housings, make sure that the main PCB is on the

housing A.

If the main PCB sticks in the housing B and pull it out from the hous-

ing A, the ribbon cable may be defected.

Ref. No. 1D Procedure 1A 1B 1C 1D Removal of Ribbon cable (FPC).

1. Slightly lift up the connector.

NOTE:

Do not pull the connector firmly because it is not able to take out

completely.

2. Take out the ribbon cable.

Ce manuel convient aux modèles suivants

2

Table des matières

Autres manuels Panasonic Outils électriques

Panasonic

Panasonic EY74A2X Manuel utilisateur

Panasonic

Panasonic EY4541X57 Manuel utilisateur

Panasonic

Panasonic EY46A5 Manuel utilisateur

Panasonic

Panasonic 7552LJ Manuel utilisateur

Panasonic

Panasonic EY7549 Manuel utilisateur

Panasonic

Panasonic EYFPA1C Manuel utilisateur

Panasonic

Panasonic EY3640 Manuel utilisateur

Panasonic

Panasonic EY3610 Manuel utilisateur

Panasonic

Panasonic EY4550 Manuel utilisateur

Panasonic

Panasonic EY4550 Manuel utilisateur

Panasonic

Panasonic EY3640 Manuel utilisateur

Panasonic

Panasonic EYFEA1N Mode d'emploi

Panasonic

Panasonic EYFLA5A Manuel utilisateur

Panasonic

Panasonic EY4541X Manuel utilisateur

Panasonic

Panasonic EY4542 - CIRCULAR SAW 14.4V Manuel utilisateur

Panasonic

Panasonic EYFLA4A Manuel utilisateur

Panasonic

Panasonic EY46A5 Manuel utilisateur

Panasonic

Panasonic EYFLA4A Manuel utilisateur

Panasonic

Panasonic 4541OLOA Manuel utilisateur

Panasonic

Panasonic EYFPA1C Manuel utilisateur

Panasonic

Panasonic AccuPulse QP Low Noise Series Manuel utilisateur

Panasonic

Panasonic EY4541 Manuel utilisateur

Panasonic

Panasonic EY75A8 Manuel utilisateur

Panasonic

Panasonic EY4550 Manuel utilisateur

Manuels Outils électriques populaires d'autres marques

AEG

AEG OMNI-JS Manuel utilisateur

SIP

SIP 01533 Manuel utilisateur

Ribimex

Ribimex PRS499 Manuel utilisateur

3M

3M Fiber Optic Connector Crimp Tool Manuel utilisateur

Ryobi

Ryobi P524 Manuel utilisateur

ROJEK

ROJEK FSN 300A Manuel utilisateur

Kemper

Kemper 1740PRO Manuel utilisateur

WABCO

WABCO OptiTire Manuel utilisateur

EINHELL

EINHELL TE-MS 18/210 Li Manuel utilisateur

Orgapack

Orgapack OR-T 85 Guide rapide

TOUGHCUT

TOUGHCUT Diamond 400 Manuel utilisateur

Yaros

Yaros PB-3603 Manuel utilisateur

Fein

Fein BSS 2.0 E Guide de configuration

Baileigh Industrial

Baileigh Industrial SS-2725 Manuel utilisateur

Milwaukee

Milwaukee 2674-20 Manuel utilisateur

Fein

Fein BLs 1.6 Manuel utilisateur

Princess

Princess Electric Multi Sharpener Manuel utilisateur

FOREDOM

FOREDOM K.1050 Manuel