Kohler 880A Manuel utilisateur

BEFORE YOU BEGIN

1071635-AN2-C 1

880A 98309A 40MM RECESSED SHOWER ONLY VALVE

882A 98310A 40MM RECESSED BATH/SHOWER VALVE

HANDLE OPERATION

INSTALLATION INSTRUCTIONS 40mm Recessed Bath/Shower Valve

For 882A & 98310A, lift diverter, turn clockwise until it stops for shower, turn counter-clockwise until it stops

for bath spout.

ROUGH-IN DIMENSIONS

All information is based on the latest product information available at the time of publication. Kohler Co.

reserves the right to make changes in product characteristics, packaging, or availability at any time without

notice.

Please leave these instructions for the consumer. They contain important information.

NOTES:

1. The dimension from the finished wall to the centerline of the valve decided by the trim selection.

2. Flush the water supply pipes throughly to remove debris.

3. Observe all local plumbing and building codes.

4. Shut off the main water supply.

5. Do not remove the plaster guard from the valve body until instructed to.

6. Check for leaks befor covering the pipes, repairs as needed.

7. Inlet & outlet threads of valve are Rc1/2".

8. Maximum working pressure: 800Kpa.

9. All installations should comply with the relevant requirements of AS/NZS 3500.

10. Sku 98309A and 98310A include a kit for unequal pressure systems. The kit is to be installed per the kits

installation instructions. These Skus are for use in New Zealand Only.

11. Please ensure only apply water pressure test on the product, and empty the air in pipe and faucet

thoroughly before the test. Please ensure test pressure below 0.8MPa (8 bar) and test duration within 30

minutes.

(26)

Decided by trim selection

1220 to the ground

(for shower faucet)

370 to up side of bath fringe

(for bath & shower faucet)

Centerline of valve

160

Rc 1/2"

160

Rc 1/2"

Rc 1/2" (26)

1220

Centerline of valve

Decided by trim selection Ground

880A 98309A 882A 98310A

Rc 1/2" Rc 1/2"

1071635-AN2-C 2

1071635-AN2-C 3

INSTALLATION

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean

soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could

adversely affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

Determine where the valve body(1) will be located on the wall. Be

sure the arrow mark on the valve body is facing upward, the mark "hot

water connection" is on the left.

As Fig.1 shown. The Min. and Max. dimensions between the

centerline of the valve and the outside of the finished wall are decided

by trim selection. The size of finished wall hole extends from the size

of body should be less than 5mm.

Note: Ensure the centerline of valve is perpendicular to the wall, the

up plane of guard is level.

Connect Rc1/2" hot and cold supplies, showerhead and bath pipings

to valve body as Fig.2 shown. Connect hot supply to the end on the

left. For 880, do not connect the bath spout pipe. Supply enough tape

or sealant.

Install temporary nipples for showerhead and bath spout. During

installation, keep valve guard on valve body.

If the pipings are not strong enough to support the valve, cut off the

spacers(2) as needed and secure the valve body on the wall or frame.

**Color code must be specified when ordering

SERVICE PARTS 40mm Recessed Bath/Shower Valve

131

573

Min

Max

Handspray or bath spout

Showerhead

(Hot)

(Cold)

Fig.1

Fig.2

880A 98309A 40MM RECESSED SHOWER ONLY VALVE

882A 98310A 40MM RECESSED BATH/SHOWER VALVE

3006991

Valve

3006930

Nut

1089477**

Diverter

(Only for 882A & 98310A)

3007020

Spacer

3006906

Screw

1161279

Green Insert

1182266

Blue Insert

1193259

Check Valve Adaptor

1192780

Optiflow Shower Valve Kit

(Only for 98309A & 98310A)

Ce manuel convient aux modèles suivants

Autres manuels Kohler Unité de contrôle

Kohler

Kohler K-11842 Series Instructions de montage

Kohler

Kohler K-408 Instructions de montage

Kohler

Kohler K-402 Manuel utilisateur

Kohler

Kohler K-687 Instructions de montage

Kohler

Kohler K-10668 Instructions de montage

Kohler

Kohler TAUT 73193T-4CD Manuel utilisateur

Kohler

Kohler K-2971 Instructions de montage

Kohler

Kohler K-10959 Manuel utilisateur

Kohler

Kohler K-682 Manuel utilisateur

Kohler

Kohler K301 Manuel utilisateur

Kohler

Kohler DTV+ Konnect K-97999-NA Manuel utilisateur

Kohler

Kohler K-528 Manuel utilisateur

Kohler

Kohler 28209W-NA Manuel utilisateur

Kohler

Kohler AQUA TURBO 360 Manuel utilisateur

Kohler

Kohler K-175 Instructions de montage

Kohler

Kohler Mira Select B14C Manuel utilisateur

Kohler

Kohler K-175 Manuel utilisateur

Kohler

Kohler TOUCHLESS K-13686 Manuel utilisateur

Kohler

Kohler DTV+ Instructions de montage

Kohler

Kohler K-2976-KS Instructions de montage

Kohler

Kohler K-T10669 Instructions de montage

Kohler

Kohler K-305 Instructions de montage

Kohler

Kohler K-13516X Instructions de montage

Kohler

Kohler 1216612 Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur