Kodak CAROUSEL BC5601 Manuel utilisateur

Operating Manual

CONSUMER IMAGING

KODAK

CAROUSEL®

Slide Projector

All manuals and user guides at all-guides.com

all-guides.com

Important Safety Instructions

When using your projector, always follow basic safety precautions:

1. Read and understand all instructions before using this equipment.

2. Operate this projector with 110- to 125-volt 60 Hz current only. Incorrect voltage can cause projector

malfunction.

3. Close supervision is necessary when any appliance is used by or near children, or others who may not

understand the need for these precautions. Do not leave the projector unattended during use.

4. Be careful not to touch hot parts. For lamp replacement, allow the module to cool before touching the

lamp and the surrounding area. Do not place the lamp module on heat-sensitive surfaces.

5. Do not operate your projector if the cord is damaged or if the projector has been dropped or damaged

(see “How to Obtain Service” on page 29).

6. Position the cord so that it is not tripped over, pulled, or placed in contact with hot surfaces.

7. If an extension cord is necessary, use a cord with a current rating at least equal to that of the projector.

Cords rated for less amperage than the projector may overheat.

8. Always unplug the projector from the electrical outlet before cleaning and servicing and when it is not

in use.

9. Allow the projector to cool before storing.

10. Do not immerse this equipment in water or other liquids.

11. Do not disassemble this projector. Use a qualified service technician when service or repair is required.

Incorrect reassembly can cause electric shock the next time the projector is used.

12. Use only safety electrical low-voltage (SELV) devices.

13. The use of an accessory attachment not recommended by the manufacturer may increase risk of

damage.

14. Keep the air-flow vents unobstructed.

Save These Instructions

All manuals and user guides at all-guides.com

Operating Manual

KODAK

CAROUSEL

Slide Projector

All manuals and user guides at all-guides.com

KODAK CAROUSEL® Slide Projector 1

Contents

Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . .Inside Front Cover

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Loading the Slide Tray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

Projecting Your Slides . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9

Editing Your Presentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16

Clearing a Gate Jam . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

Using the Built-In Viewer (Model 5600 Only) . . . . . . . . . . . . . . . . . .18

Shutdown . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19

Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20

Changing the Projection Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21

Cleaning the Condenser, Heat-Absorbing Glass, and Mirror . . . . . . .22

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28

How to Obtain Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29

Serial Number

The serial number of your projector is printed on the label afﬁxed to the power

cord retainer on the base of the projector. Record this number, as well as the

model identiﬁcation, date, and place of purchase, for future reference.

All manuals and user guides at all-guides.com

2 KODAK CAROUSEL® Slide Projector

Introduction

Congratulations!

You have just purchased a KODAK CAROUSEL Slide Projector which:

• triples lamp life

• provides brighter and more vivid colors!

Introduction

Take the time to read the instructions in this operating manual to become

familiar with your KODAK CAROUSEL®Slide Projector and how to operate

it properly.

All manuals and user guides at all-guides.com

all-guides.com

KODAK CAROUSEL® Slide Projector 3

Overview

FRONT RIGHT

BACK RIGHT

BASE

1 – Tray

2 – Lock Ring

3 – Storage Compartment/Remote

4 – Elevating Foot

5 – Elevating Adjustment Wheel

6 – Elevating Foot Release Button

7 – Lens

8 – Viewer (Model 5600)

9 – Focus Knob

10 – Select Bar

11 – Timer (Model 5600)

12 – Reverse

13 – Forward

14 – Power/Fan/Lamp

15 – Tray Release Latch

16 – Lamp Module

17 – Reading Light

18 – Room Light Outlet (Model 5600)

19 – Remote Control Receptacle

20 – Power Cord

21 – Power Cord Retainer

22 – Leveling Foot

All manuals and user guides at all-guides.com

4 KODAK CAROUSEL® Slide Projector

Operation

Startup

Open the storage compartment and remove the remote control.

Plug the 5-pin cable remote connector into the remote-control receptacle,

aligning the raised dot with the metallic rivet head.

Plug the power cord into a grounded outlet with 110- to 125-volt 60 Hz

current only.

All manuals and user guides at all-guides.com

KODAK CAROUSEL® Slide Projector 5

Operation

Loading the Slide Tray

KODAK Slide Trays are available in 80- and 140-slide capacities. Use a

140-slide tray if you use thin-mounted slides (1/16 in. / 1.6 mm) and need

the larger capacity. Use an 80 cpacity tray if any of your slides have thick

mounts (1/8 in. / 2.5 mm).

Note: Do not attempt to project slides mounted with sticky or loose tape.

Place the tray over the center post of the projector. Align the "0" slot with the

gate index; the tray will drop into position.

If your 140-slide tray does not drop easily, secure the lock ring, invert the

tray, and align the index hole with the index notch. Slide and hold the tray

release latch in the direction of the arrow, and turn the bottom plate until the

index hole and notch align. Then release the latch. If you use an 80-slidetray,

rotate the metal plate on the bottom of the tray until it locks into position.

140-Slide Tray 80-Slide Tray

All manuals and user guides at all-guides.com

6 KODAK CAROUSEL® Slide Projector

Operation

Adding Your Slides Remove the lock ring by turning it counterclockwise and lifting it off.

Check each slide’s orientation (horizontal or vertical), and arrange them in the

order you wish to show them. Then turn the slides upside down.

Number each mount in the upper right-hand corner of the film’s shiny side.

Insert your first slide into the first slot in the tray so that the number is visible

on the outer circumference of the tray. Insert your second slide in the second

slot with the emulsion (dull side) facing your ﬁrst slide, and so on.

All manuals and user guides at all-guides.com

Table des matières

Autres manuels Kodak Projecteur

Kodak

Kodak LUMA 400 Manuel utilisateur

Kodak

Kodak CAROUSEL NEW LOOK PROJECTOR Manuel utilisateur

Kodak

Kodak Luma 75 Manuel utilisateur

Kodak

Kodak Carousel 760 Manuel utilisateur

Kodak

Kodak Ektalite 1000 Manuel utilisateur

Kodak

Kodak DP1050 ULTRA Manuel utilisateur

Kodak

Kodak Instamatic M Series Manuel utilisateur

Kodak

Kodak DP900 - Digital Projector Manuel utilisateur

Kodak

Kodak Instamatic M80 Manuel utilisateur

Kodak

Kodak Carousel 850H Mode d'emploi

Kodak

Kodak DP850 - Ultra Digital Projector Manuel utilisateur

Kodak

Kodak Ektapro 4020 Manuel utilisateur

Kodak

Kodak V600 Manuel utilisateur

Kodak

Kodak FLIK X10 Manuel utilisateur

Kodak

Kodak DP850 - Ultra Digital Projector Guide de démarrage rapide

Kodak

Kodak FLIK X4 Manuel utilisateur

Kodak

Kodak Carousel S-AV 2060 Manuel utilisateur

Kodak

Kodak EKTAPRO Manuel utilisateur

Kodak

Kodak Ektalite 2000 Manuel utilisateur

Kodak

Kodak Carousel S-AV28 Mode d'emploi

Kodak

Kodak Pocket Pico Projector Manuel utilisateur

Kodak

Kodak PAGEANT 250S Manuel utilisateur

Kodak

Kodak V600 Manuel utilisateur

Kodak

Kodak BC4401 - Carousel 4400 Projector Guide de configuration

Manuels Projecteur populaires d'autres marques

iEmmet

iEmmet MP-312 Manuel utilisateur

Epson

Epson VS400 Manuel utilisateur

Sony

Sony VPL-HS10 Marketing Specifications & Features Manuel utilisateur

Sony

Sony VPL-HW65ES Manuel de service

Toshiba

Toshiba TLP-791U Manuel utilisateur

Philips

Philips LC1341 Guide de référence

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manuel utilisateur

NEC

NEC NP600S EDU Manuel utilisateur

BenQ

BenQ SH753P Manuel utilisateur

Eiki

Eiki EK-623U series Manuel utilisateur

Epson

Epson PowerLite Pro Cinema 6020UB Manuel utilisateur

Epson

Epson PowerLite Home Cinema 705HD Manuel utilisateur

Christie

Christie LHD700 Manuel utilisateur

Navitar

Navitar FX Manuel utilisateur

InFocus

InFocus LitePro 560 Manuel utilisateur

Sony

Sony SRX-R815P Manuel utilisateur

Vivitar

Vivitar DP1500 X Manuel utilisateur

Acer

Acer C20 Series Manuel utilisateur