FIC CE31-A Manuel utilisateur

CE31-A

MAINBOARD

MANUAL

DOC No.: 098B09

Rev. : A0

Date : 4, 1999

Part No. : 25-10936-20

Handling Precautions

Warning:

1. Static electricity may cause damage to the integrated circuits on

the motherboard. Before handling any motherboard outside of its

protective packaging, ensure that there is no static electric charge

in your body.

2. There is a danger of explosion if the battery is incorrectly

replaced. Replace only with the same or an equivalent type

recommended by the manufacturer.

3. Discard used batteries according to the manufacturer’s

instructions.

Observe the following basic precautions when handling the motherboard

or other computer components:

nWear a static wrist strap which fits around your wrist and is

connected to a natural earth ground.

nTouch a grounded or anti-static surface or a metal fixture such as a

water pipe.

nAvoid contacting the components on add-on cards, motherboards,

and modules with the golden fingers connectors plugged into the

expansion slot. It is best to handle system components by their

monting brackets.

The above methods prevent static build-up and cause it to be discharged

properly.

Trademark

All trademarks mentioned in this manual are registered properly of

the respective owners.

Handling Precautions

Thismanualmaynot,inwholeorinpart,bephotocopied,reproduced,

transcribed, translated, or transmitted in whatever form without the

written consent of the manufacturer, except for copies retained by the

purchaser for personal archival purposes.

Notice

TableofContents

Table of Contents

Chapter 1 Overview

Package Checklist .......................................................................... 1-2

TheCE31-AMainboard ............................................................ 1-3

Main Features................................................................................ 1-4

Intelligent Properties...................................................................... 1-6

ACPIReady ................................................................................... 1-7

Chapter 2 Installation Procedures

1). Set System Jumpers ................................................................. 2-2

QuickReference............................................................................. 2-3

Mainboard Layout .................................................................... 2-7

ClearPassword:CLR_PWD .............................................. 2-9

ClearCMOS:J4 ................................................................. 2-9

InternalUSB Port Enable:J3.............................................. 2-10

2). Install RAM Modules .............................................................. 2-10

SDRAM..................................................................................... 2-10

RAM Module Configuration..................................................... 2-11

Install and Remove DIMMs ...................................................... 2-11

3).Install the CPU .......................................................................... 2-12

4). Install Expansion Cards............................................................. 2-13

5). Connect Devices ....................................................................... 2-15

FloppyDiskette Drive Connector:FLOPPY ...................... 2-15

IDEHDDDevice Connectors:PRIMARY,SECONDARY .. 2-16

ATX Power Connector: POWER ....................................... 2-16

CPUFan Connector: FAN1 ............................................... 2-17

Wake-On-LAN Connector: WOL ...................................... 2-17

Front Panel Block Connector ............................................ 2-18

PCIAudio Card Connector:SB_LINK .............................. 2-19

InfraredConnector: IR....................................................... 2-19

PS/2 Keyboard and Mouse Connector: KB, MS ............... 2-20

UniversalSerial BusConnectors: USB0,USB1, CONN1 ... 2-20

PrinterConnector: LPT...................................................... 2-21

SerialPort Connectors: COM1,COM2 .............................. 2-21

Joystick/MIDIConnector: GAME..................................... 2-22

AudioI/O Jacks: L_OUT,L_IN, MIC_IN .......................... 2-22

Video Graphics AcceleartorConnector: VGA ................... 2-23

CE31-AMainboardManual

Chapter 3 BIOS Setup

CMOSSetup Utility ....................................................................... 3-1

Standard CMOS Setup................................................................... 3-2

Hard Disk Configurations.......................................................... 3-2

Software Turbo Speed............................................................... 3-3

BIOS Features Setup...................................................................... 3-3

Chipset Features Setup.................................................................. 3-6

Power Management Setup ............................................................. 3-9

PNP/PCIConfiguration .................................................................. 3-13

LoadBIOS Defaults ....................................................................... 3-14

Load Setup Defaults ...................................................................... 3-14

Integrated Peripherals.................................................................... 3-15

Supervisor/User Password ............................................................ 3-19

IDE HDD Auto Detection .............................................................. 3-19

Save and Exit Setup ....................................................................... 3-19

Exitwithout Saving ........................................................................ 3-20

Chapter 4 FAQs

GeneralFAQs................................................................................. 4-1

BIOSFAQs .................................................................................... 4-5

Windows 98 FAQs ......................................................................... 4-7

Windows 95 FAQs ......................................................................... 4-8

IntelCPU FAQs ............................................................................. 4-9

1 - 1

Overview

Chapter 1

TheCE31-A isa MicroATX sized Socket 370motherboard with onboard Video

and Audio, and support for Ultra DMA/66. The CE31-A supports the Intel®

Celeron PPGA 300-500 MHz processor at 66MHz Front side bus, and is ready

to support 100MHz Front Side Bus in the event of any future CPU upgrades.

Based around the SIS Eagle chipset, the CE31-A is a feature rich mainboard

offering the very latest in quality onboard integrated functions.

Quality stereo sound is provided by the ESS Solo-1 onboard audio chip, which

is equipped with Headphone AMP, while graphics capabilities are provided

by the SIS 6326 2D/3D, which is embedded in the North Bridge. The option of

DVD playback software and a TV-out connection, allows DVD playback on

a TV, instead of just a monitor. This special feature is enabled by FIC’s unique

licensing agreement with CSS.

With support for Ultra DMA/66 and its high-speed interface, hard drive per-

formance and data transfer speeds are significantly increased. The CE31-A

has 2 DIMM, providing up to 1 GB of SDRAM, and has 3 PCI and 1 ISA

expansion slot. UMA mode can be selected through the BIOS at either 4MB or

8MB, while non UMA mode is offered as a manufacturing option. The CE31-

Ais ACPI ready,ensuring improvedpower management, and is PC98and Y2K

compliant. Other key features of the CE31-A are Keyboard/Mouse Power On

and CD Pro with enhanced drivers. A hardware monitoring facility provides

effective system control and protection.

The CE31-A offers a complete set of standard I/O features, such as 2 serial

ports, 1 parallel port, 1 PS/2 mouse and keyboard connector and 2 USB con-

nectors. There are also connectors for 1 VGA, 1 media, mono-in for modem,

CD-in,Wake-on-LAN and Wake-on-Ring.

1 - 2

CE31-AMainboardManual

Package Checklist

If you discover any item below was damaged or lost, please contact your

vendor.

Ö Themainboard

Ö Thisuser manual

Ö Onefloppy diskdrive cable

Ö Oneprinter and COM1cable

Ö One HDD cable

Ö One COM2 cable

Ö One USB cable (optional)

Ö Software utilities

1 - 3

Overview

The CE31-A Mainboard

1 - 4

CE31-AMainboardManual

Main Features

■Easy Installation

||BIOS with support for Plug and Play, auto detection of IDE hard drives,

||LS-120|drives,IDE ZIPdrives, Windows95, Windows98,Windows NT,

||andOS/2.

■Leading Edge Chipset

SiS Eagle chipset includes a CPU interface controller, integrated memory

controller, integrated power management unit, concurrent PCI (PCI v.2.0,

2.1,2.2), 3D video, IDE and ISA bus controller.

■Flexible Processor Support

Onboard Socket 370 supports leading-edge processors:

Celeron™PPGAprocessors 300A/333/366/400/433/466/500MHz and up.

|■Various External Bus and CPU/Bus Frequency Ratio Support

The board supports the Bus frequency of 66 / 75 / 83 / 90 / 95 / 100 / 112

/124 / 133MHz and theCPU/Bus frequencyratio of2x /2.5x /3x / 3.5x / 4x

/ 4.5x / 5x / 5.5x / 6x / 6.5x / 7x / 7.5x / 8x by a switching voltage regulator

whichaccepts 1.8V to2.8V.|||(Please read InstalltheCPU in Chapter2 for

moreinformation).

■Versatile Main Memory Support

Accepts up to 1GB RAM using two DIMMs of 8, 16, 32, 64, 128, 256,

512MBwith support forlightning-fast SDRAM (66/100MHz).

■ISA and PCI Expansion Slots

One 16-bit ISA Bus and three 32-bit PCI Bus expansion slots provide the

room to install a full range of add-on cards.

■Onboard IrDA Connector

An IrDA connector for wireless infrared connections is available.

1 - 5

Overview

■Enhanced PCI Bus Master IDE Controller with Ultra DMA/33 and

Ultra DMA/66 Support

Integrated Enhanced PCI Bus Master IDE controller features two dual-

channel connectors that accept up to four Enhanced IDE devices, includ-

ing CD-ROM and Tape Backup Drives, as well as Hard Disk Drives sup-

portingthe new UltraDMA/66 protocol. Standard PIO Mode 3, PIO Mode

4, DMA Mode 2, DMA Mode 4 devices are also supported.

■USB Support

A fly cable comes with the board for allowing convenient, high-speed

Plug and Play connections (up to four USB ports) to the growing number

of USB compliant external peripheral devices on the market.

■■

■Remote Wake-Up Support

One LAN wake-up connector, WOL, supports LAN cards equipped for

remote wake-up functionality; also, an additional Wake-On-Ring connec-

tor awakes the system while the ring signal via modem.

■■

■Super Multi Input/Output (I/O) Support

IntegratedPlug and Play multi-I/O chipset features two high-speed UART

16550 compatible serial ports, one IR connector, one EPP/ECP capable

parallel port, and one FDD connector.

■■

■SB-LINKÔfor theAudio Card with PCI Bus

The 2x3 pin SB-LINKÔheader accepts the Creative CT4600 series PCI

audio cards with PCI solution to connect the Legacy Sound BlasterÒ

compatible audio to the PCI bus.

■■

■Compact ESS Solo-1 Audio Subsystem for Sound and Game

The onboard audio provides DirectMusic accelerator. It also provides

OPL3,Sound BlasterPro, MPU401UARTmodeand Joystick function for

various PC games on real DOS mode that without software drivers. The

board came with three audio jacks: MIC_IN, L_IN, L_OUT; and one con-

nector for joystick with MIDI interface.

1 - 6

CE31-AMainboardManual

Intelligent Properties

This mainboard comes equipped with the most advanced new features that

not only optimize the performance of the latest processors but also enhance

the manageablity, power management capabilities, and user-friendliness of

your system. This section provides detailed information on these features,

and how they are implemented on the mainboard.

■■

■OptimizedCeleronÔPPGA Processor Performance

The mainboard utilizes the advanced features of the SiS Eagle chipset to

optimize the unrivaled performance of the CeleronÔPPGA processor

with MMXÔtechnology, allowing you to enjoy a richer video, audio,

digitalimaging and communicationsexperience from the latest generation

ofmultimedia software.

■Capability of Conference via Modem

The board equipped a MONO connector to allow users to talk with other

people at remote end via a modem.

■Connection with a Television (Optional)

The manufacturing optional connector, TV1, makes use of a television as

a monitor for software games and other tasks by a cable from the board to

theTV.

Table des matières

Manuels Carte mère populaires d'autres marques

DFI

DFI SD170 Manuel utilisateur

ASROCK

ASROCK ROMED8-2T Manuel utilisateur

Asus

Asus P2L97A Manuel utilisateur

Winmate

Winmate IC70 Manuel utilisateur

Asus

Asus MES-B Manuel utilisateur

Grantech

Grantech SYS8F377VGGA-3OMN Manuel utilisateur

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuel utilisateur

Gigabyte

Gigabyte GA-9IVDT Manuel utilisateur

Texas Instruments

Texas Instruments ADS8372EVM Manuel utilisateur

Commell

Commell MS-C73 Manuel utilisateur

IBT Technologies

IBT Technologies MB860 Manuel utilisateur

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur

Biostar

Biostar M7VIT Bravo Instructions d'utilisation et d'installation

Intel

Intel D33217CK Manuel utilisateur

Asus

Asus F1A55-M LX PLUS R2.0 Manuel utilisateur

EPC

EPC EPC9147C Manuel utilisateur

Asus

Asus EX-B760M-V5 D4 Manuel utilisateur

EPOX

EPOX MU-8KHA0010 Manuel utilisateur