FIC 1stMainboard VG33 Manuel utilisateur

VG33

MAINBOARD

MANUAL

DOCNo.: M02A04

Rev. |:A0

Date |:1, 2003

Part No. |: 25-10630-00

Handling Precautions

Warning:

1. Static electricity may cause damage to the integrated circuits on

the motherboard. Before handling any motherboard outside of its

protective packaging, ensure that there is no static electric charge

in your body.

2. There is a danger of explosion if the battery is incorrectly

replaced. Replace only with the same or an equivalent type

recommended by the manufacturer.

3. Discard used batteries according to the manufacturer’s

instructions.

4. Never run the processor without the heatsink properly and firmly

attached. PERMANENTDAMAGE WILLRESULT!

Observe the following basic precautions when handling the motherboard

or other computer components:

Wear a static wrist strap which fits around your wrist and is

connected to a natural earth ground.

Touch a grounded or anti-static surface or a metal fixture such as a

water pipe.

Avoid contacting the components on add-on cards, motherboards,

and modules with the golden fingers connectors plugged into the

expansion slot. It is best to handle system components by their

mounting brackets.

The above methods prevent static build-up and cause it to be discharged

properly.

Trademark

All trademarks mentioned in this manual are registered properly of

the respective owners.

Handling Precautions

Thismanual maynot, inwhole orin part,be photocopied,reproduced,

transcribed, translated, or transmitted in whatever form without the

written consent of the manufacturer, except for copies retained by the

purchaser for personal archival purposes.

Notice

Table of Contents

Chapter 1 Overview

Package Checklist .......................................................................... 1-2

TheVG33Mainboard ................................................................ 1-3

Main Features................................................................................ 1-4

Chapter 2 Installation Procedures

QuickReference (fromPage2-2 to 2-4) .......................................... 2-2

Mainboard Layout .................................................................... 2-2

(1).ClearCMOS ................................................................ 2-3

(2). Front Panel Block Cable Connection ........................... 2-3

(3).CPU Fan Installation.................................................... 2-4

1).SetSystem Jumper .................................................................... 2-4

ClearCMOS:JP3 ............................................................... 2-4

2). Install Memory Modules .......................................................... 2-5

3). Install the CPU .......................................................................... 2-5

4). Install Expansion Cards ............................................................. 2-7

5). ConnectDevices ....................................................................... 2-8

FloppyDisketteDrive Connector ...................................... 2-8

IDEDevice Connectors ..................................................... 2-9

Power Connectors ............................................................. 2-9

CDAudio-In Connectors................................................... 2-10

FrontPanel Block,Power LED, IR,andSpeaker Connector

.......................................................................................... 2-10

Fan Connectors ................................................................. 2-12

Wake-On-Lan Connector................................................... 2-12

Wake-On-Ring Connector ................................................. 2-13

SPDIF Out Connector ....................................................... 2-13

SerialIRQ Connector......................................................... 2-14

Quick Reference (German) G-1

Quick Reference (French) F-1

Quick Reference (Spanish) S-1

Quick Reference (Japanese) J-1

Quick Reference (Chinese) C-1

Quick Reference (Simplified Chinese) |||||||||||||SC-1

VG33MainboardManual

PS/2 Keyboard and Mouse Connector.............................. 2-14

Universal Serial Bus Connectors....................................... 2-14

Serial Port Connectors....................................................... 2-15

Printer Connector .............................................................. 2-16

Audio I/O Jacks ................................................................ 2-16

VideoGraphicsAccelerator Connector .............................. 2-17

LAN Connector ................................................................. 2-17

IEEE1394 Connectors (mfg.optional) ............................... 2-18

Chapter 3 BIOS Setup

Main Features Setup...................................................................... 3-1

Advanced Features Setup ............................................................. 3-3

Onboard device Configuration.................................................. 3-5

I/O device Configuration ........................................................... 3-6

Hardware Monitor ..................................................................... 3-7

Power Features Setup .................................................................... 3-8

Boot Features Setup ...................................................................... 3-9

Exit Features Setup ........................................................................ 3-10

1 - 1

Overview

Chapter 1

The new microATX 1stMainboard®VG33 supports a full range of the latest

generation Intel®Pentium®4 CPUs. The leading edge chipset Intel®845GE

MCH was designed for coworking with Pentium®4 in the mPGA478 CPU

socket based on VRM 9.X spec. and 533 MHz FSB. Being built by the leading

edge technology, the Intel Pentium®4 processors provide a significant perfor-

mance over previous Pentium®III processors. Onboard two DDR SDRAM

sockets supportDDR333 SDRAM for up to 2GB memory capacity.The ICH4

brings the ATA100 IDE performance and its high-speed interface further en-

sures that data transfer speeds are improved, especially for six USB 2.0 periph-

eral devices. The board also features onboard audio with either 2-channel or

5.1-channel.

The board comes with a versatile range of I/O features such as 2 serial ports,

three optional 1394 ports (pinheaders onboard), 1 parallel port, 1 LAN, 1 IR, 1

PS/2 mouse and keyboard connector, 6 USB 2.0 ports (two of them are in one

pinheader), 1 media connector (front audio pinheader, Line-in, Line-out and

Mic-in).Ample expansion is available through 3 PCI, 1AGP slot to meet the

requirementfor fully makinguseof theP4CPU benefits ininternetapplicatons,

video/3D graphics performance, and so forth.

Other key features are Remote On/Off, Auto Power Failure Recovery, inte-

grated temperature monitoring and system fan control. Included also is a CD,

1st Utilities, with enhanced drivers.

1 - 2

VG33MainboardManual

NOTE: lst Utilities CD that contains patch files, onboard video/au-

dio chip drivers, related online help and other useful information

can be found in your mainboard package.

Please install it right after your Windows operating system installa-

tion is done.Place your lst Utilities CD in the drive, an operating

menu will appears in your monitor. Please select Auto Installation.

It will automatically detect which software tools (patch files, drivers)

that the mainboard needs. Press OK button to go through the whole

installation procedure in a very straight forward and easy way. It

also provides you with a custom way to select wanted patch files

and software drivers that for onboard chips use. The top menu of

thelst Utilities CDlistsallthefunctions that allowedbythisboard.

NOTE: Aboutthe USB2.0 driver.

if you use-

Windows XP + Sevice Pack 1: it offers the driver.

Windows XP: download it from Microsoft web site.

Windows 2000/98SE/ME:

driver in lst Utilities CD, please manually installed it.

Package Checklist

If you discover any item below was damaged or lost, please contact your

vendor.

;The mainboard ;This user manual

;OneFDDcable ;|SoftwareCD

;OneATA/100 cable ;|I/O shilding

1 - 3

Overview

The VG33 Mainboard

1 - 4

VG33MainboardManual

Main Features



Easy Installation

||BIOS with support for Plug and Play, auto detection of IDE hard drives,

||LS-120|drives, IDE ZIPdrives,Windows 98SE,Windows ME, Windows

||NT,Windows 2000, Windows XP, and OS/2.



Leading Edge Chipset

Intel®845GE supports integrated graphic (UMA only) features that of 32

bpp true color and flat panel monitors. The ICH4 provides SMBus 2.0

support,20-bitAC97 audio, 6USB2.0ports,andUltraATA100 IDEperfor-

mance between mainboard and peripheral devices.



Versatile Main Memory Support

Acceptsupto 2GBDDRSDRAMusing two memory socketsforallowing

thatfrom64, 128,256,512MB,1GBwith support forlightenning-fastDDR

SDRAM(DDR200/266/333MHz).



Super Multi Input/Output (I/O) Support

Integrated Plug and Play multi-I/O chipset features two high-speed UART

16550 compatible serial ports, one parallel port and one FDDconnector.



AGPand PCI Expansion Slots

One AGP Bus that supportsAGP (only 1.5VAGP 4X card allowed) and

three PCI Bus expansion slots provided the room to install a full range of

add-on cards.



Intel P4 Processors Support

1.4Gto2.5GHzandup*(FSB400) /Celeron1.7-2.0GHzandup*(FSB400)

2.0Gto3.06GHz andup* (FSB 533)

(*: not tested yet)

1 - 5

Overview



Integrated Audio Subsystem



Enhanced PCI BusMaster IDEController with UltraDMA33/66/100

Support

Integrated Enhanced PCI Bus Master IDE controller features two dual-

channel connectors that up to four Enhanced IDE devices, including CD-

ROM and Tape Backup Drives, as well as Hard Disk Drives supporting

thenew UltraATA100protocol. Standard PIOMode 3,PIOMode 4,DMA

Mode 2, DMA Mode 4, UltraDMA-100 Mode 5 devices are also sup-

ported.



Convenient Rear Panel USB Connection Support

Four USB ports integrated in the rear I/O panel and one USB pinheader for

two USB ports to allow the connecting with either front or rear panel jacks

in a convenient way and high-speed Plug and Play connection to the USB

2.0 compliant peripheral devices on the market.

Onboard audio features included one SPDIF pinheader for digital audio

resource output use. The onboard AC97 Codec chip has two options:

either supports 2-channel or optional 5.1-channel audio feature. If the

latter one onbaord, the Microphone/Line_In/Line_Out can be used as

audio output.



LAN Support

Onboard optional LAN controller with one optional RJ45 jack integrated

with other rear panel I/O connectors pvovides users with a convenient

connection with network environment.



1394 Support (optional)

One optional 1394 controller with three optional 2x5 pinheaders of 1394

ports (Intel spec.) for more efficient peripheral device connection and

data transaction.

1 - 6

VG33MainboardManual

The Page Left Blank for Note

Table des matières

Manuels Carte mère populaires d'autres marques

DFI

DFI SD170 Manuel utilisateur

ASROCK

ASROCK ROMED8-2T Manuel utilisateur

Asus

Asus P2L97A Manuel utilisateur

Winmate

Winmate IC70 Manuel utilisateur

Asus

Asus MES-B Manuel utilisateur

Grantech

Grantech SYS8F377VGGA-3OMN Manuel utilisateur

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuel utilisateur

Gigabyte

Gigabyte GA-9IVDT Manuel utilisateur

Texas Instruments

Texas Instruments ADS8372EVM Manuel utilisateur

Commell

Commell MS-C73 Manuel utilisateur

IBT Technologies

IBT Technologies MB860 Manuel utilisateur

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur

Biostar

Biostar M7VIT Bravo Instructions d'utilisation et d'installation

Intel

Intel D33217CK Manuel utilisateur

Asus

Asus F1A55-M LX PLUS R2.0 Manuel utilisateur

EPC

EPC EPC9147C Manuel utilisateur

Asus

Asus EX-B760M-V5 D4 Manuel utilisateur

EPOX

EPOX MU-8KHA0010 Manuel utilisateur