AudioCodes Mediant Series Manuel utilisateur

Version 6.8 / 7.0

May 2016

Quick Setup Guide

BroadCloud SIP-Trunking Service using

AudioCodes Mediant BRI/PRI Gateway

BRI/PRI Media Gateways

AudioCodes Mediant™ Series

BroadCloud SIP Trunk

AudioCodes Mediant BRI/PRI Gateway 2 Document #: LTRT-12393

Table of Contents

1Introduction .........................................................................................................3

1.1 Component Information............................................................................................3

2Installing the Hardware.......................................................................................5

2.1 Mediant 500L Media Gateway .................................................................................5

2.2 Mediant 500 PRI Media Gateway ..........................................................................10

2.3 Mediant 800B Media Gateway ...............................................................................13

3Connecting to the Management Interface .......................................................17

3.1 Default OAMP IP Address......................................................................................17

3.2 Connecting to the Embedded Web Server.............................................................17

4Configuring the Device .....................................................................................19

4.1 Step 1: Download, Install BroadCloud Certified Firmware / Configuration............. 19

4.2 Step 2: Configure a Network Interface for the Device............................................23

4.3 Step 3: Configure PSTN Trunk Settings ................................................................26

4.4 Step 4: Configure General SIP Parameters ...........................................................28

4.5 Step 5: Configure Trunk Group Parameters ..........................................................29

4.6 Step 6: Configure the Number of Digits to be Present to the PBX.........................32

4.7 Step 7: Check the SIP Trunk Registration Status ..................................................34

4.8 Step 8: Secure Device Access...............................................................................35

4.9 Step 9: Save the Configuration, Connect to DMZ ..................................................36

AOptional TDM PSTN Fallback if WAN Fails .....................................................37

BTroubleshooting ................................................................................................39

CAudioCodes ini File...........................................................................................41

Notice

This Quick Setup Guide shows how to connect the BRI/PRI PBX and the BroadCloud SIP

trunk using AudioCodes' Mediant Gateway product series.

Information contained in this document is believed to be accurate and reliable at the time of

printing. However, due to ongoing product improvements and revisions, AudioCodes cannot

guarantee accuracy of printed material after the Date Published, nor can it accept

responsibility for errors or omissions. Updates to this document and other documents as

well as software files can be viewed by registered customers at

http://www.audiocodes.com/downloads.

This document is subject to change without notice.

Date Published: May-29-2016

Quick Setup Guide 1. Introduction

BroadCloud SIP Trunk 3 AudioCodes Mediant BRI/PRI Gateway

1 Introduction

This guide shows how to set up AudioCodes' Mediant BRI/PRI Gateway to interoperate

with the BroadCloud SIP trunk.

1.1 Component Information

1.1.1 AudioCodes Gateway Version

Table 1-1: AudioCodes Gateway Version

SBC Vendor AudioCodes

Models Mediant 500L

Mediant 500

Mediant 800B

Software Version Mediant 500L - SIP_F7.00A.044.007

Mediant 500 - SIP_F6.80A.263.005

Mediant 800B - SIP_F6.80A.263.005

Protocol SIP/UDP (to the BroadCloud SIP trunk)

BRI/PRI (to the PSTN PBX)

1.1.2 BroadCloud SIP Trunking Version

Table 1-2: BroadCloud Version

Vendor/Service Provider BroadSoft

SSW Model/Service BroadWorks

Software Version 21

Protocol SIP

BroadCloud SIP Trunk

AudioCodes Mediant BRI/PRI Gateway 4 Document #: LTRT-12393

1.1.3 Solution Topology

Interoperability between AudioCodes' BRI/PRI gateway and the BroadCloud SIP trunk was

achieved using the following topology setup:



Enterprise BRI/PRI PBX



AudioCodes Mediant Gateway device, connecting the enterprise’s BRI/PRI PBX to the

BroadCloud SIP trunking service over IP



Internet/MPLS network connectivity to the BroadCloud SIP trunk service

The figure below illustrates this solution topology:

Figure 1-1: Solution Configuration

Quick Setup Guide 2. Installing the Hardware

BroadCloud SIP Trunk 5 AudioCodes Mediant BRI/PRI Gateway

2 Installing the Hardware

2.1 Mediant 500L Media Gateway

2.1.1 Front Panel

LEDs on the front panel indicate functionality statuses.

Figure 2-1: Front Panel - LEDs

When green, 1 (power LED) indicates power is on. Table 2-1 describes 2 (Status LED).

Table 2-1: Status LED

LED

Color

LED State Description

Green On Device is operational.

Flashing Initial rebooting stage.

Red On Boot failure.

- Off Advanced rebooting stage.

2.1.2 Rear Panel

Figure 2-2: Rear Panel

Table 2-2: Rear Panel

Item # Label Description

1 POWER 12V -- 3A AC power supply plug entry to connect to the external AC power supply adapter.

2 ON / OFF Power button which powers on the device when pressed in and powers off the device when

pressed again (pressed out).

3 CONSOLE RJ-45 port for RS-232 serial communication with the device.

BroadCloud SIP Trunk

AudioCodes Mediant BRI/PRI Gateway 6 Document #: LTRT-12393

Item # Label Description

USB 2.0 port, not applicable.

5 // Reset pinhole button to reset the device or to restore to factory defaults. To restore to

factory defaults: With a paper clip or any other similar pointed object, press and hold down

the pinhole button for at least 12 seconds, but no longer than 25 seconds

6 S1 / FE LAN Up to four Fast Ethernet (10/100Base-T) ports (RJ-45) to connect to LAN or WAN. These

support full-duplex modes, auto-negotiation, and straight or crossover cable detection.

7 S2 / BRI Up to four ISDN BRI port interfaces (RJ-45)

2.1.3 Cabling

2.1.3.1 Connecting LAN Interfaces

Four Fast Ethernet (10/100Base-T) ports (supporting half- and full-duplex modes, auto-

negotiation, and straight or crossover cable detection) allow connection to the LAN/WAN.

To connect the device to the BroadCloud service:

1. If the device's IP isn't configured yet, connect as shown in Section 3.

2. If the device's IP has already been configured:

a. Connect one end of a straight-through RJ-45 Cat 5e or Cat 6 cable to the RJ-45

port labeled S1 / FE LAN port 1.

b. Connect the other end to the DMZ port assigned by the IT administrator.

Figure 2-3: Cabling Ethernet Ports

2.1.3.2 Connecting BRI Lines

This section shows how to connect the device's BRI ports to the PBX.

Warning: To protect against electrical shock and fire, use a 26 AWG min wire.

To connect a BRI line:

1. Connect the RJ-45 cable to the device's BRI port 1 on the rear panel (it's labeled S2 /

BRI).

Quick Setup Guide 2. Installing the Hardware

BroadCloud SIP Trunk 7 AudioCodes Mediant BRI/PRI Gateway

Figure 2-4: Cabling BRI Ports

2. Connect the other end of the cable to your ISDN PBX equipment.

2.1.3.3 Connecting to the Power Supply

The device is powered by an external 12V AC/DC power adapter (supplied), connected to

a standard alternating current (AC) electrical wall outlet.

Table 2-3: Power Specifications

Item Description

Power Supply Single universal external AC power supply

Input Ratings 100-240 VAC, 50-60 Hz

Output Ratings 12V/3A

Warning: Use only the AC/DC power adapter supplied with the device.

The device is shipped with the AC/DC power adapter shown Figure 2-5 which also

supports interchangeable plugs to suite the electrical wall outlet type requirement of the

country in which the device is being installed.

BroadCloud SIP Trunk

AudioCodes Mediant BRI/PRI Gateway 8 Document #: LTRT-12393

Figure 2-5: AC/DC Power Adapter

Table 2-4: Power Adapter with Interchangeable Plugs

Item Description

1 Plug slot

2 Plug lock

3 Plug release lever

4 DC power cord

5 DC power plug

To connect the device to the power supply using the power adapter:

1. Insert the relevant AC plug into the housing power adapter:

a. Insert the top part of the plug into the upper part of the housing slot (1).

b. Press down on the bottom part of the plug until a "click" sound is heard, indicating

that the plug is securely inserted in the housing slot. To remove the plug, push

and slide down the OPEN plug release lever (3).

Figure 2-6: Inserting Plug into Power Adapter

2. Insert the DC plug (5) located at the end of the power cord (4) of the power adapter

into the device's power socket located on the rear panel.

Quick Setup Guide 2. Installing the Hardware

BroadCloud SIP Trunk 9 AudioCodes Mediant BRI/PRI Gateway

Figure 2-7: Cabling to Power using Power Adapter

3. Plug the power adapter directly into a standard electrical wall outlet.

2.1.4 Powering the Device On / Off

The power switch is located on its rear panel (see Section 2.1.2).

To power on the device:



Press in the power button; the device receives power, indicated by the lighting of the

Power LED on the front panel.

To power off the device:



Press out the power button; the device powers off, indicated by the Power LED going

off.

BroadCloud SIP Trunk

AudioCodes Mediant BRI/PRI Gateway 10 Document #: LTRT-12393

2.2 Mediant 500 PRI Media Gateway

Figure 2-8: Front Panel - Ports

Table 2-5: Front Panel

Item # Label Description

1 POWER / STATUS LEDs indicating the status of the power and reboot/initialization.

2 // Reset pinhole button to reset and optionally to restore to factory defaults. To restore to

factory defaults: Press and hold down the pinhole button for at least 12 seconds, but no

longer than 25 seconds, with a paper clip or any other similar pointed object.

3 CONSOLE RJ-45 port for RS-232 serial communication

4 LAN Up to four Gigabit Ethernet (10/100/1000Base-T) ports to connect to LAN (IP phones,

computers, or switches). These ports support half- and full-duplex modes, auto-

negotiation, and straight or crossover cable detection.

5 PRI Single E1/T1 port interface (RJ-48).

6 USB Two USB 2.0 ports. Do not use.

Figure 2-9: Rear Panel – Earth and Power

Table 2-6: Rear Panel

Item # Label Description

Protective earthing screw.

2 I / 0 Power switch (Ois off; Iis on).

3 100-240V~50-60Hz 0.8A Max. Three-prong AC power supply entry.

2.2.1 Cabling

2.2.1.1 Grounding the Device

The device must be connected to earth (grounded) using an equipment-earthing conductor.

Autres manuels pour Mediant Series

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels AudioCodes Porte

AudioCodes

AudioCodes Mediant 800B Manuel utilisateur

AudioCodes

AudioCodes MediaPack MP-262 Manuel utilisateur

AudioCodes

AudioCodes E-SBC Manuel utilisateur

AudioCodes

AudioCodes Media Pack MP-124 Manuel utilisateur

AudioCodes

AudioCodes Mediant 800 MSBG Manuel utilisateur

AudioCodes

AudioCodes MediaPack MP-102 Manuel utilisateur

AudioCodes

AudioCodes Mediant 800B Manuel utilisateur

AudioCodes

AudioCodes MediaPack 124 Instructions de montage

AudioCodes

AudioCodes Mediant 600 Manuel utilisateur

AudioCodes

AudioCodes MediaPack MP-118 Manuel utilisateur

AudioCodes

AudioCodes Mediant 1000 Instructions de montage

AudioCodes

AudioCodes Mediant 2000 Manuel utilisateur

AudioCodes

AudioCodes Mediant 800 Manuel utilisateur

AudioCodes

AudioCodes MediaPack MP-112 Instructions de montage

AudioCodes

AudioCodes MEDIAPACK VERSION 6.2 Comment utiliser

AudioCodes

AudioCodes MediaPack MP-11x Series Manuel utilisateur

AudioCodes

AudioCodes Mediant 600 Manuel utilisateur

AudioCodes

AudioCodes MediaPack MP-124 Manuel utilisateur

AudioCodes

AudioCodes Mediapack mp-11x Manuel utilisateur

AudioCodes

AudioCodes Mediant 500 Manuel utilisateur

AudioCodes

AudioCodes Mediant 1000 Manuel utilisateur

AudioCodes

AudioCodes Mediant 2000 Manuel utilisateur

AudioCodes

AudioCodes Mediant 1000 Manuel utilisateur

AudioCodes

AudioCodes MediaPack 124 Manuel utilisateur

Manuels Porte populaires d'autres marques

LST

LST M500RFE-AS Manuel utilisateur

Kinnex

Kinnex Media Gateway Manuel utilisateur

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuel utilisateur

Telsey

Telsey CPVA 500 - SIP Manuel utilisateur

RTA

RTA 460A-NNA4 Fiche technique

Shaw

Shaw Gateway HDPVR Manuel utilisateur

ABB

ABB VSN900 Guide de démarrage rapide

Commander

Commander Pulse Manuel utilisateur

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuel utilisateur

NETGEAR

NETGEAR C6300BD Manuel utilisateur

Amit

Amit CDW531AM Manuel utilisateur

HMS

HMS Netbiter EasyConnect EC150 Manuel utilisateur

Huawei

Huawei EchoLife HG620 Manuel utilisateur

AT&T

AT&T U-verse 3801 Manuel d'utilisation et d'entretien

Logic IO

Logic IO RTCU MX2 turbo Manuel utilisateur

Suttle

Suttle MediaMAX MXM-521 Manuel utilisateur