Advantech PCM-3612I Manuel d'installation et d'exploitation

1 Startup Manual All product specifications are subject to change without notice.

STARTUP MANUAL

PCM-3612I

4-port RS-232/422/485 PCI-104 Module

The PCM-3612I is a PCI-104-compatible 4-port

RS-232/422/485 serial interface module. It works

with PCI-104 CPU modules or CPU cards which

accept PCI-104 expansion modules. It provides four

independent serial interfaces,accessed through the

IDE 40-pin connector(s). The module’s industry-

standard 16C550 asynchronous communication chip

is fully programmable. The module requires no

special commands or control codes if you use the

standard COM1~COM4(PCM-3612I) port address

We carefully inspected the PCM-3612I both

mechanically and electrically before we shipped it.

It should be free of marks and scratches and in per-

fect electrical order on receipt.

Handle the board only by its edges. The static

charge on your body may damage its integrated cir-

cuits. Keep the card in its anti-static package when-

ever it is not installed. You can use this package to

return the card if it should need repair.

• 4 independent RS-232/422/485 serial ports

• Transmission speeds up to 921.6 Kbps

• Supports Windows 7/8/10, and Linux

• LED indicators: TX, RX

• Compatible with standard PC ports:

COM1~COM4

• Automatic RS-485 data flow control

• Bus interface: PCI-104

• Number of ports: 4

• Data bits: 5, 6, 7, 8

• Stop bits: 1, 1.5, 2

• Parity: none, even, odd

• Speed (bps): 50 ~ 921.6K

• Connectors: One IDE 40-pin male

• Signals:

RS-232: TxD, RxD, RTS, CTS, DTR, DSR,

DCD, RI and GND

RS-422:TxD+,TxD-, RxD+, RxD-,GND,

CTS+, CTS-, RTS+ and RTS-

RS-485:Data+,Data- and GND

• Power requirements:

+3.3V@260 mA (Typical) +3.3V@530 mA

(Max.)

• Operating Temperature: -40~85°C(-40~185°F)

• Storage Temperature: -40~85°C(-40~185°F)

Card Configuration

The max configuration for the PCI bus of PCI-104

modules is FOUR plus the host board. If you stack

more than one PCI-104 module to a host board be

sure to set the modules to different PCI numbers

through SW1.

SW1 Settings

SW2 Settings

CN2-CN5 Impedance Selection

Introduction Specifications

Initial Inspection

Features

Notes

For more information on this and other Advantech

products, please visit our websites at:

http://www.advantech.com

http://www.advantech.com/eAutomation

For technical support and service:

http://www.advantech.com/support/

This startup manual is for PCM-3612I

Part No: 2003M61211 2nd Edition

May 2016

1 2 Expansion Board

OFF OFF 3

OFF ON 2

ON OFF 1

ON ON 0 (default)

Switch Position Mode

ON RS-422_Master

OFF RS-422_Slave/RS-485

CH1 CH2 CH3 CH4

CN2 CN3 CN4 CN5

2 Startup Manual

CN7-CN10 RS-232/422/485 Model Select

Hardware Installation

Installing the Module on a CPU Card:

1. Turn the PC power off. Turn the power off to any

peripheral devices such as printers and monitors.

2. Disconnect the power cord and any other cables from

the back of the computer.

3. Remove the system unit cover

4. Remove the CPU card from the chassis (if necessary)

to gain access to the card’s PCI-104 connector.

5. Screw the brass spacer (included with the module)

into the threaded hole on the CPU card. Do not

tighten too much, or the threads may be damaged.

6. Carefully align the pins of the PCM-3612I with the

PCI-104 connector. Slide the module into the con-

nector, do not push too hard.

7. Secure the module to the CPU card to the threaded

hole in the CPU card using the included screw.

8. Attach any accessories to the PCM-3612I.

9. Reinstall the CPU card and replace the system unit

cover. Reconnect the cables you removed in step 2.

10. Turn the power on.

Connecting to Another PCI-104 Module:

1. Insert the pins of connector CN6 into the piggy-

back connector on the other PCI-104 module.

2. Screw the PCM-3612I to the brass spacer. This com-

pletes the hardware installation

Pin Assignments

The following table and figure shows pin assignments

for the DB9 connector.

Pin Assignment of Male DB9 on cable

CH1 CH2 CH3 CH4

CN7 CN8 CN9 CN10

Warning! Turn off PC whenever you install, remove connect

or disconnect cables to PCM-3612I

Pin RS-232 RS-422 RS-485

1 DCD Tx- Data-

2 RxD Tx+ Data+

3TxD Rx+ -

4DTR Rx- -

5 GND GND GND

6 DSR RTS- -

7RTS RTS+-

8CTS CTS+-

9RI CTS-+

12345

Table des matières

Autres manuels Advantech Unité de contrôle

Advantech

Advantech PCM-3614 Manuel utilisateur

Advantech

Advantech PCM-3614I Manuel d'installation et d'exploitation

Advantech

Advantech ASMB-BMC Manuel d'installation et d'exploitation

Advantech

Advantech WISE-1510 Manuel utilisateur

Advantech

Advantech MOS-2120-Z1101E Manuel utilisateur

Advantech

Advantech PCM-3526 Manuel d'installation et d'exploitation

Advantech

Advantech VEGA-330 Manuel d'installation et d'exploitation

Advantech

Advantech iDAQ-817 Manuel utilisateur

Advantech

Advantech SOM-5962 Manuel utilisateur

Advantech

Advantech WISE-2211 Manuel d'installation et d'exploitation

Advantech

Advantech Adam 4000 Series Manuel utilisateur

Advantech

Advantech B+B SmartWorx iMcV-Giga-MediaLinX TX/SFP Manuel utilisateur

Advantech

Advantech ROM-7510 Manuel utilisateur

Advantech

Advantech APAX-5202P Manuel utilisateur

Advantech

Advantech SOM 144 Mode d’emploi

Advantech

Advantech SOM-5897 Manuel utilisateur

Advantech

Advantech MOS-2110Z-1201E Manuel utilisateur

Advantech

Advantech PCM-2610B Manuel d'installation et d'exploitation

Advantech

Advantech IPMI-2000 Manuel d'installation et d'exploitation

Advantech

Advantech PCM-3524 Manuel utilisateur

Advantech

Advantech AIW-357 DK-G2U Manuel utilisateur

Advantech

Advantech B+B SmartWorx iMcV-LIM Manuel utilisateur

Advantech

Advantech PCM-3116 Manuel d'installation et d'exploitation

Advantech

Advantech Network Device USB-4761 Manuel d'installation et d'exploitation

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur