Ubiquiti Rocket M2 Titanium RM2-Ti Manuel utilisateur

Carrier Class

airMAX™BaseStation

Models: RM2-Ti, RM5-Ti

Introduction

Thank you for purchasing the Ubiquiti Networks™Rocket™M

Titanium. This Quick Start Guide is designed to guide you

through installation and show how to access the airOS™

Configuration Interface. This guide also includes the warranty

terms and is for use with the RocketM2 Titanium, model

RM2-Ti, and RocketM5 Titanium, model RM5-Ti.

Package Contents

RocketM Titanium Gigabit PoE Adapter

(48V, 0.5A)

Power Cord

Carrier Class

airMAX™BaseStation

Models: RM2-Ti, RM5-Ti

Metal Strap GPS Patch Antenna (RM5-Ti only) Quick Start Guide

Installation Requirements

• GPS antenna (RM5-Ti only) must have a clear line of sight

to the sky.

• Shielded Category 5 (or above) cabling should be used for

all wired Ethernet connections and should be grounded

through the AC ground of the PoE.

We recommend that you protect your networks from the

most brutal environments and devastating ESD attacks

with industrial-grade shielded Ethernet cable from Ubiquiti

Networks. For more details, visit

www.ubnt.com/toughcable

TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet

cable and earth grounding must be used as conditions of product warranty. TOUGHCable is

designed for outdoor installations. It is the customer’s responsibility to follow local country

regulations, including operation within legal frequency channels, output power, and Dynamic

Frequency Selection (DFS) requirements.

Hardware Overview

LED Panel

RP-SMA Connections

to Antenna

Port Cover

Main Ethernet Port

(10/100/1000 Mbps)

GPS SMA Connector

(RM5-Ti only)

Reset

Button

Secondary Ethernet Port

(10/100 Mbps)

LED Panel

Signal In airOS, you can modify the wireless

signal strength threshold values for each LED on

the Advanced tab under Signal LED Thresholds,

or you can configure the LEDs to display the GPS

connection quality instead (RM5-Ti only). The

default values are shown below:

LED will light green when the wireless

signal strength is above -65 dBm.

LED will light green when the wireless

signal strength is above -71 dBm.

LED will light green when the wireless

signal strength is above -77 dBm.

LED will light green when the wireless

signal strength is above -82 dBm.

LED will light green when the wireless

signal strength is above -88 dBm.

LED will light green when the wireless

signal strength is above -94 dBm.

GPS (RM5-Ti only) The GPS LED indicates

airSync™activity. Requires three or more satellite

connections.

Secondary Ethernet The secondary Ethernet

LED will light steady green when an active

Ethernet connection is made to the Secondary

Ethernet port and flash when there is activity.

Main Ethernet The main Ethernet LED will

light steady green when an active Ethernet

connection is made to the Main Ethernet port and

flash when there is activity.

Power The Power LED will light green when the

device is connected to a power source.

Hardware Installation

The RocketM Titanium is designed to mount directly onto

Ubiquiti airMAX™RocketDish™or Titanium Sector antennas.

Itcan also be mounted directly on a pole.

1. Press the release buttons on the sides of the Port Cover and

slide it off.

Port Cover

2. Connect an Ethernet cable to the Main Ethernet port.

3. (RM5-Ti only) Connect the GPS Patch Antenna to the GPS

SMA Connector.

4. Replace the Port Cover.

5. Connect the RF cables to the RP-SMA Connectors located on

top of the RocketM Titanium.

6. Attach the RocketM Titanium to an antenna. Align the

mounting tabs on the back of the RocketM Titanium

with the mounting bracket on the antenna. Slide the

RocketM Titanium down until it locks into place. (If you

are mounting the RocketM Titanium on a pole, refer to the

Pole-Mounting section.)

Mounting on a Dish Antenna Mounting on a Sector Antenna

7. Attach the RF cables from the RocketM Titanium to the

connectors on the antenna.

Connecting to a Dish Antenna Connecting to a Sector Antenna

8. Attach the Protective Shroud.

a. Align the arrow on the

top of the shroud with

the short hash mark on

the Dish Antenna.

b. Rotate the shroud

clockwise until it aligns

with the long hash mark

to lock it into place.

a. Slide the shroud down

over the Rocket until it

locks into place on the

Sector Antenna.

9. (RM5-Ti only) Place the magnetic GPS Patch Antenna on the

upper pole-mounting bracket.

Placement on a Dish Antenna Placement on a Sector Antenna

Pole-Mounting

To mount the RocketM Titanium on a pole, use the included

Metal Strap and perform the following steps:

1. Open the Metal Strap by turning the screw

counter-clockwise. You can loosen it by hand or use a

flathead screwdriver.

2. Straighten out the end of the Metal Strap and slide it

through the back of the RocketM Titanium.

3. Wrap the Metal Strap around the pole. To tighten the strap,

turn the screw clockwise using a flathead screwdriver.

Ce manuel convient aux modèles suivants

1

Table des matières

Autres manuels Ubiquiti Point d'accès sans fil

Ubiquiti

Ubiquiti airFiber AF-11 Manuel utilisateur

Ubiquiti

Ubiquiti LiteBeam LBE-5AC-LR Manuel utilisateur

Ubiquiti

Ubiquiti NBE--2AC--13 Manuel utilisateur

Ubiquiti

Ubiquiti UAP-AC-HD Manuel utilisateur

Ubiquiti

Ubiquiti UniFi Dream Machine Manuel utilisateur

Ubiquiti

Ubiquiti UniFi UAP-AC-PRO Manuel utilisateur

Ubiquiti

Ubiquiti NBE-M5-16 Manuel utilisateur

Ubiquiti

Ubiquiti AirFiber X AF-5G34-S45 Manuel utilisateur

Ubiquiti

Ubiquiti UniFi Enterprise AP Manuel utilisateur

Ubiquiti

Ubiquiti Rocket 5AC-Lite Manuel utilisateur

Ubiquiti

Ubiquiti UniFi Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam M Manuel utilisateur

Ubiquiti

Ubiquiti UBB Manuel utilisateur

Ubiquiti

Ubiquiti UniFi UAP-IW-HD Manuel utilisateur

Ubiquiti

Ubiquiti airFiber AF 60 Manuel utilisateur

Ubiquiti

Ubiquiti NanoStationM Series Manuel utilisateur

Ubiquiti

Ubiquiti UAP-PRO Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation loco Manuel utilisateur

Ubiquiti

Ubiquiti UAP-AC-PRO Manuel utilisateur

Ubiquiti

Ubiquiti NanoBridge M5 Manuel utilisateur

Ubiquiti

Ubiquiti Rocket R5AC-Lite Manuel utilisateur

Ubiquiti

Ubiquiti LiteBeam LBE-5AC-16-120 Manuel utilisateur

Ubiquiti

Ubiquiti M5 GPS Rocket M Series Manuel utilisateur

Ubiquiti

Ubiquiti GBE Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur

Draytek

Draytek VIGORAP 902 Manuel utilisateur

EnGenius

EnGenius EAP350 Manuel utilisateur