Ubiquiti AirCube ACB-AC Manuel utilisateur

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

1/8

airCube AC Access Point Power Adapter

24V PoE In Port

Package Contents

Hardware Overview

ACB-AC Quick Start Guide

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

2/8

Ports 2-3

WAN Port

Power Port

LED

Reset Button

This Gigabit Ethernet port is available to connect a 10/100/1000 Mbps device to

the internet. It also accepts 24V PoE input and can be used to power the

airCube.

These Gigabit Ethernet ports are available to connect 10/100/1000 Mbps

devices to the internet.

This Gigabit Ethernet port connects to and powers a 24V PoE airMAX device.

The Power Adapter connects to this port.

The LED lights up when the airCube is powered on.

Resets to factory defaults. The device should be running after bootup is

complete. Press and hold the Reset button for about 10 seconds until the LED

starts flashing and then becomes solidly lit. After a few seconds, the LED will

turn off, and the device will automatically reboot.

Hardware Installation

ACB-AC Quick Start Guide

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

3/8

Web UI Configuration

To configure the airCube using a web interface:

1. Launch your web browser and go to: https://192.168.1.1

NOTE: The device used to configure the airCube must be on the same

network as the airCube itself.

2. Enter ubnt for the Username, and type in the QR code password for the

Password. Then click Login.

ACB-AC Quick Start Guide

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

4/8

NOTE: The QR code password can be found on the bottom of the

airCube. It is labeled PSWD.

3. Follow the on-screen instructions.

Specifications

ACB-AC

Dimensions 87.80 x 89.50 x 89.25 mm

(3.46 x 3.52 x 3.51")

Weight 280 g (9.88 oz)

Management Interface Wi-Fi / Ethernet

Networking Interface (4) Gigabit Ethernet Ports

LED Status

Operating Frequency 2.4 GHz

5 GHz

Antenna Gain

2.4 GHz 4 dBi

5 GHz 5 dBi

Max. Speeds

2.4 GHz 300 Mbps

5 GHz 866.7 Mbps

Max. Power Consumption 8.5W

Max. TX Power 22 dBm

Power Supply 24VDC

Power Method 24VDC, 0.83A

PoE 24V In on Ethernet Port 1

PoE Out Controllable 24V PoE Out (4, 5+, 7, 8-) on WAN Port

Supported Voltage Range 22-26V

Operating Temperature -10 to 50° C

(-14 to 122° F)

Operating Humidity 5 to 95% Noncondensing

ESD/EMP Protection ± 24 kV Contact / Air

Certifications CE, FCC, IC

Safety Notices

1. Read, follow, and keep these instructions.

2. Heed all warnings.

3. Only use attachments/accessories specified by the manufacturer.

ACB-AC Quick Start Guide

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

5/8

WARNING: Do not use this product in location that can be submerged by water.

WARNING: Avoid using this product during an electrical storm. There may be a

remote risk of electric shock from lightning.

Electrical Safety Information

1. Compliance is required with respect to voltage, frequency, and current requirements

indicated on the manufacturer’s label. Connection to a different power source than those

specified may result in improper operation, damage to the equipment or pose a fire hazard if

the limitations are not followed.

2. There are no operator serviceable parts inside this equipment. Service should be provided

only by a qualified service technician.

3. This equipment is provided with a detachable power cord which has an integral safety

ground wire intended for connection to a grounded safety outlet.

a. Do not substitute the power cord with one that is not the provided approved type. Never

use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the

grounding wire.

b. The equipment requires the use of the ground wire as a part of the safety certification,

modification or misuse can provide a shock hazard that can result in serious injury or

death.

c. Contact a qualified electrician or the manufacturer if there are questions about the

installation prior to connecting the equipment.

d. Protective earthing is provided by Listed AC adapter. Building installation shall provide

appropriate short-circuit backup protection.

e. Protective bonding must be installed in accordance with local national wiring rules and

regulations.

Limited Warranty

ui.com/support/warranty

The limited warranty requires the use of arbitration to resolve disputes on an individual basis,

and, where applicable, specify arbitration instead of jury trials or class actions.

Compliance

FCC

Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions.

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

ACB-AC Quick Start Guide

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

6/8

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

The device has been approved by the FCC under FCC ID: SWX-ACBAC.

ISED Canada

CAN ICES-3(B)/NMB-3(B)

This device complies with ISED Canada licence-exempt RSS standard(s). Operation is

subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may cause undesired

operation of the device.

The device has been approved by ISED Canada under IC: 6545A-ACBAC.

The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the

potential for harmful interference to co-channel mobile satellite systems.

CAN ICES-3(B)/NMB-3(B)

Le présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1. l’appareil ne doit pas produire de brouillage;

2. l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

L’appareil ont été approuvés par ISDE Canada en vertu IC: 6545A-ACBAC.

Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une

utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de

satellites mobiles utilisant les mêmes canaux.

IMPORTANT NOTE:

Radiation Exposure Statement:

This equipment complies with radiation exposure limits set forth for an uncontrolled

environment.

This equipment should be installed and operated with minimum distance 20 cm between the

radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

ACB-AC Quick Start Guide

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

7/8

AVIS IMPORTANT :

Déclaration sur l’exposition aux rayonnements :

Cet équipement est conforme aux limites prévues pour l’exposition aux rayonnements dans

un environnement non contrôlé.

Lors de l’installation et de la mise en fonctionnement de l’équipement, assurez-vous qu’il y

ait une distance minimale de 20 cm entre l’élément rayonnant et vous.

Cet émetteur ne doit être installé à proximité d’aucune autre antenne ni d’aucun autre

émetteur, et ne doit être utilisé conjointement à aucun autre de ces appareils.

Australia and New Zealand

Brazil

Nota: Este equipamento não tem direito à proteção contra interferência prejudicial e

não pode causar interferência em sistemas devidamente autorizados.

CE Marking

CE marking on this product represents the product is in compliance with all directives that are

applicable to it.

Country List

AT BE BG CY CZ DE DK EE EL ES FI FR HR HU

IE IT LV LT LU MT NL PL PT RO SE SI SK UK

BFWA (Broadband Fixed Wireless Access) members noted in blue

Note: This device meets Max. TX power limit per ETSI regulations.

The following apply to products that operate in the 5 GHz frequency range:

Note: This device is restricted to indoor use only when operating in the 5150 - 5350

MHz frequency range within all member states.

Note: All countries listed may operate at 30 dBm. BFWA member states may operate

at 36 dBm.

Note: Operation in the 5.8 GHz frequency band is prohibited in BFWA member states.

Other countries listed may use the 5.8 GHz frequency band.

ACB-AC Quick Start Guide

24/10/2022, 12:04

ACB-AC Quick Start Guide

https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html

8/8

WEEE Compliance Statement

Declaration of Conformity

Online Resources

ACB-AC Quick Start Guide

Autres manuels pour AirCube ACB-AC

Table des matières

Autres manuels Ubiquiti Point d'accès sans fil

Ubiquiti

Ubiquiti NanoBeam 5AC Gen2 Manuel utilisateur

Ubiquiti

Ubiquiti Loco5AC Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation M Series Manuel utilisateur

Ubiquiti

Ubiquiti UAP-AC-M-PRO Manuel utilisateur

Ubiquiti

Ubiquiti UAP-Outdoor-5 Manuel utilisateur

Ubiquiti

Ubiquiti UBB Manuel utilisateur

Ubiquiti

Ubiquiti R5AC-PTP Manuel utilisateur

Ubiquiti

Ubiquiti UniFi UAP-AC-LR-5-EU Manuel utilisateur

Ubiquiti

Ubiquiti Rocket 5AC-Lite Manuel utilisateur

Ubiquiti

Ubiquiti UniFi UAP-AC-LITE Manuel utilisateur

Ubiquiti

Ubiquiti UAP-AC-PRO Manuel utilisateur

Ubiquiti

Ubiquiti UniFi AC SHD Manuel utilisateur

Ubiquiti

Ubiquiti UniFi nanoHD UAP-nanoHD Manuel utilisateur

Ubiquiti

Ubiquiti UAP-AC-M Manuel utilisateur

Ubiquiti

Ubiquiti UniFi Dream Machine Beacon Manuel utilisateur

Ubiquiti

Ubiquiti UAP Manuel utilisateur

Ubiquiti

Ubiquiti UniFi AP FlexHD Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam M Manuel utilisateur

Ubiquiti

Ubiquiti Rocket2AC Prism Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam m5 iso PBE-M5-300-ISO Manuel utilisateur

Ubiquiti

Ubiquiti M2 GPS Rocket M Series Manuel utilisateur

Ubiquiti

Ubiquiti UniFi Wifi BaseStationXG Manuel utilisateur

Ubiquiti

Ubiquiti U-Installer Manuel utilisateur

Ubiquiti

Ubiquiti LTU-Lite Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur

Draytek

Draytek VIGORAP 902 Manuel utilisateur

EnGenius

EnGenius EAP350 Manuel utilisateur