Siemens Modem Block Manuel utilisateur

INTRODUCTION The SIEMENS Modem Block module is a component of the HUB-4 assembly. Each

Modem Block module provides 1 independent data channel.The HUB-4 can support

up to 4 independent data channels.The Modem Block module mounts on the HUB-4,

COM-2 board, which in turn mounts on the HUB -4 Main-2 board. Refer to the table

below to determine the required modules for the desired configuration.

TABLE 1

HUB-4 CONFIGURATION

Number of

Channels Required Modules

1 1 HUB-4 Main-2, 1 HUB-4 COM-2, 1 Modem Block

2 1 HUB-4 Main-2, 1 HUB-4 COM-2, 2 Modem Blocks

3 1 HUB-4 Main-2, 2 HUB-4 COM-2, 3 Modem Blocks

4 1 HUB-4 Main-2, 2 HUB-4 COM-2, 4 Modem Blocks

PRE-INSTALLATION The Modem Block module has three configuration jumpers: JP1, JP2, and JP3. Refer

to Figure 1 for the location of the jumpers. Set the jumpers to the configuration

shown in Table 2.

NOTE:

"ON" IS WHEN THE JUMPER

IS IN THE PROPER POSITION

OVER PLUGS JP1, JP2, OR JP3.

JP2 JP3

JP1

MODEM BLOCK

Figure 1

Module Block Module

Installation Instructions

Model Modem Block

Modem Block Module For HUB-4

Siemens Building Technologies

Fire Safety

P/N 315-099356-2

TABLE 2

MODEM BLOCK

JUMPER SETTINGS

JP1 ON

JP2 OFF

JP3 OFF

INSTALLATION

Disconnect BATTERY and AC prior to working on equipment.

Mounting Each Modem Block module mounts to a HUB-4, COM-2 with the 3 nylon spacers, 3

nylon screws, and 3 nylon washers provided. One HUB-4, COM-2 board can accom-

modate up to 2 Modem Block modules.

1. To begin mounting a Modem Block module on a HUB-4, COM-2 board,

place the screw end of the 3 spacers through the holes in the top of the

COM-2 board. (Refer to Figure 2.)

2. Secure the spacers in place on the underside of the HUB-4, COM-2 with

the 3 nylon nuts.

3. DO NOT place the Modem Block module on the HUB-4, COM-2 board at

this time. Reserve the 3 nylon screws provided.

4. Refer to the HUB -4 Installation Instructions, P/N 315-099458, to complete

the installation.

HOLES FOR

MOUNTING

NYLON SPACERS

HOLES FOR

MOUNTING

NYLON SPACERS

PLACE SCREW

END OF SPACER

THROUGH HOLE

IN HUB-4, COM-2

2X10PIN

RECEPTACLE

2X10PIN

RECEPTACLE

MOUNTS ONE

MODEM BLOCK

MODULE

MOUNTS ONE

MODEM BLOCK

MODULE

HUB-4,

COM-2

Figure 2

Placing Nylon Spacers For Modem Block Module On HUB-4, COM-2 Board

Siemens Building Technologies, Inc.

8 Fernwood Road

Florham Park, New Jersey 07932

Siemens Building Technologies, Ltd.

2 Kenview Boulevard

Brampton, Ontario L6T 5E4 CN P/N 315-099356-2

Table des matières

Autres manuels Siemens Unité de contrôle

Siemens

Siemens MICROMASTER 420 Manuel utilisateur

Siemens

Siemens SIMOVERT Masterdrives SSB Manuel utilisateur

Siemens

Siemens 3KC ATC3100 Manuel utilisateur

Siemens

Siemens MVS661 N Series Manuel utilisateur

Siemens

Siemens HZM Manuel utilisateur

Siemens

Siemens V P45 Series Manuel utilisateur

Siemens

Siemens SINAMICS CONNECT 500 Manuel utilisateur

Siemens

Siemens Simatic S7-1500 Document technique

Siemens

Siemens SIMATIC TI525 Manuel utilisateur

Siemens

Siemens SIMATIC ET 200S Manuel utilisateur

Siemens

Siemens SIMATIC Manuel utilisateur

Siemens

Siemens SIPROTEC4 7SJ61 Manuel utilisateur

Siemens

Siemens SENTRON 7KM PAC 4DI/2DO Manuel utilisateur

Siemens

Siemens SIMATIC ET 200SP Manuel utilisateur

Siemens

Siemens SINUMERIK 802D Guide d'installation

Siemens

Siemens SINAMICS S120 Manuel utilisateur

Siemens

Siemens SIPROTEC4 7SJ61 Manuel utilisateur

Siemens

Siemens OZW771 Manuel utilisateur

Siemens

Siemens SCALANCE W788C-2 Manuel utilisateur

Siemens

Siemens SIPLUS CMS2000 VIB-MUX Guide de l'administrateur

Siemens

Siemens EFB300 Manuel utilisateur

Siemens

Siemens VAI60.15-15 Manuel utilisateur

Siemens

Siemens SINAMICS G120 Manuel utilisateur

Siemens

Siemens AP 641 Manuel de service

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur