Quantum Quantum Fireball SE Manuel utilisateur

1 of 1

ATA

Jumper Settings

Rsvd

tand Alone ON

OFF

aster with Slave Present ON

OFF

lave to Master OFF

OFF

X = PK is a Parking position. The presence or absence of this jumper has no effect on the drive.

Labeling may indicate to place this jumper when configuring as a slave. This is to provide for

retention of the jumper in the event it is needed later.

Jumper Locations

The Fireball SE disk drive has only one location where user configurable jumpers are found. The

jumper block is incorporated into the IDE / ATA cable connector. Using the jumper pins you can

establish the drive Master/Slave configuration.

Fireball SE

Jumper Settings

Fireball SE

fireball_se_jumper.pdf

BIOS Settings

The following BIOS parameters are provided for customers needing to manually configure the Quantum disk drive.

Both base 2 and base 10 capacity values are displayed.

Cylinders

Heads

Sectors

Base 2 Capacity

ase 10 Capacity

.1 GB 4092

2,014 MB

2,111 MB

.2 GB 6256

3,079 MB

3,228 MB

.3 GB 14848

4,110 MB

4,310 MB

.4 GB 13328

6,149 MB

6,448 MB

.4 GB 16383

8,063 MB

8,455 MB

Special Considerations

Hard drives greater than 2.1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions

4.0 through 6.22 allow a maximum primary partition / logical drive size of 2.1GB and are limited to 8.4GB in

physical drive capacity. The file systems supported by Windows-95, Windows-98 and Windows NT are not restricted

to the 8.4GB physical drive limit, but special BIOS support is required.

SCSI

Jumper Settings

The following describes the jumper options and settings available on the Fireball SE drive. For more detail on

jumper definitions; please refer to the jumper definition section.

Termination Enable (TE)

nable termination T

E jumper on

isable termination T

E jumper off

SCSI ID (A2, A1, A0)

et drive SCSI ID S

ee ID settings table below

Park (PK)

sed for spare jumper N

Jumper Locations

The Fireball SE disk drive has only one location where user configurable jumpers are found. The jumper block for

the Fireball SE is found on the disk drive printed circuit board. Using these jumper pins you can establish the

various drive configuration options.

2 of 2

Fireball SE

fireball_se_jumper.pdf

3 of 3

The drawing above displays the jumper block physical location.

SCSI ID Settings

The following table identifies the various SCSI ID values and the jumper positions required to set them.

Drive ID

ID 0

OFF

ID 1

OFF

ID 2

OFF

ID 3

OFF

ID 4

OFF

ID 5

OFF

ID 6

OFF

ID 7

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Quantum Stockage

Quantum

Quantum DXi6900 Guide de démarrage rapide

Quantum

Quantum Scalar LTFS Manuel de la liste des pièces

Quantum

Quantum Internal Storage System Travan 40 GB Manuel utilisateur

Quantum

Quantum Scalar 100 Manuel utilisateur

Quantum

Quantum DAT 72 Manuel utilisateur

Quantum

Quantum QXS G2 Series Manuel d'utilisation

Quantum

Quantum DAT 160 Manuel utilisateur

Quantum

Quantum Scalar 1000 Mode d’emploi

Quantum

Quantum LTO 2U Feuille d'instructions

Quantum

Quantum ActiveScale P100E3 Instructions d'installation

Quantum

Quantum DXi9000 Manuel utilisateur

Quantum

Quantum DLT-V4 Manuel

Quantum

Quantum LTO-4 (Model B) Manuel utilisateur

Quantum

Quantum DXi V-Series Manuel utilisateur

Quantum

Quantum ATL M1500 Manuel utilisateur

Quantum

Quantum Fireball LCT20 Manuel utilisateur

Quantum

Quantum ValueLoader DLT VS80 Mode d'emploi

Quantum

Quantum ActiveScale X100 Manuel utilisateur

Quantum

Quantum Tape Drive SDLT 600A Manuel utilisateur

Quantum

Quantum DLT 2500 Manuel utilisateur

Quantum

Quantum DAT 72 Manuel utilisateur

Quantum

Quantum P3000 Series Manuel utilisateur

Quantum

Quantum DXi6701 Manuel de l'opérateur

Quantum

Quantum QX Series Manuel utilisateur

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

HP StorageWorks MSL2024 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

HP P9000 Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur