Quantum DLTtape DLT1 Manuel utilisateur

DLT™ TAPE UNIT INSTALLATION

HP® 9000 Series 700 System

HP-UX® 9.X

Installation

The system must have the appropriate SCSI interface for DLT drive to attach to, i.e., a SCSI single-ended

DLT drive can be attached only to a SCSI single-ended interface. The same is true for SCSI differential

attachment. The hardware attachment simply requires the DLT tape peripheral to be attached to the

interface while the system is powered down. After the DLT tape peripheral has been attached, you will

need to perform certain system operations that will allow DLT device system recognition.

Perform the installation as follows:

1. Shutdown the system and remove ac power from the system. Install the DLT tape

peripheral and connect it to its SCSI controller. Refer to the following manual for

switch and jumper settings and SCSI bus termination:

• DLT1/DLT7 Install and Operations Guide Set the DLT SCSI device address to an

unassigned ID.

1. Power up the system. During the power-up, the process allows you to stop the

sequence by pressing the ESC key. By doing so, you can verify drive attachment

by issuing a search for boot device selection. This will display all attached SCSI

devices including the DLT tape drive. The boot process can continue by selecting

the appropriate boot disk.

2. Log on as root and change directory to /dev/rmt

In the next step, you will create a set of device files that will allow DLT device access. These device files

allow certain DLT device modes of operation.

1. Enter the following commands:

mknod 1m c 54 0x201402

mknod 1mn c

54 0x201403

mknod 1c c 54 0x2014c2

mknod 1cn c 54 0x2014c3

The device files created are for an installed DLT device with a SCSI ID of 4 and are shown below along

with their corresponding operating characteristics:

1m - drive 1, rewind on close

1mn-d

rive 1, no rewind on close

1c - drive 1, compressed, rewind on close

1cn - drive 1, compressed, no rewind on close

Associating the device files to a DLT device with a SCSI ID other than

requires that the number "4" in the minor number of the

mknod command be changed to the new ID.

DLT Mini-Library Usage

The HP-UX operating system does not support SCSI-2 media changer device commands. Therefore, an

installed DLT7 mini-library can not be utilized in random access mode and can only be accessed in

sequential mode. Refer to the DLT1/DLT7 Install and Operations Guide for detailed description of these

access modes.

Autres manuels pour DLTtape DLT1

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Quantum Stockage

Quantum

Quantum DXi4601 Manuel utilisateur

Quantum

Quantum Lattus A10 Manuel utilisateur

Quantum

Quantum ATL PowerStor L200 Series Manuel utilisateur

Quantum

Quantum Scalar 218 Guide d'installation

Quantum

Quantum ValueLoader DLT VS80 Manuel utilisateur

Quantum

Quantum LTO 2U Feuille d'instructions

Quantum

Quantum DXi3500 Manuel utilisateur

Quantum

Quantum Scalar i6000 Manuel utilisateur

Quantum

Quantum SuperLoader DLT Manuel utilisateur

Quantum

Quantum DXi6902 Manuel de l'opérateur

Quantum

Quantum Scalar i500 Manuel utilisateur

Quantum

Quantum DLTtape DLT1 Manuel utilisateur

Quantum

Quantum QXS-448 Manuel utilisateur

Quantum

Quantum LTO 4 Manuel utilisateur

Quantum

Quantum FastStor 1 Manuel utilisateur

Quantum

Quantum DXi9000 Manuel utilisateur

Quantum

Quantum Scalar 50 Manuel utilisateur

Quantum

Quantum LTO 3 Manuel utilisateur

Quantum

Quantum P4000 Series Manuel utilisateur

Quantum

Quantum Scalar i40 Instructions d'utilisation et de sécurité

Quantum

Quantum Scalar i2000 Manuel utilisateur

Quantum

Quantum DLT 2500 Manuel utilisateur

Quantum

Quantum DXi2500-D Manuel utilisateur

Quantum

Quantum ATL M2500 Manuel utilisateur

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

HP StorageWorks MSL2024 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

HP P9000 Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur