and drink are stored, prepared, or consumed and must not be ingested. After handling
materials, wash hands with soap and cold water before consuming or preparing food.
Inhalation: Under normal operation, inhalation is not an expected route of entry.
Contact With Uncured Material: Employees should be alerted to clean and rinse off
any contacted surface promptly in order to prevent further contamination. Ensure a
convenient washroom location is provided with access to soap, water, and disposable
paper towels.
Handling Finished Parts: Finished (cured) parts can be handled or disposed of the
same as standard household plastic products. VisiJet parts are not recyclable. VisiJet
materials are not intended for, and cannot be used for medical implant or food or drink
handling applications.
Exposure Control: The 3D printer system has a variety of built-in engineering controls
which are designed to prevent operator exposure. Do not try to change or disable
these controls.
Appropriate hygienic practices should be followed, including washing with soap and
cold water before meals, breaks, smoking, applying cosmetics, using toilet facilities,
and after work.
Material Handling
Emergency
Chemtrec USA (800) 424-9300; Europe +1-703-527-3887
Packaging Inspection: VisiJet materials are supplied in bottles. These bottles are
packaged with cardboard packing material inside the shipping carton. Upon receipt of
material shipments, inspect cardboard carton exterior for signs of damage and
leakage. If leakage is observed, DO NOT open carton, contact 3D Systems Field
Service Engineer or 3D Systems authorized service personnel. If no leakage is
observed, store shipping carton until material is used.
Building: If uncured material is observed on the part or platform after build, this is an
abnormal condition, and is an indication the 3D printer system requires servicing by
3D Systems or an authorized servicing reseller. Assume any liquid or paste-like
material is build material. Do not directly touch uncured build material without
protective gloves and protective sleeves. Discontinue use of the 3D printer system,
pending service by a 3D Systems Technical Support Representative or your servicing
reseller.
