Motorola 2247-62-10NA - Netopia 2247-62 Wireless... Manuel utilisateur
User Manual
The Motorola Netopia®2247-N8
DSL Gateway
4-port Ethernet, 802.11b/g/n Wi-Fi
2
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS – POWER SUPPLY INSTALLATION.
Connect the power supply
cord to the power jack on the Motorola Gateway. Plug the power supply into an appropriate electrical outlet.
CAUTION:
Depending on the power supply provided with the product, either the direct plug-in power supply
blades, power supply cord plug or the appliance coupler serves as the mains power disconnect. It is impor-
tant that the direct plug-in power supply, socket-outlet or appliance coupler be located so it is readily acces-
sible.
(Sweden)
Apparaten skall anslutas till jordat uttag när den ansluts till ett nätverk
(Norway)
Apparatet må kun tilkoples jordet stikkontakt.
TELECOMMUNICATION INSTALLATION.
When using your telephone equipment, basic safety precautions
should always be followed to reduce the risk of fire, electric shock and injury to persons, including the follow-
ing:
• Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink or laundry
tub, in a wet basement or near a swimming pool.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electrical shock from lightning.
• Do not use the telephone to report a gas leak in the vicinity of the leak.
PRODUCT VENTILATION.
The Motorola Gateway is intended for use in a consumer's home. Ambient tem-
peratures around this product should not exceed 104°F (40°C). It should not be used in locations exposed
to outside heat radiation or trapping of its own heat. The product should have at least one inch of clearance
on all sides except the bottom when properly installed and should not be placed inside tightly enclosed
spaces unless proper ventilation is provided.
SAVE THESE INSTRUCTIONS
Motorola Part Number:
579442-001-00
Copyright © 2010 by Motorola, Inc.
All rights reserved. No part of this publication may be reproduced in any form or by any means or used to make any derivative
work (such as translation, transformation or adaptation) without written permission from Motorola, Inc. Motorola reserves the
right to revise this publication and to make changes in content from time to time without obligation on the part of Motorola to
provide notification of such revision or change. Motorola provides this guide without warranty of any kind, either implied or
expressed, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Motorola
may make improvements or changes in the product(s) described in this manual at any time. MOTOROLA and the Stylized M
Logo are registered in the US Patent & Trademark Office. Microsoft, Windows, Windows Me, and Windows NT are either
trademarks or registered trademarks of Microsoft Corporation in the U.S and/or other countries. Macintosh is a registered
trademark of Apple, Inc. Firefox is a registered trademark of the Mozilla Foundation. All other product or service names are the
property of their respective owners.
Safety Information
3
ENGLISH
Thank you for selecting the Motorola Netopia
®
2247-N8 DSL Gateway. This guide will help you
set up and configure your network.
Check your package contents. It should contain the items shown here:
If you don’t have everything, contact your supplier immediately.
Checklist
1
CD & User Manual
Motorola Gateway
Power Supply Telephone Cable Ethernet Cable
M
4
ENGLISH
1.
Decide on a location for the Gateway.
Put the Gateway near a power source, a DSL wall outlet, and in a location where air can
circulate freely around it.
2.
Power the Gateway.
Connect the power supply to the power jack on the back panel of the Gateway. Then,
plug the power supply into an electrical outlet. Turn on the Power switch.
The
Power
LED should light solid green.
3.
Insert the Motorola Netopia
®
CD into your CDROM drive.
The Motorola Netopia
®
Installa-
tion Guide Wizard automates
several tasks to get you up and
running easily. These tasks
include making the cable con-
nections and configuring the
Gateway. Run the Wizard on
every PC that will connect to
your network.
The Installation Guide Wizard
will start automatically and the
Welcome screen will appear to
step through the process. Fol-
low the on-screen instructions
to make all of your connections.
Connections
2
5
ENGLISH
When all of your connections are made, your network may look like this:
4.
Enable Wireless Protected Setup (WPS) on your Wi-Fi devices.
Adding wireless clients to your network is easier using Wireless Protected Setup (WPS).
Older, non-WPS clients can still be added to the network by configuring them the stan-
dard way with WPA-PSK.
Make sure your wireless clients are running. Press the WPS push-button to begin the
exchange, which may last up to two minutes.
Do not power off your Gateway during the exchange.
The Gateway will display a success message when the exchange has completed.
Note:
Not all client wireless devices support WPS. Refer to their documentation.
DC Power
Rear View
Ethernet
Ports
Power Switch
DSL Port
WPS
Pushbutton
6
ENGLISH
When all of your connections are made, the status LEDs on the front of your Motorola IAD
Gateway will light, according to the following diagram:
LED Behavior
Power
Green
when power is on.
Red
if device malfunctions; flashes
red
when updat-
ing embedded software.
Ethernet
1, 2, 3, 4
Solid
green
when connected. Flash
green
when there is activity on the LAN.
Wireless
Flashes
green
when there is activity on the wireless LAN.
Power
Ethernet 1, 2, 3, 4
Front View
Wireless
Internet
DSL
WPS USB
Activity
7
ENGLISH
WPS
Solid
green
when WPS is successful.
USB
Not currently used.
DSL
Flashes
green
when training. Solid
green
when trained.
Internet
Green
when device is connected. Flashes
green
for activity on WAN port.
Activity
Off
= The device is not powered or the broadband connection is not present;
Flashing green
= Inbound Internet activity seen from the broadband connec-
tion
LED Behavior
8
ENGLISH
You can access the configuration pages at any time as follows:
1.
Run a Web browser, such as Firefox, Safari, or Microsoft Internet Explorer, and
enter
http://192.168.1.254
in the URL Address text box.
Press Return.
(If your ISP’s Configuration Worksheet tells you to use an IP address other than
192.168.1.254 to log in, enter http://< ip-address>.)
2.
The browser displays the
Welcome
page.
• You can choose
Unrestricted LAN Access
.
Device Configuration
3
9
ENGLISH
If you choose Unrestricted LAN Access, any user connected to your network can access
and administer the Motorola Netopia
®
Gateway’s configuration pages.
Or,
• For security, you may create and enter an Administrative password for accessing the
Motorola Netopia
®
Gateway.
• The administrative User name is
admin
.
• The initial Password can be whatever you choose, from one to 32 characters long.
This user name and password are separate from the user name and password you might
use to access the Internet. You may change them later. You will be challenged for this
Admin username and password any time that you attempt to access the Motorola Neto-
pia
®
Gateway’s configuration pages.
If you have chosen to create an Administrative password, when you connect to your Gateway
as an Administrator, you enter “
admin
” as the UserName and the Password you just created.
10
ENGLISH
Record your subscriber information here for future reference:
Congratulations!
Your connection is up and running and you should be able to browse the Inter-
net by typing a URL address in your browser’s Address text box or by selecting any of your
favorite bookmarks.
Should you require additional information, the “FAQs” on page 14 of this Guide contain Fre-
quently Asked Questions (and Answers) and “Basic Troubleshooting” on page 16 gives Basic
Troubleshooting tips. The latest Administrator’s Handbook with advanced configuration instruc-
tions is also available on-line at:
http://broadband.motorola.com/consumers/support/default.asp?supportSection=blank
Required Information Your entries:
Your Telephone number:
Your ISP Username:
(example: joesurfer@serviceprovider.com)
Your ISP Password:
Service Provider support
contact information:
Support desk number -
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Motorola Porte
Motorola
Motorola VT2442 - VONAGE Manuel utilisateur
Motorola
Motorola RG2200 Manuel utilisateur
Motorola
Motorola SVG2500 SURFBOARD DIGITAL VOICE WIRELESS GATEWAY - annexe... Guide de démarrage rapide
Motorola
Motorola SURFboard SVG1501 Manuel utilisateur
Motorola
Motorola SURFboard SVG2500 Manuel utilisateur
Motorola
Motorola SURFboard SBG901 Manuel utilisateur
Motorola
Motorola Netopia 2247-N8 Manuel utilisateur
Motorola
Motorola SURFboard SVG2501 Manuel utilisateur
Motorola
Motorola Netopia 2247-62 Manuel utilisateur
Motorola
Motorola VT2442 - VONAGE Manuel utilisateur
Motorola
Motorola SURFboard SVG1501 Manuel utilisateur
Motorola
Motorola Netopia Manuel utilisateur
Motorola
Motorola SURFboard SBG900 Manuel utilisateur
Motorola
Motorola 0171486N11 Manuel utilisateur
Motorola
Motorola SURFboard SVG2501 Manuel utilisateur
Motorola
Motorola NETOPIA 2247/57-62 Manuel utilisateur
Motorola
Motorola RSGu3502 Manuel utilisateur
Motorola
Motorola EASY START KIT HMEZ1000 - CELL PHONE SET UP Manuel utilisateur
Motorola
Motorola Netopia 2200 Series Manuel utilisateur
Motorola
Motorola RSG2500 Manuel utilisateur
Manuels Porte populaires d'autres marques
LST
LST M500RFE-AS Manuel utilisateur
Kinnex
Kinnex Media Gateway Manuel utilisateur
2N Telekomunikace
2N Telekomunikace 2N StarGate Manuel utilisateur
Mitsubishi Heavy Industries
Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuel utilisateur
ZyXEL Communications
ZyXEL Communications ZYWALL2 ET 2WE Manuel utilisateur
Telsey
Telsey CPVA 500 - SIP Manuel utilisateur
