Milwaukee MW13 Manuel utilisateur

SPECIFICATIONS

Range 0.0 to 12.5 ppm

Resolution 0.1 ppm

Accuracy ±0.1 ppm ±5% of reading

@ 25 °C

Typical EMC Dev. ±0.1 ppm

Light Source Light Emitting Diode

@525nm

Light Detector Silicon Photocell

Method

Adaptation of the Standard

Methods for the Examination

of Water and Wastewater,

18th edition, DPD method. The

reaction between iodine and

the reagent causes a pink

tint in the sample.

Environment 0 to 50°C (32 to 122 °F)

max. 95% RH non-condensing

Battery Type 1 x 1.5V AAA

Auto-Shut O After 2 minutes of non-use

Dimensions 87.5 x 63.7 x 35.2 mm

(3.4 x 2.5 x 1.4”)

Weight 65 g (2.29 oz.)

OPTIONAL ACCESSORIES

Reagent Sets

MI527-25 Iodine powder reagent, 25 pcs.

Other Accessories

3000100 Glass cuvettes with caps (2 pcs.)

3000200 Tissue fow wiping cuvettes

(2pcs.)

3000300 1.5V AAA batteries (4 pcs.)

CERTIFICATION

Milwaukee Instruments conform to

the CE European Directives.

Disposal of Electrical & Electronic

Equipment. Do not treat this product

as household waste. Hand it over

to the appropriate collection point

for the recycling of electrical and

electronic equipment.

Disposal of waste batteries. This product

contains batteries. Do not dispose of them with

other household waste. Hand them over to the

appropriate collection point for recycling.

Please note: proper product and battery disposal

prevents potential negative consequences

for human health and the environment. For

detailed information, contact your local

household waste disposal service or go to

www.milwaukeeinstruments.com (USA & CAN)

or www.milwaukeeinst.com.

RECOMMENDATION

Before using this product, make sure it is entirely

suitable for your specific application and for the

environment in which it is used. Any modification

introduced by the user to the supplied equipment

may compromise the meter’s performance. For

your and the meter’s safety do not use or store

the meter in hazardous environment. To avoid

damage or burn, do not perform any measurement

in microwave ovens.

WARRANTY

This instrument is warranted against defects

in materials and manufacturing for a period of

2years from the date of purchase. This warranty

is limited to repair or free of charge replacement if

the instrument cannot be repaired. Damage due to

accidents, misuse, tampering or lack of prescribed

maintenance is not covered by warranty. If

service is required, contact your local Milwaukee

Instruments Technical Service. If the repair is not

covered by the warranty, you will be notified of

the charges incurred. When shipping any meter,

make sure it is properly packaged for complete

protection.

ISTMW13 07/20

USER MANUAL

SATISFACTION

GUARANTEED

milwaukeeinstruments.com (USA & CAN)

milwaukeeinst.com

MW13

Digital

Iodine

MiniPhotometer

PRELIMINARY EXAMINATION

Please examine this product carefully. Make

sure that the instrument is not damaged.

If any damage occured during shipment,

please notify your Dealer.

Each MW13 meter is supplied complete with:

yTwo Sample Cuvettes and Caps

ySix powder reagents for Iodine

y1 x 1.5V AAA Battery

yInstruction Manual

FUNCTIONAL DESCRIPTION

1. Dust cover

2. Cuvette with cap

3. Cuvette holder

4. Liquid Crystal Display

5. Button

OPERATION

yTurn the meter on by pressing the button.

After all the segments are displayed, “C.1”,

“Add” appears with “Press” blinking, the

meter is ready.

yFill the cuvette with 10 mL of unreacted

sample and replace the cap. Place the

cuvette into the meter and close the

meter’s cap.

yPress the button. When the display shows

“Add”, “C.2” with “Press” blinking the meter

is zeroed.

yRemove the cuvette, open it and add the

content of one packet of MI527-0 reagent.

Replace the cap and shake gently for

20 seconds until the powder is completely

dissolved. Replace the cuvette into the meter.

yWait for 2 minutes and 30 seconds and then

press the button or press and hold the button

until the timer is displayed on the LCD.

yThe instrument directly displays the

concentration of iodine in ppm. The meter

automatically turns o after 2minutes.

BATTERY REPLACEMENT

To save the battery, the instrument shuts

down after 2 minutes of non-use. One

fresh battery lasts for a minimum of 5000

measurements, depending on the light level.

When the battery capacity is under 10% “bAt”

appears on the LCD at start-up.

If the battery is empty and accurate

measurements can’t be taken any more, the

instrument shows “bAd” then ”bAt” each

for 1 second and turns o. To restart the

instrument, the battery must be replaced with

a fresh one.

Iodine

ppm

MW13

To replace the instrument’s battery, follow the

steps:

yTurn the instrument o by holding the

button until the meter shuts o.

yTurn the instrument upside down

and remove the battery cover with a

screwdriver.

yRemove the battery from its location and

replace it with a fresh one.

yInsert the battery cover and replace the

screw with a screwdriver.

Autres manuels Milwaukee Instrument de mesure

Milwaukee

Milwaukee MC310 Manuel utilisateur

Milwaukee

Milwaukee 2205-20 Manuel utilisateur

Milwaukee

Milwaukee MI 411 Manuel utilisateur

Milwaukee

Milwaukee LDM 30 Manuel utilisateur

Milwaukee

Milwaukee MW11 Manuel utilisateur

Milwaukee

Milwaukee MW14 Manuel utilisateur

Milwaukee

Milwaukee C65 Manuel utilisateur

Milwaukee

Milwaukee MW170 MAX Manuel utilisateur

Milwaukee

Milwaukee REDLITHIUM Manuel utilisateur

Milwaukee

Milwaukee pH 58 Manuel utilisateur

Milwaukee

Milwaukee M12 3PL Manuel utilisateur

Milwaukee

Milwaukee MW10 Manuel utilisateur

Milwaukee

Milwaukee Mi 190 Manuel utilisateur

Milwaukee

Milwaukee pH600 Manuel utilisateur

Milwaukee

Milwaukee REDLITHIUM Manuel utilisateur

Milwaukee

Milwaukee MW100 Manuel utilisateur

Milwaukee

Milwaukee MI 406 Manuel utilisateur

Milwaukee

Milwaukee 2270-20 Manuel utilisateur

Milwaukee

Milwaukee MW11 Manuel utilisateur

Milwaukee

Milwaukee CALIBRATION 2238-20 Manuel utilisateur

Milwaukee

Milwaukee MW13 Manuel utilisateur

Milwaukee

Milwaukee MW101 Manuel utilisateur

Milwaukee

Milwaukee Mi 180 Manuel utilisateur

Milwaukee

Milwaukee 2235-20 Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur