MikroTik RouterBOARD 433 Manuel utilisateur

See www.routerboard.com for more information. Contact support@mikrotik.com for support questions. 31-Jan-2012

RouterBOARD 433/433AH

Quick Setup Guide and Warranty Information

Assembling the Hardware

First use of the board:

1. Insert the MiniPCI cards;

2. Install the board in a case and connect antenna wires, if needed;

3. Connect other peripherals and cables;

4. Plug in power cable to turn on the board.

Powering

The board accepts powering from either the power jack or the LAN1

Ethernet port:

1. direct-input power jack J801 (5.5mm outside and 2mm inside

diameter, female, pin positive plug) accepts 10..28 V DC (overvoltage

protection starts at 30V).

2. LAN1 Ethernet port J601 accepts 10..28 V DC input (at the board;

higher voltage needed to compensate for power loss on long cables;

at least 18V suggested) from non-standard (passive) Power over

Ethernet injectors (no power over datalines).

The maximum output of the power supply available for extension cards is normally 16W.

Booting process

Initial connection has to be done via the Ethernet cable. Open 192.168.88.1 in your web browser, and choose

“Webfig” for browser based configuration or “Winbox” for a Windows utility with the same functions. Username

is admin and there is no password. In case IP connection is not available, Winbox can be used to connect to the

MAC address of the device. More information here: http://wiki.mikrotik.com/wiki/First_time_startup

In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button

of the device when starting it until the LED light turns off, and the device will start to look for Netinstall servers.

It is also possible to connect with the onboard RS232C serial port. The serial port is set by default to 115200bit/s,

8 data bits, 1 stop bit, no parity, flow control off.

Extension Slots and Ports

1. Three Ethernet ports, supporting automatic cross/straight cable correction (Auto MDI/X), so you can use

either straight or cross-over cables for connecting to other network devices. The first Ethernet port accepts

10..28V DC powering from a passive PoE injector. The other two Ethernet ports do not support PoE

powering.

2. Three MiniPCI Type IIIA/IIIB ports with 3.3V power signaling.

3. DB9 RS232C asynchronous serial port.

4. microSD card slot for storage expansion (only on RB433AH)

See www.routerboard.com for more information. Contact support@mikrotik.com for support questions. 31-Jan-2012

Buttons

RouterOS reset hole. While booting, and holding a metal object in this hole (so that it's metal sides short-

circuit) will cause RouterOS software to be reset to defaults

BIOS Loader backup button. Holding the button while booting will cause the backup bootloader to be

used.

Operating System Support

Currently tested operating system is MikroTik RouterOS (starting from version 3.4).

reproduced or transmitted in any form without prior written permission from the copyright holder.

RouterBOARD, RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and

registered trademarks appearing in this manual are the property of their respective holders.

Hardware. MikroTik warrants all RouterBOARD series equipment for the term of fifteen (15) months from the

shipping date to be free of defects in materials and workmanship under normal use and service, except in case of

damage caused by mechanical, electrical or other accidental or intended damages caused by improper use or due

to wind, rain, fire or other acts of nature.

To return failed units to MikroTik, you must perform the following RMA (Return Merchandise Authorization)

procedure. Follow the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA

process.

1. If you have purchased your product from a MikroTik Reseller, please contact the Reseller company

regarding all warranty and repair issues, the following instructions apply ONLY if you purchased your

equipment directly from MikroTik in Latvia.

2. We do not offer repairs for products that are not covered by warranty. Exceptions can be made for

RB1000, RB1100 and RB1200.

3. Out-of-warranty devices and devices not covered by warranty sent to Mikrotikls will be returned to the

sender at sender's cost.

RMA Instructions are located on our webpage here: http://rma.mikrotik.com

Manual. This manual is provided “as is” without a warranty of any kind, expressed or implied, including, but not

limited to, the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has

made every effort to ensure the accuracy of the contents of this manual, however, it is possible that it may

contain technical inaccuracies, typographical or other errors. No liability is assumed for any inaccuracy found in

this publication, nor for direct or indirect, incidental, consequential or other damages that may result from such

an inaccuracy, including, but not limited to, loss of data or profits. Please report any inaccuracies found to

su[email protected]om

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels MikroTik Routeur réseau

MikroTik

MikroTik RBLDFR&R11e-LTE6 Manuel utilisateur

MikroTik

MikroTik RouterBOARD 1100Hx2 Manuel utilisateur

MikroTik

MikroTik CCR2216-1G-12XS-2XQ Manuel utilisateur

MikroTik

MikroTik CCR2004-16G-2S+ Manuel utilisateur

MikroTik

MikroTik RouterBOARD 750 Series Manuel utilisateur

MikroTik

MikroTik RouterBOARD RB2011UAS-IN Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

MikroTik

MikroTik SXT 2 Manuel utilisateur

MikroTik

MikroTik RouterBoard 1200 Manuel utilisateur

MikroTik

MikroTik RouterBOARD CCR2004-1G-12S+2XS Manuel utilisateur

MikroTik

MikroTik RB912UAG-2HPnD Manuel utilisateur

MikroTik

MikroTik RouterBOARD 1100 Manuel utilisateur

MikroTik

MikroTik PWR-LINE AP Series Manuel utilisateur

MikroTik

MikroTik RB750UPr2 Manuel utilisateur

MikroTik

MikroTik RouterBOARD 2011U Series Manuel utilisateur

MikroTik

MikroTik RouterBOARD 493 Manuel utilisateur

MikroTik

MikroTik RB2011iL-IN Manuel

MikroTik

MikroTik RBM33G Feuille d'instructions

MikroTik

MikroTik RB2011-2HND Manuel utilisateur

MikroTik

MikroTik LHG 5 Manuel utilisateur

MikroTik

MikroTik DynaDish 5 Manuel utilisateur

MikroTik

MikroTik RB2011 Series Manuel utilisateur

MikroTik

MikroTik RouterBOARD 711GA-5HnD Manuel utilisateur

MikroTik

MikroTik 711UA-2HnD Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité

LevelOne

LevelOne FBR-1416 Manuel utilisateur