La Crosse Technology WS-9021U Manuel utilisateur

Contents

Language Page

_______________________________________________________________

English

French

Spanish

TABLE OF CONTENTS

Topic Page

INVENTORY OF CONTENTS

QUICK SETUP

DETAILED SETUP GUIDE

BATTERY INSTALLATION

12 OR 24 HOUR TIME DISPLAY

TIME SETTING

FEATURES

MIN AND MAX TEMPERATURE

RESETTING MIN & MAX TEMPERATURE

ADDING ADDITIONAL THERMO-HYGRO SENSORS

VIEWING & OPERATING WITH MULTIPLE THERMO-HYGRO

SENSORS

MOUNTING

TROBLESHOOTING

MAINTENANCE AND CARE

SPECIFICATION

WARRANTY INFORMATION

This product offers:

NSTANT TRANSMISSIO

is the state-of-the-art

new wireless transmission technology,

exclusively designed and developed by LA

CROSSE TECHNOLOGY. INSTANT

TRANSMISSION offers you an immediate update

(every 4 seconds!) of all your outdoor data

measured from the sensors: follow your climatic

variations in real-time!

FIGURE 1 Low Battery

Indicator Max icon

12 or 24 Hou

Time Display

Set/Channel

Button Minimum/Maximum

& Plus Button

Outdoor

Temperature

(°F or °C)

Sensor signal

reception icon

Figure 2

INVENTORY OF CONTENTS

1. Wireless Temperature Station (Figure 1)

2. Wireless Temperature Sensor (TX29) and mounting bracket. (Figure 2)

3. 3 each, 1/2” Philips screws.

4. One strip of double sided adhesive tape.

5. Instruction Manual and Warranty Card.

ADDITIONAL EQUIPMENT (not included)

1. 1 Philips screwdriver.

2. 4 Fresh “AA” 1.5VAlkaline Batteries.

QUICK SETUP

Hint: Use good quality Alkaline Batteries; avoid rechargeable batteries.

1. Have the Wireless Temperature Station and temperature sensor 3 to 5 feet

apart.

2. Batteries should be out of both units for 5 minutes.

3. Place the batteries into the Temperature sensor first and next into the

Wireless Temperature Station.

4. DO NOT PRESS ANY BUTTONS FOR 5 MINUTES.

In this time the Wireless Temperature Station and the temperature sensor will begin

to communicate with each other, and the display will show both the indoor

temperature and an outdoor temperature. If the Wireless Temperature Station does

not display both temperatures after the 5 minutes, please retry the set up as stated

above. After both indoor and outdoor temperatures are displayed for 5 minutes you

can place your temperature sensor outdoors, and set your time.

The temperature sensor should be placed in a dry, shaded area (ex: under the eve

of a roof). The temperature sensor has a range of 330 feet. Any walls that the

signal will have to pass through will reduce distance. An outdoor wall or window will

have up to 20 feet of resistance and an interior wall will have up to 10 feet of

resistance. Your distance plus resistance should not exceed 330 feet in a straight

line.

NOTE: Fog and mist will not harm your temperature sensor, but direct rain must be

avoided.

DETAILED SETUP GUIDE

BATTERY INSTALLATION - When one Temperature sensor is being used

1. First, insert the batteries to the Temperature sensor (see “Temperature

sensor” below).

2. Within 2 minutes of powering up the sensor, insert the batteries to the

Temperature Station (see “Wireless Temperature station” below). Once the

batteries are in place, all segments of the LCD will light up briefly. Following

the indoor temperature and the time as 12:00 will be displayed. If they are

not shown in LCD after 60 seconds, remove the batteries and wait for at least

60 seconds before reinserting them. Once the indoor data is displayed user

may proceed to the next step.

3. After the batteries are inserted, the Temperature Station will start receiving

data signal from the sensor. The outdoor temperature should then be

displayed on the Temperature Station. If this does not happen after 2

minutes, the batteries will need to be removed from both units and reset from

step 1 and the signal reception icon is no longer shown.

TEMPERATURE SENSOR

1. Remove the Battery Cover.

2. Observing the correct polarity, install 2 “AA”

Alkaline Batteries—make sure they do not spring

free, or start-up problems may occur.

3. Replace the Battery Cover.

WIRELESS TEMPERATURE STATION

Note: After the batteries are installed, DO NOT press any buttons. This may

interfere with the signals, causing temperatures to register incorrectly.

1. Remove the Battery Cover on

the back of the Wireless

Temperature Station.

2. Observing the correct polarity,

install 2 “AA” Alkaline

Batteries.

3. Replace Battery Cover.

Batter

compartment

Battery cover

Sensor signal

reception icon*

•*When the signal is successfully received by the Temperature Station, the

icon will be switched on. (If not successful, the icon will not be shown in LCD)

So the user can easily see whether the last reception was successful (icon

on) or not (icon off). On the other hand, the short blinking of the icon shows

that a reception is currently taking place.

•If the signal reception is not successful on the first frequency (915MHz) for

45 seconds, the frequency is changed to 920MHz and the learning is tried

another 45 seconds. If still not successful the reception is tried for 45

seconds on 910MHz. This will also be done for re-synchronization.

SELECTING 12 OR 24 HOUR TIME DISPLAY

1. Press and hold the set/ch button for about 5 seconds.

2. “12h” will begin to flash in the TIME section of the LCD

3. Press the min/max/+ button to toggle between “12h” and “24h” time.

Note:

•Selecting 12 hour time will automatically select °F as your temperature unit.

•Selecting 24 hour time will automatically select °C as your temperature unit.

4. Press and release the set/ch button again to enter Time Setting.

Table des matières

Autres manuels La Crosse Technology Station météorologique

La Crosse Technology

La Crosse Technology WS6283 Manuel d'installation et d'exploitation

La Crosse Technology

La Crosse Technology 308-146v2 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-9121U-IT Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-9013U Manuel utilisateur

La Crosse Technology

La Crosse Technology 724-2310 Manuel d'utilisation et d'entretien

La Crosse Technology

La Crosse Technology 308-2316 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-8015TWC Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-3610-CH Manuel utilisateur

La Crosse Technology

La Crosse Technology C86371 Manuel utilisateur

La Crosse Technology

La Crosse Technology TX25U Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-3502 Manuel utilisateur

La Crosse Technology

La Crosse Technology 308-146 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS7059 Manuel utilisateur

La Crosse Technology

La Crosse Technology 724-1415BLv2 Manuel utilisateur

La Crosse Technology

La Crosse Technology C79790-11 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-2811U-IT Manuel utilisateur

La Crosse Technology

La Crosse Technology S74177 Manuel utilisateur

La Crosse Technology

La Crosse Technology 308-1414 Manuel utilisateur

La Crosse Technology

La Crosse Technology C85845V5 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-9115 Manuel utilisateur

La Crosse Technology

La Crosse Technology WD-2511U Guide d'installation

La Crosse Technology

La Crosse Technology WA-1030U Manuel utilisateur

La Crosse Technology

La Crosse Technology C79790V2-BBQ1 Guide d'installation

La Crosse Technology

La Crosse Technology WS-9630U-IT-CA Manuel utilisateur

Manuels Station météorologique populaires d'autres marques

Auriol

Auriol AHFL 433 A1 Manuel utilisateur

NexSens

NexSens G2-HYDROMET Manuel utilisateur

Hyundai

Hyundai WS 2202 Manuel utilisateur

IROX

IROX HBVR761 UV-X Manuel utilisateur

ADE

ADE WS 1711 Manuel utilisateur

Auriol

Auriol z29592 Manuel utilisateur

Auriol

Auriol 296289 Manuel utilisateur

Hyundai

Hyundai WS 2266 Manuel utilisateur

Ventus

Ventus W177 Manuel utilisateur

National Geographic

National Geographic VA Colour RC Manuel utilisateur

Renkforce

Renkforce 1208067 Manuel utilisateur

Levenhuk

Levenhuk Discovery Report WA40 Manuel utilisateur

Instant Transmission

Instant Transmission MA 10410 Manuel utilisateur

Lutron Electronics

Lutron Electronics PHB-318 Manuel utilisateur

WAREMA

WAREMA EWFS Weather station eco Manuel utilisateur

TFA

TFA 30.3013.IT Manuel utilisateur

Alecto

Alecto WS-1200 Manuel utilisateur

Oregon Scientific

Oregon Scientific RMR966PA Manuel utilisateur