Intel NUC7CJYHN Manuel utilisateur

User Guide for NUC7CJYHN, NUC7PJYHN

Intel® NUC Kit NUC7CJYHN

Intel® NUC Kit NUC7PJYHN

User Guide

User Guide for NUC7CJYHN, NUC7PJYHN

Before You Begin

CAUTIONS

The procedures in this user guide assume familiarity with the general terminology associated with

personal computers and with the safety practices and regulatory compliance required for using

and modifying electronic equipment.

Disconnect the computer from its power source and from any telecommunications link or network before

performing any of the procedures described in this guide. Failure to disconnect power,

telecommunications links, or networks before you open the computer or perform any procedures can

result in personal injury or equipment damage. Some circuitry on the board can continue to operate

even though the front panel power button is off.

Follow these guidelines before you begin:

 Always follow the steps in each procedure in the correct order.

 Set up a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

 Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam

pad. If such a station is not available, you can provide some ESD protection by wearing an

antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation

instructions.

To avoid injury, be careful of:

 Sharp pins on connectors

 Sharp pins on circuit boards

 Rough edges and sharp corners on the chassis

 Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

 Damage to wires that could cause a short circuit

Observe all warnings and cautions that instruct you to refer computer servicing to qualified

technical personnel.

Observe Safety and Regulatory Requirements

If you do not follow these instructions, you increase your safety risk and the possibility of

noncompliance with regional laws and regulations.

User Guide for NUC7CJYHN, NUC7PJYHN

This guide tells you how to:

•

Install and remove memory

•

Install a 2.5” drive

•

Install a VESA mount bracket

•

Connect power

•

Install an operating system

•

Install the latest device drivers and software

Open the Intel NUC Chassis

To open the Intel NUC chassis, follow these steps:

1. With a screwdriver unscrew the four corner screws on the bottom cover of the chassis and lift the

cover.

Installing and Removing Memory

Intel NUC Kits NUC7CJYHN and NUC7PJYHN have two 260-pin DDR4 SO-DIMM sockets. Be sure to

select memory modules that meet these requirements:

 1.2V low voltage memory

 2400 MHz SO-DIMMs

 Non-ECC

Find compatible memory modules in the Intel® Product Compatibility Tool:

 NUC7CJYHN

 NUC7PJYHN

User Guide for NUC7CJYHN, NUC7PJYHN

NOTE If you plan to install only one memory module, install it in the lower memory

socket.

To install memory, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer and

disconnect the power cord.

3. Remove the computer’s bottom chassis cover.

4. Align the small space at the bottom edge of the memory module with the key in the socket.

5. Insert the bottom edge of the module at a 45 degree angle into the socket (A).

6. When the module is inserted, push down on the outer edge of module until the retaining

clips snap into place (B). Make sure the clips are firmly in place (C).

To remove a SO-DIMM, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect

the power cord.

3. Remove the computer’s bottom chassis cover.

4. Gently spread the retaining clips at each end of the memory socket, which causes the module to

pop out of the socket (C).

5. Holding the module by the edges, lift it away from the socket, and store it in an anti-static package.

6. Reinstall and reconnect any parts you removed or disconnected to reach the memory sockets.

7. Replace the computer’s cover and reconnect the power cord.

Install a 2.5” SSD or Hard Drive

The Intel NUC Kits NUC7CJYH[x] and NUC7PJYH[x] support a 2.5” Solid State Drive (SSD) or Hard Disk

Drive (HDD).

Find compatible 2.5” drives in the Intel® Product Compatibility Tool:

 NUC7CJYHN

 NUC7PJYHN

User Guide for NUC7CJYHN, NUC7PJYHN

1. Slide the new 2.5” drive into the drive bay, ensuring the SATA connectors are fully seated into the

connectors of the SATA daughter card (A).

2. Secure the drive into the drive bay with the two small silver screws that were included in the box (B).

Set the drive bay bracket down inside the chassis (C).

User Guide for NUC7CJYHN, NUC7PJYHN

Close the Chassis

After all components have been installed, close the Intel NUC chassis (using an electric or battery

operated screwdriver can damage the NUC).

Attach and Use the VESA Bracket (Optional)

Follow these instructions to attach and use the VESA mount bracket:

1. Using the four small black screws that were included in the box, attach the VESA bracket to the

back of the monitor or TV.

User Guide for NUC7CJYHN, NUC7PJYHN

2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.

3. Slide the Intel NUC onto the VESA mount bracket.

User Guide for NUC7CJYHN, NUC7PJYHN

Connect Power

Each Intel NUC model includes either a region-specific AC power cord or no AC power cord (only the power

adapter).

Product codes

Power cord type

BOXNUC7CJYHN,

BOXNUC7PJYHN

No power cord included.

An AC power cord needs to be

purchased

separately. Power cords are available at many Internet sites for use in

multiple countries. The connector on the power adapter is a C5 type

connector.

BOXNUC7CJYHN1

BOXNUC7PJYHN1

US power cord included.

BOXNUC7CJYHN2,

BOXNUC7PJYHN2,

EU power cord included.

BOXNUC7CJYHN3

UK power cord included.

BOXNUC7CJYHN4

Australia/New Zealand power cord included.

BOXNUC7CJYHN5

India power cord included.

Connect AC power.

User Guide for NUC7CJYHN, NUC7PJYHN

Install an Operating System

Refer to Supported Operating Systems for a list of Intel-validated Windows* operating systems, as well

as versions of Linux that have been reported as compatible by Intel NUC owners.

Refer to Operating System Installation for system requirements and installation steps.

Install the Latest Device Drivers and Software

Here are the options for keeping device drivers current:

 Allow the Intel® Driver & Support Assistant (Intel® DSA) to detect out-of-date drivers

 Manually download drivers, BIOS, and software from Download Center:

o NUC7CJYHN

o NUC7PJYHN

The following device drivers and software are available.

 Intel® Chipset Device Software

 Intel® UHD Graphics

 Intel® Wireless

 Intel® Bluetooth

 Intel® Trusted Execution Engine

 Intel® Serial I/O

 Intel® GNA Scoring Accelerator

 Realtek* Gigabit Ethernet

 Realtek* Card Reader

 ITE Tech* Consumer Infrared

 Intel® Software Guard Extensions

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Intel Matériel informatique

Intel

Intel I5-520E - ADDENDUM Manuel utilisateur

Intel

Intel SRCU42E - Ultra320 SCSI PCI Express X8 RAID Storage... Manuel d'installation

Intel

Intel CMCN1CC Guide de configuration rapide

Intel

Intel 80C51FA Manuel utilisateur

Intel

Intel SRCSAS18E - RAID Controller Manuel utilisateur

Intel

Intel DC3217BY Manuel utilisateur

Intel

Intel NetStructure ZT 5085 12U Manuel utilisateur

Intel

Intel RS25AB080 Manuel utilisateur

Intel

Intel BX80571E7500 - Core 2 Duo 2.93 GHz Processor Mode d'emploi

Intel

Intel l2ICE Manuel utilisateur

Intel

Intel Core i7-860 Instructions d'utilisation et de sécurité

Intel

Intel SRCS28X - RAID Controller Manuel utilisateur

Intel

Intel DQ77MK Guide de configuration rapide

Intel

Intel SASWT4I Manuel d'installation

Intel

Intel 80219 Manuel technique

Intel

Intel TS13X Manuel utilisateur

Intel

Intel i960 Series Mode d’emploi

Intel

Intel Optane M Series Manuel utilisateur

Intel

Intel Core i5 Desktop Series Manuel utilisateur

Intel

Intel NetBurst Manuel utilisateur

Intel

Intel LGA2011 Manuel utilisateur

Intel

Intel I7-900 DEKSTOP SPECIFICATION Manuel utilisateur

Intel

Intel IXDP465 Manuel utilisateur

Intel

Intel DP45SG - CARACTERISTIQUES TECHNIQUES Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur

Advantech

Advantech ASMB-935 Series Manuel utilisateur

Jupiter

Jupiter RAM PACK Manuel utilisateur