FIC AZ11 Manuel utilisateur

AZ11

MAINBOARD

MANUAL

DOC No.: M00401

Rev. : A1

Date : 6, 2000

Part No. : 25-11521-21

Handling Precautions

Warning:

1. Static electricity may cause damage to the integrated circuits on

the motherboard. Before handling any motherboard outside of its

protective packaging, ensure that there is no static electric charge

in your body.

2. There is a danger of explosion if the battery is incorrectly

replaced. Replace only with the same or an equivalent type

recommended by the manufacturer.

3. Discard used batteries according to the manufacturer’s

instructions.

Observe the following basic precautions when handling the motherboard

or other computer components:

nWear a static wrist strap which fits around your wrist and is

connected to a natural earth ground.

nTouch a grounded or anti-static surface or a metal fixture such as a

water pipe.

nAvoid contacting the components on add-on cards, motherboards,

and modules with the golden fingers connectors plugged into the

expansion slot. It is best to handle system components by their

monting brackets.

The above methods prevent static build-up and cause it to be discharged

properly.

Trademark

All trademarks mentioned in this manual are registered properly of

the respective owners.

Handling Precautions

Thismanualmaynot,inwholeorinpart,bephotocopied,reproduced,

transcribed, translated, or transmitted in whatever form without the

written consent of the manufacturer, except for copies retained by the

purchaser for personal archival purposes.

Notice

TableofContents

Table of Contents

Chapter 1 Overview

Package Checklist .......................................................................... 1-2

The AZ11 Mainboard................................................................ 1-3

Main Features................................................................................ 1-4

ACPIReady ................................................................................... 1-6

FICUniqueInnovationforUsersII(NOVUSII) -

Enhanced Mainboard Features and System Support .................... 1-6

Chapter 2 Installation Procedures

QuickReference (from Page2-2 to 2-4) .......................................... 2-2

Mainboard Layout .................................................................... 2-2

1).Clear CMOS,Over VoltageDriving............................... 2-3

2). Front Panel Block Cable Connection ............................ 2-4

3).CPU Fan Installation .................................................... 2-4

1). Set System Jumpers .................................................................. 2-5

ClearCMOS:CLR_CMOS ................................................. 2-6

Enabling Over Voltage Driving: Magic Tuner ................... 2-6

2). Install RAM Modules .............................................................. 2-7

Install and Remove DIMMs .............................................. 2-7

3).Install the CPU .......................................................................... 2-8

4). Install Expansion Cards............................................................. 2-9

5). Connect Devices ....................................................................... 2-10

Floppy Diskette Drive Connector: FDD ............................ 2-10

IDEHDD DeviceConnectors: PRIMARY,SECONDARY .. 2-11

ATX Power Connector: ATX_PWR .................................. 2-11

CPUFan Connector:CPU_FAN ........................................ 2-12

System Case Fan Connectors: CHS_FAN, SYS_FAN ....... 2-12

CDAudioo-In Connectors: CD_IN1, CD_IN2.................. 2-13

FrontPanel Block Connector: FPNL.................................. 2-13

PS/2 Keyboard and Mouse Connector: PS2_KB, PS2_MS 2-15

Universal Serial Bus Connectors: Rear USBs, Front USBs 2-15

PrinterConnector: LPT...................................................... 2-16

Serial Port Connectors: COM ............................................ 2-16

AudioI/O Jacks:LINE_OUT,LINE_IN, MIC_IN .............. 2-17

NOVUSII ModuleConnector: NOVUSII ......................... 2-17

AZ11MainboardManual

Chapter 3 BIOS Setup

CMOSSetup Utility ....................................................................... 3-1

Standard CMOS Setup................................................................... 3-2

Hard Disk Configurations.......................................................... 3-2

Advanced BIOS Features .............................................................. 3-3

Advanced Chipset Features .......................................................... 3-6

Integrated Peripherals .................................................................... 3-11

Power Management Setup ............................................................. 3-15

PNP/PCIConfigurations ................................................................ 3-20

PC Health Status ............................................................................ 3-21

Frequency/Voltage Control ............................................................ 3-22

LoadFail-Safe Defaults.................................................................. 3-23

LoadOptimized Defaults................................................................ 3-23

Supervisor/User Password ............................................................ 3-24

Save and Exit Setup ....................................................................... 3-25

Exitwithout Saving ........................................................................ 3-25

Quick Reference (German) G-1

Quick Reference (French) F-1

Quick Reference (Spanish) S-1

Quick Reference (Japanese) J-1

Quick Reference (Chinese) C-1

Quick Reference (Simplified Chinese ) SC-1

1 - 1

Overview

Chapter 1

The new Socket A 1stMainboard AZ11 is an ATX sized motherboard support-

ing the latest generation of AMD Athlon and Duron processors at industry

leading speeds. By utilizing DDR ( Double Data Rate ) transfer rate the 100

MHz AMD Athlon system bus effectively reaches speeds of 200 MHz. The

AMD Athlon processor offers high-performance cache technology, including

128KBof on-chip level one (L1), while the Duron featuresfull-speed, on-chip

L2 cache memory, and enhanced 3DNow!™ technology. The 1stMainboard

AZ11 has 3 DIMM, for up to 1.5 GB of SDRAM, utilizes the latest PC133

SDRAM technology and is equipped with ECC memory support.

The 1stMainboard AZ11 is based around the high performance KT133 chipset

comprisedof VIA VT8363 systemcontroller for theNorth Bridge, andthe VIA

686A ( Super South ). The KT133’s support for AGP 4x provides the end-user

a photo-realistic 3D experience suitable for the most robust 3D games and

software environments. Onboard AC97 sound ensures high quality audio, but

with the option of being disabled through the BIOS.

The 1stMainboard AZ11 also comes equipped with the new NOVUS II range

of innovative features that assist in the installation and maintenance of your

1stMainboard. The features include Easy Key, which provides instant key-

board access to the BIOS for adjustments to Clock and Default settings and

LogoGenie, which allows you to create your own customized logo to be dis-

played during system boot up. The BIOS Guardian is anAnti Virus utility that

prevents viruses from damaging your system BIOS and rendering your sys-

tem inoperative. Clockometer is a user friendly Graphic User Interface (GUI)

that allows you to change clock speed settings directly, without having to

enterthe BIOS Sub-Menus. Moreover, audio alertII (mfg. optional) ,a friendly

onboard voice caution, will advice the error during system boot up.

Expansionis provided by1 AGPand 5 PCI slots.In addition, the1stMainboard

AZ11 is equipped with 2 dual channeled enhanced PCI bus master IDE con-

nectors. Standard I/O connections include 1 serial port, 1 parallel port, 1 PS/2

mouse and keyboard connector, 2 USB connectors, 2 front USB pin-headers

and 1 media connector ( Line-In, Line-Out, Mic-In).

1 - 2

AZ11MainboardManual

Package Checklist

If you discover any item below was damaged or lost, please contact your

vendor.

þThe mainboard þThis user manual

þOneFDD cable þOne HDD cable

þOneATA/66cable þAudio Alert II module (optional)

þTwo software CDs (CD Pro, CD Plus and its manual)

IMPORTANT:AMDCPUHEATSINKINSTALLATION

Be ware finish heat hink install. Before you boot system, please

check the heat sink is complete contact with die of CPU.

The poor contact will bring about over heat, it may damage your

processor.

Itisstrongly recommended that at least a200-wattATXpower pupply

be used for this motherboard. Make sure that your ATX power sup-

ply can supply at least 20 amperes on teh +5-Volt lead and 10ma

on the +5-Volt standby lead (+5VSB). Your system may become

unstable / unreliable and may experience difficulty in powering up if

your power supply is inadequate.

1 - 3

Overview

The AZ11 Mainboard

1 - 4

AZ11MainboardManual

Main Features

■Easy Installation

||BIOS with support for Plug and Play, auto detection of IDE hard drives,

||LS-120|drives, IDE ZIP drives, Windows 95, Windows 98, Windows NT

||4.0,Windows2000, |andOS/2.

■Leading Edge Chipset

VIAVT8363 and 686A (Super South) provideintegrated DRAM control-

lers with new Dynamic Power Management Architecture (DPMA), con-

currentPCI (2.2),AGP 1.0/2.0compliant and USB.

■Versatile Main Memory Support

Accepts up to 1.5GB DRAM using three DIMMs of 32, 64, 128, 256,

512MB with support for lightenning-fast SDRAM (100/133MHz). The

latestVirtualChannel Memory (VCM)SDRAM alsosupported.This board

allows the FSB and DRAM to be asynchronous.

■Enhanced PCI Bus Master IDE Controller with Ultra DMA/33 and

Ultra DMA/66 Support

Integrated Enhanced PCI Bus Master IDE controller features two dual-

channel connectors that up to four Enhanced IDE devices, including CD-

ROM and Tape Backup Drives, as well as Hard Disk Drives supporting

the new Ultra DMA/66 protocol. Standard PIO Mode 3, PIO Mode 4,

DMA Mode 2, DMA Mode 4 devices are also supported.

■AMD® Athlon™ Processors Support

Duron Socket A CPU 600/650/700/750MHz at 100MHz FSB with AMD

bus for double data transfer rate at 100MHz for an effective 200MHz

transfer rate.

Athlon Socket A CPU 750/800/850/900*/950*MHz and up to 1GHz*at

100MHz FSB with AMD Athlon bus for double data rate transfers at

100MHzfor effective 200MHztransfer rate.

1 - 5

Overview

■AGP and PCI Expansion Slots

One AGP Bus expansion slot and five PCI Bus expansion slots provided

the room to install a full range of add-on cards.

■Compact Onboard Audio Subsystem

Embeded in VIA 686A®, the audio processor offers an integrated PCI

audiocontroller,DOS games compatibleengine, and offersthe feature of

high-quality music synthesizer. The subsystem utilizes line-out, line-in,

and MIC mini-jack external jacks, one joystick port with MIDI interface.

■■

■Super Multi Input/Output (I/O) Support

IntegratedPlug and Play multi-I/O chipset featuresone high-speed UART

16550 compatible serial port, one EPP/ECP capable parallel port, and one

FDD connector.

■■

■Convenient Rear Panel USB Connection Support

Two USB ports integrated in the rear I/O panel with two manufacturing

optional USB front panel connections allow convenient and high-speed

Plug and Play connections to the growing number of USB compliant

peripheral devices on the market.

■■

■Onboard Accelerated Graphics Port (AGP)

Themotherboard is installedone 32-bit AGPbus with adedicated 66MHz/

133MHzpath from the graphicscard to the system memoryoffering much

greater bandwidth than the 32-bit PCI bus does. AGP enabled 3D graph-

ics cards can directly access main memory across this fast path instead of

using local memory. To make use of the improved AGP performance, the

motherboardshould be installed withSDRAM type memory andthe VGA

card and drivers should also be fully AGP compliant. Using Microsoft’s

Windows 98 and Windows 2000 which implement DirectDraw will allow

the system to take full use of AGP’s benefits without the need to install

additional drivers.

1 - 6

AZ11MainboardManual

It is compatible with all other none ACPI operating systems. If you want to

setup ACPI feature under Windows 98, please follow the description below:

Run Windows 98 setup by using setup/p j on the command line for installing

Windows 98 with the ACPI control feature.

If you type setup without the parameter /p j, Windows 98 will be installed as

APM, PnP mode, no ACPI will be used. For more detail information, please

visit the web site of Microsoft. Its address is: www.microsoft.com/hwtest/.

FIC Unique Innovation for Users II (NOVUS

II) - Enhanced Mainboard Features and System Support

■■

■LogoGenie

A user friendly GUI supporting Windows 98, LogoGenie allows you to

customize, create or select a Logo which will be displayed when the sys-

tem is booting.

Before execute this LogoGenie function, please make sure the related

BIOS feature, BIOS Guardian, is disabled; and refer to its related

README file.

NOTE:

1. LogGenie supports Award BIOS only.

2. If you create a Logo file (.bmp) by LogoGenie, the file size must

||||be 640 x 464 x 16 colors (around 145K).

NOTE: If BIOS date is after 12/02/1999, the ACPI will be installed

automatically. Users do not need to setup in the above-mentioned

way.

ACPI Ready

Thismainboard fully implements the newACPI (Advanced Configuration and

Power Interface) 1.0B Hardware and BIOS requirement. If you install ACPI

aware of operating system, such as Windows 98, you fully utilized the power

saving under ACPI. (Windows 2000 Professional supports ACPI functions.)

Table des matières

Manuels Carte mère populaires d'autres marques

DFI

DFI SD170 Manuel utilisateur

ASROCK

ASROCK ROMED8-2T Manuel utilisateur

Asus

Asus P2L97A Manuel utilisateur

Winmate

Winmate IC70 Manuel utilisateur

Asus

Asus MES-B Manuel utilisateur

Grantech

Grantech SYS8F377VGGA-3OMN Manuel utilisateur

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuel utilisateur

Gigabyte

Gigabyte GA-9IVDT Manuel utilisateur

Texas Instruments

Texas Instruments ADS8372EVM Manuel utilisateur

Commell

Commell MS-C73 Manuel utilisateur

IBT Technologies

IBT Technologies MB860 Manuel utilisateur

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur

Biostar

Biostar M7VIT Bravo Instructions d'utilisation et d'installation

Intel

Intel D33217CK Manuel utilisateur

Asus

Asus F1A55-M LX PLUS R2.0 Manuel utilisateur

EPC

EPC EPC9147C Manuel utilisateur

Asus

Asus EX-B760M-V5 D4 Manuel utilisateur

EPOX

EPOX MU-8KHA0010 Manuel utilisateur