Ekwb EK-FC590 GTX Mode d’emploi

All disclosures, notices and warranty conditions are being written on the back of the box. Released on 4th of April, 2011.

Installation and mounting manual for EK-FC590 GTX backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of NVidia GeForce 590 GTX graphic card (reference design).

STEP 2: PREPARING YOUR GRAPHIC CARD NVIDIA GEFORCE 590 GTX

EK-FC590 GTX backplate is very easy to install. First install EK-FC590 GTX water block according to its manual. If you have it already installed,

please check below which mounting screws for water block are to be left in their position. Please remove the six screws marked with arrow.

STEP 3: APPLYING THE THERMAL PADS

EK-FC590GTX backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install the enclosed

thermal pads. Please install the 0.5mm thick thermal pads on the memory ICs and on the two extruded stubs on the backplate itself.

STEP 3: ATTACHING EK-FC590 GTX BACKPLATE

Thickness 0.5mm (for memory ICs)

Thickness 0.5mm

(for VRM)

Thickness 0.5mm (for

memory ICs)

All disclosures, notices and warranty conditions are being written on the back of the box. Released on 4th of April, 2011.

Take enclosed mounting screws and install them as shown on picture below. EKWB recommends users to start with M3x12 screws in the middle

(HINT: do not tighten screws until they are all positioned in their mounting holes). Backplate has milled in standoffs, so there is no fear of

overtightening the screws. Nevertheless, do not exaggerate with screwing force as there is no need for it.

(Please note that EKWB holds no responsibility of any kind if assembly is not made by instructions. This applies also for all products that are not out

of EKWB production line. Users must by all means also consider instructions that are being made for proper use of FC blocks.)

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was

purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled

carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer

rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and

does not affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper

liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void only leaking issues.

Any other RMA issues can be reported to support@ekwaterblocks.com for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

scissors 6 ×PVC washers 6 x screws M3x12 7991DIN 2mm allen key

Use enclosed allen key

on screws to attach

backplate.

M3x12 screw

Please use enclosed PVC

washers under milled

standoffs!

Washer

Table des matières

Autres manuels ekwb Matériel informatique

ekwb

ekwb EK-FC970 GTX TF5 Manuel

ekwb

ekwb EK-Pro Manuel utilisateur

ekwb

ekwb EK-FB ASUS Strix X299-E RGB Monoblock Manuel utilisateur

ekwb

ekwb EK-FC R9-290X Manuel

ekwb

ekwb Vector 2 FTW3 RTX 3080/90 ABP Manuel utilisateur

ekwb

ekwb EK-FB ASUS Z270E Strix Monoblock Series Manuel utilisateur

ekwb

ekwb EK-FCQK5000 Manuel

ekwb

ekwb EK-FC R9-390X TF5 Mode d’emploi

ekwb

ekwb EK-FC980 GTX Original CSQ Series Manuel

ekwb

ekwb EK X Series Manuel utilisateur

ekwb

ekwb EK-Vector Trio RTX 2080 Ti Manuel utilisateur

ekwb

ekwb EK-FB ASUS P7P55 KIT Mode d’emploi

ekwb

ekwb EK-UNI RAD Manuel

ekwb

ekwb Barebones Mode d’emploi

ekwb

ekwb EK-FC980 GTX Ti Strix Manuel

ekwb

ekwb EK-FC680 GTX FTW Mode d’emploi

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Manuel utilisateur

ekwb

ekwb EK-FB ASRock X299 RGB Monoblock Manuel utilisateur

ekwb

ekwb EK-FC R9-290X Lightning Series Manuel

ekwb

ekwb EK-Nucleus AIO CR360 Vision D-RGB Manuel utilisateur

ekwb

ekwb EK-Quantum Velocity 2 Manuel utilisateur

ekwb

ekwb EK-AIO 280 D-RGB Manuel utilisateur

ekwb

ekwb EK-FC Strix RTX 2080 Ti Backplate Classic Manuel utilisateur

ekwb

ekwb EK-FC 780 GTX Lightning Manuel

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur

ekwb EK-FC590 GTX Mode d’emploi

Manuels Matériel informatique populaires d'autres marques