Ekwb EK-DBAY DCP 2.2 Manuel

Revision 1.0. Released on 20th of November, 2012.

Installation and mounting manual for EK-DBAY DCP 2.2 (Original CSQ incl.

pump)

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

1. Please carefully read the manual before through before beginning with the installation process!

2. The EK High Flow and EK-PSC type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.

3. The use of quality, market proved corrosion inhibiting coolants is always strongly recommended for any liquid cooling system.

STEP 1: GENERAL INFORMATION. Sample picture of EK-DBAY DCP 2.2 (Original CSQ incl. pump)

STEP 2: MOUNTING THE RESERVOIR INSIDE YOUR COMPUTER CHASSIS:

This reservoir occupies two 5.25” drive bay expansion slots in your computer chassis. Free two slots in case they are already occupied with other

computer components such as optical- or hard disk drives:

1) Install anti-vibration rubber damper into each of the three slots on the sides of the reservoir

2) Place the reservoir in your

5.25" drive bay

with the front plate facing outwards

3) Secure the reservoir to the drive bay cage using the enclosed M3x4 DIN7985 screws and Philip head screwdriver.

M3x4 DIN7985 screw

M3 BAY anti-vibration

rubber damper

Revision 1.0. Released on 20th of November, 2012.

STEP 3: CONNECTING YOU RESERVOIR

Connect two G1/4 threaded fittings to the reservoir (IN) and pump (OUT). Please note the water flow orientation.

EKWB recommends using EK-PSC

fittings with the EK-DBAY DCP 2.2 (Original CSQ incl. pump) series units. To ensure that the tubes are securely attached to the barb/fittings, please use hose

clamps or an appropriate substitute.

STEP 4: FILLING THE RESERVOIR, PRIMING THE PUMP

Fill reservoir through G3/8 threaded fill port (marked with arrow) and make sure liquid is not spilled over your computer or any electrical devices nearby. Run

your pump shortly for couple of times to make sure water floods your tubes and other water cooling components. Repeat the procedure until you are done and

pay attention to the water level in your reservoir. Lowest and highest recommendable water levels are indicated on the reservoir's front panel (

min

max

). Once

done with the filling process please close your EK-DBAY DCP 2.2 (Original CSQ incl. pump) with G3/8 plug and tighten the seal using enclosed Allen key.

STEP 5: OTHER INSTRUCTIONS

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the computer. We recommend a 24 hour leak test prior to powering

up the computer. Do not test the water block using tap water pressure. This will rupture the top of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the

most comprehensive tutorial possible, EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks cooling products, either

due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During this period, products will be repaired or have

parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the

product has not been misused, handled carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other than

those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not affect your statutory rights as a consumer. This warranty is voided if

the product comes in contact with aggressive UV additives or other improper liquids.

REQUIRED TOOLS:

philips head screwdriver

Water out

(to radiator or water block)

Inlet G1/4

threaded port

EK PSC fitting

Water in (from radiator or water block)

Tubing

Predrilled holes for 5mm LEDs

(acrylic version only)

EK-DCP 2.2

Water Pump

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels ekwb Matériel informatique

ekwb

ekwb EK-Quantum Vector Trinity RTX 3080/3090 Manuel utilisateur

ekwb

ekwb EK-D5 Dual TOP CSQ Manuel

ekwb

ekwb EK-PRO GPU WB AMP-Trinity RTX 4090 Ni+Inox Manuel utilisateur

ekwb

ekwb EK-Nucleus AIO CR360 Vision D-RGB Manuel utilisateur

ekwb

ekwb EK-Vector Trio RTX 2080 Manuel utilisateur

ekwb

ekwb EK-Loop PCI Bracket Pass-Through Manuel utilisateur

ekwb

ekwb EK-Quantum Vector Trinity RTX 3080/3090 Manuel utilisateur

ekwb

ekwb EK-FC980 GTX Original CSQ Series Manuel

ekwb

ekwb EK-QuantumX Loophole Distroplate D5 PWM Manuel utilisateur

ekwb

ekwb EK-FB ASUS CROSSHAIR 3 Manuel

ekwb

ekwb EK-Quantum Reflection Uni 140 D5 PWM D-RGB Manuel utilisateur

ekwb

ekwb EK-FB MSI X399 GAMING RGB Monoblock Manuel utilisateur

ekwb

ekwb EK-FB KIT GA-X99 SOC Champion Series Manuel

ekwb

ekwb EK-Classic GPU Water BlockRTX 2080Ti D-RGB Manuel utilisateur

ekwb

ekwb EK-Vector FTW3 RTX 2080 Ti Mode d’emploi

ekwb

ekwb EK-Quantum Momentum Aorus Z490 Master D-RGB Manuel utilisateur

ekwb

ekwb EK-FC7970 Manuel

ekwb

ekwb EK-XTOP D5 Mode d’emploi

ekwb

ekwb EK-FC670 GTX Backplate Manuel

ekwb

ekwb EK-FB GA X299 GAMING Monoblock Manuel utilisateur

ekwb

ekwb EK-FC Titan X Mode d’emploi

ekwb

ekwb EK-TIM Indigo Extreme Manuel utilisateur

ekwb

ekwb EK-FB ASUS M8I Monoblock Manuel utilisateur

ekwb

ekwb EK-FC 4890 VAPOR X Mode d’emploi

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur

ekwb EK-DBAY DCP 2.2 Manuel

Manuels Matériel informatique populaires d'autres marques