Dinstar UC100 Manuel utilisateur

Quick Installation Guide

1. Product Appearance of UC100

（1）Front View

On the front panel are seven indicators and the SIM card slot which supports hot swap.

（2）Back View

On the rear panel are the power port, WAN port, LAN port, FXS port, FXO port, reset button and external antenna.

Please use a network cable to connect the UC100 with a PC for convenient management.

Note: If the network is working under the route mode,WAN IP address is different from LAN IP address. But when

it is under the bridge mode, WAN IP address is the same as LAN IP address.

2.Configurations via Telephone

User could conduct some basic configurations on the UC100 by dialing the following keys on the telephone.

3. Configurations on Web Interface

（1）How to Log on Web Interface

Insert a network cable into LAN port, open a web browser on PC and enter the default IP ‘192.168.11.1’. Both the

default username and password are admin.

（2）How to Modify Network Configuration

Click Network Setting, and configure network parameters and WiFi parameters.

Note: Default network model is Route. User could choose to switch to Bridge.

（3）Configuration of SIP Trunk

Click Trunk SIP, and then click the New button to create a new trunk. Configure IP address and port of the peer

device. Choose whether to enable register or not. Click Save at the last.

（4）Configuration of FXS/FXO Port

Take FXS Port for Example

Click Extension FXS, and then click . Enter correct extension number and choose whether to enable register or

not. Click Save at the last.

Note: Auto call can only be enabled for incoming calls of FXO port and GSM port.

（5）Routing Configuration

Click Call ControlRoute, and then click the New button to create a new route. Choose a source and destination for

calls and click the Save button.

User needs to click Unsaved Changes at the upper right of the web interface after completing the above

configuration, and then click Save & Apply.

Note: the changes will not take effect until the UC100 is restarted.

4. Description of Indicators

5. FAQ

If the web interface you are trying to access is unavailable:

a. Check whether the network cable is correctly connected.

b. Check whether WAN IP is obtained via DHCP and LAN IP is 192.168.11.1 under the default network model ‘route'.

c. Check whether the IP address of PC and the IP address of peer device are at the same network segment.

d. Check whether the IP address of UC100 has been used by other device.

Autres manuels pour UC100

Table des matières

Autres manuels Dinstar Porte

Dinstar

Dinstar DWG2000E Manuel utilisateur

Dinstar

Dinstar UC2000-VE Manuel utilisateur

Dinstar

Dinstar DAG2500-48S Manuel utilisateur

Dinstar

Dinstar DAG1000-4O Manuel utilisateur

Dinstar

Dinstar DWG2000 Series Manuel utilisateur

Dinstar

Dinstar MTG1000 Manuel utilisateur

Dinstar

Dinstar FXSFXO Manuel utilisateur

Dinstar

Dinstar MTG1000 Manuel utilisateur

Dinstar

Dinstar MTG3000 Manuel utilisateur

Dinstar

Dinstar DWG2001 Manuel utilisateur

Dinstar

Dinstar DWG2000-8G Manuel utilisateur

Dinstar

Dinstar MTG3000 Manuel utilisateur

Dinstar

Dinstar DAG3000-112S Manuel utilisateur

Dinstar

Dinstar MTG1000-4E1/T1 Manuel utilisateur

Dinstar

Dinstar DAG1000-4S4O Manuel utilisateur

Dinstar

Dinstar DAG3000-24O Manuel utilisateur

Dinstar

Dinstar UC350 Manuel utilisateur

Dinstar

Dinstar UC2000-VE Manuel utilisateur

Dinstar

Dinstar MTG5000-64E1 Manuel utilisateur

Dinstar

Dinstar DAG1000-4S-V321 Instructions d'utilisation et d'entretien

Dinstar

Dinstar UC100-1T1S1O Manuel utilisateur

Dinstar

Dinstar DAG1000-4O Manuel utilisateur

Dinstar

Dinstar MTG1000B Series Manuel utilisateur

Dinstar

Dinstar UC100-1V1S1O Manuel utilisateur

Manuels Porte populaires d'autres marques

LST

LST M500RFE-AS Manuel utilisateur

Kinnex

Kinnex Media Gateway Manuel utilisateur

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuel utilisateur

Telsey

Telsey CPVA 500 - SIP Manuel utilisateur

RTA

RTA 460A-NNA4 Fiche technique

Shaw

Shaw Gateway HDPVR Manuel utilisateur

ABB

ABB VSN900 Guide de démarrage rapide

Commander

Commander Pulse Manuel utilisateur

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuel utilisateur

NETGEAR

NETGEAR C6300BD Manuel utilisateur

Amit

Amit CDW531AM Manuel utilisateur

HMS

HMS Netbiter EasyConnect EC150 Manuel utilisateur

Huawei

Huawei EchoLife HG620 Manuel utilisateur

AT&T

AT&T U-verse 3801 Manuel d'utilisation et d'entretien

Logic IO

Logic IO RTCU MX2 turbo Manuel utilisateur

Suttle

Suttle MediaMAX MXM-521 Manuel utilisateur