Digital Equipment DEClaser 2200 Manuel utilisateur

DEClaser 2200 Printer

Installation Guide

EK–D2200–IN–001

Digital Equipment Corporation

Maynard, Massachusetts

First Printing, June 1990

The information in this document is subject to change without notice and should not be

construed as a commitment by Digital Equipment Corporation.

Digital Equipment Corporation assumes no responsibility for any errors that may appear in

this document.

Any software described in this document is furnished under a license and may be used or

copied only in accordance with the terms of such license. No responsibility is assumed for

the use or reliability of software or equipment that is not supplied by Digital Equipment

Corporation or its afﬁliated companies.

Restricted Rights: Use, duplication, or disclosure by the U.S. Government is subject to

restrictions as set forth in subparagraph (c)(1)(ii) of the Rights in Technical Data and Computer

Software clause at DFARS 252.227–7013.

The Reader’s Comments form at the end of this document requests your critical evaluation to

assist in preparing future documentation.

The following are trademarks of Digital Equipment Corporation: BASIC Service, DECconnect,

DECdirect, DEClaser, DECmailer, DECmate, DECserver, DECservice, DECstation, EDT,

LN03, MicroVAX, PRO, Rainbow, VAX, VAX DOCUMENT, VAXmate, VAXstation, VAX/VMS,

VMS, WPS-PLUS, VT, and the DIGITAL Logo.

The following are third-party trademarks: BITSTREAM is a registered trademark of

Bitstream, Inc. Centronics is a trademark of Centronics Data Computer Corporation.

CG Times is a trademark of Compugraphic Corporation. CG Triumvirate is a trademark

of Compugraphic Corporation. IBM is a registered trademark of International Business

Machines Corporation. IBM-PC is a trademark of International Business Machines

Corporation. ITC Souvenir is a registered trademark of International Typeface Corporation.

PostScript is a registered trademark of Adobe Systems, Inc.

S1387

This document was prepared using VAX DOCUMENT, Version 1.2.

FCC NOTICE: This equipment generates and uses radio frequency energy

and if not installed and used properly, that is, in strict accordance with the

manufacturer’s instructions, may cause interference to radio and television

reception. It has been type tested and found to comply with the limits

for a Class B computing device in accordance with the speciﬁcations in

Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable

protection against such interference in a residential installation. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause interference to radio or television

reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of

the following methods.

– Reorient the receiving antenna.

– Relocate the computer or peripheral with respect to the receiver.

– Move the computer or peripheral away from the receiver.

– Plug the computer or peripheral into a different outlet so that they are

on different branch circuits than the receiver.

If necessary, the user should consult the dealer or an experienced radio/

television technician for additional suggestions. The user may ﬁnd the

booklet How to Identify and Resolve Radio/TV Interference Problems,

prepared by the Federal Communications Commission helpful. This booklet

is available from the U.S. Government Printing Ofﬁce, Washington DC,

20402, Stock No. 004-000-00345-4.

To meet FCC requirements, a shielded parallel cable is required to connect

the device to a personal computer or other Class B device.

Contents

Preface v

Chapter 1 Preparing Your Site

1.1 Power Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1

1.2 Operating Location Requirements . . . . . . . . . . . . . . . . . . . . . 1–2

1.3 Environmental Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–3

Chapter 2 Unpacking Your Printer

2.1 PrinterInventory.................................. 2–1

2.2 DEClaser 2200 Printer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–2

2.3 Unpacking the Printer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–3

Chapter 3 Cleaning the Fixing Assembly Roller

Chapter 4 Installing the EP-S Cartridge

Chapter 5 Loading Paper

Chapter 6 Connecting the Printer

6.1 Connecting to the Host Device . . . . . . . . . . . . . . . . . . . . . . . . 6–1

6.1.1 Serial Interface Connection . . . . . . . . . . . . . . . . . . . . . . . . 6–2

6.1.2 Parallel Interface Connection . . . . . . . . . . . . . . . . . . . . . . . 6–4

6.2 Connecting to a Power Source . . . . . . . . . . . . . . . . . . . . . . . . 6–5

iii

Chapter 7 Verifying the Installation

7.1 Checking the Printer Mechanism . . . . . . . . . . . . . . . . . . . . . . 7–1

7.1.1 Testing the Printer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7–3

7.1.2 Producing a Test Print . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7–5

7.2 Conclusion....................................... 7–6

Appendix A Cabling Information

A.1 Cable Combinations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A–1

A.2 Interface Programming Instructions . . . . . . . . . . . . . . . . . . . A–5

A.2.1 Serial Flow Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A–5

A.2.2 Parallel Communication . . . . . . . . . . . . . . . . . . . . . . . . . . . A–6

Tables

A–1 Cables and Adapters for Communication Connections . . . . . . A–1

Preface

The DEClaser 2200 printer is a nonimpact, desktop, page printer that can

print on both sides of a sheet of paper. This guide covers the installation

of the DEClaser 2200 printer up to the point where it is certiﬁed to be

operating properly.

Intended Audience

This guide is written for installers of the DEClaser 2200 printer.

Document Structure

This guide has seven chapters and one appendix.

Chapter 1, Preparing Your Site, discusses site preparation items, such as

power requirements, operating location, and environmental conditions.

Chapter 2, Unpacking Your Printer, describes how to unpack the printer

and identiﬁes its parts.

Chapter 3, Cleaning the Fixing Assembly Roller, shows how to do an initial

cleaning of the ﬁxing assembly roller.

Chapter 4, Installing the EP-S Cartridge, describes how to install the

electrophotographic supplies (EP-S) cartridge.

Chapter 5, Loading Paper, explains how to load paper.

Chapter 6, Connecting the Printer, shows how to connect the printer to

your computer system or video terminal.

Chapter 7, Verifying the Installation, explains how to run the self-test.

Appendix A, Cabling Information, explains how to cable your printer to

different systems, such as workstations and PCs.

NOTE: It is recommended to perform all procedures in the order given.

Ordering Additional Copies of This Documentation Set

You can order additional copies of this documentation set from DECdirect

as described in the ordering information section following Appendix D of

the DEClaser 2200 Printer Operator’s Guide. The ordering number for the

documentation is EK–D2200–DK.

The documentation set consists of:

• One DEClaser 2200 Printer Installation Guide

• One DEClaser 2200 Printer Operator’s Guide

• One spine insert for the binder

• One 3-ring binder

NOTE: You cannot order the installation or operator’s guide individually.

You can order only the documentation set.

Associated Documents

DEClaser 2200 Printer Operator’s Guide (EK–D2200–OP)

Digital ANSI-Compliant Printing Protocol Level 3 Programming Reference

Manual (AA–PBWGA–TE)

Digital ANSI-Compliant Printing Protocol Level 3 Programming Supple-

ment (AA–PBWHA–TE)

Terms and Conventions

The following terms and conventions are used in this guide:

Term/Convention Meaning

NOTE Provides general information about the current topic.

CAUTION Provides information to prevent damage to equipment.

WARNING Provides information for preventing personal injury.

On Line a key name is shown enclosed to indicate that you press that key on

the operator panel. For example:

1. Press On Line to place the printer on line.

Term/Convention Meaning

Dash (—) A statement beginning with a dash (—) describes the result of a

step. For example:

1. Press On Line to place the printer on line.

— The On Line indicator lights.

Check Mark (



) A statement marked by a check mark (



) indicates a special

instruction. For example:

1. Remove the ﬁxing assembly roller cleaner from the EP-S

cartridge box.



Identify the felt pad on one end of the ﬁxing assembly

roller cleaner.

Laser Safety

The DEClaser 2200 printer complies with laser product performance

standards set by government agencies as a Class 1 Laser Product. The

DEClaser 2200 printer does not emit hazardous light, since the beam is

totally enclosed during all modes of customer operation and maintenance.

Ozone Safety

The DEClaser 2200 printer uses an ozone ﬁlter to remove the ozone

generated by the printer. The ozone ﬁlter should be replaced at the 100,000

page count. Refer to the DEClaser 2200 Printer Operator’s Guide for

instructions on replacing the ozone ﬁlter.

WARNING: Do not operate the printer without the ozone ﬁlter installed. The

ﬁlter removes ozone, which could be hazardous to your health.

vii

Chapter 1

Preparing Your Site

The performance of the DEClaser 2200 printer can be affected by electrical

and environmental conditions surrounding its work location. This chapter

lists the requirements for installing the DEClaser printer in a location

where it performs best.

1.1 Power Requirements

The wall outlet you use should meet the following requirements:

Area Voltage Frequency Amperage

North America 120 Volts 50–60 Hz 8 Amp circuit

All others 220–240 Volts 50 Hz 5 Amp circuit

NOTE: Do not plug any other equipment into the same power supply line.

Preparing Your Site 1–1

1.2 Operating Location Requirements

The DEClaser 2200 printer should be installed in an area that meets the

following requirements:

• A ﬂat, level surface free from vibrations.

• Enough surrounding space to allow ventilation and easy access to all

sides of the printer for servicing.

The following ﬁgure illustrates the space requirements for the printer:

mlo-004522

1–2 DEClaser 2200 Printer Installation Guide

Autres manuels pour DEClaser 2200

Table des matières

Autres manuels Digital Equipment Imprimante

Digital Equipment

Digital Equipment LASO Manuel utilisateur

Digital Equipment

Digital Equipment LA600 MultiPrinter Manuel utilisateur

Digital Equipment

Digital Equipment LG31 Guide de l'administrateur

Digital Equipment

Digital Equipment LB12 Instructions d'installation

Digital Equipment

Digital Equipment LGplus Series Manuel utilisateur

Digital Equipment

Digital Equipment LG plus Series Manuel

Digital Equipment

Digital Equipment LN15 Manuel utilisateur

Digital Equipment

Digital Equipment LG06 Manuel utilisateur

Digital Equipment

Digital Equipment DEClaser 2200 Manuel

Digital Equipment

Digital Equipment LJ250 Manuel utilisateur

Digital Equipment

Digital Equipment LA30 N Manuel utilisateur

Digital Equipment

Digital Equipment DECcolorwriter 120ic Manuel utilisateur

Digital Equipment

Digital Equipment PrintServer 17/300 Manuel utilisateur

Digital Equipment

Digital Equipment LG06 Manuel utilisateur

Digital Equipment

Digital Equipment DEClaser 2100 Manuel utilisateur

Digital Equipment

Digital Equipment LN15 Guide de dépannage

Digital Equipment

Digital Equipment LA600 MultiPrinter Guide de démarrage rapide

Digital Equipment

Digital Equipment LA310 Manuel utilisateur

Digital Equipment

Digital Equipment DEClaser 2100 plus Manuel utilisateur

Digital Equipment

Digital Equipment Letterprinter 100 Manuel

Digital Equipment

Digital Equipment PrintServer 32 Manuel utilisateur

Digital Equipment

Digital Equipment LA75 plus companion Manuel utilisateur

Digital Equipment

Digital Equipment Colorwriter LSR 2000+ Manuel utilisateur

Digital Equipment

Digital Equipment DECwriter 110i Manuel utilisateur

Manuels Imprimante populaires d'autres marques

Lexmark

Lexmark 1400 Series Manuel

Canon

Canon i70 Series Manuel utilisateur

Evolis

Evolis Elypso Manuel utilisateur

Kyocera

Kyocera FS-9530DN Manuel utilisateur

Canon

Canon LASER SHOT LBP-1210 Manuel utilisateur

Samsung

Samsung BIXOLON SRP-350plusF Manuel utilisateur

Canon

Canon PIXMA PRO-1 Series Manuel utilisateur

Canon

Canon PIXMA G3560 Guide de configuration

Dell

Dell Color Laser Printer 2130cn Manuel utilisateur

Tektronix

Tektronix Phaser 840 Manuel utilisateur

Epson

Epson ET-7750 Mode d'emploi

Canon

Canon CLBR 460ps Manuel utilisateur

Eltron

Eltron P210 Guide Manuel utilisateur

Ricoh

Ricoh MD-P1 Manuel utilisateur

Epson

Epson SC-F7100 series Manuel utilisateur

Epson

Epson Stylus C40UX Manuel utilisateur

Canon

Canon imagePASS-A2 Manuel utilisateur

Canon

Canon S820D Manuel utilisateur