DeLonghi DRAGON HM3 Manuel utilisateur

DRAGON HM3

We were thinking of you

when we thought of it

IMPORTANT

DO NOT OPERATE WITHOUT READING

INSTRUCTIONS FIRST

Spare copies of this leaflet can be obtained

from your dealer

Proudly distributed by

De’Longhi Australia Pty Limited

P.O. BOX 4540

CASULA MALL NSW 2170

Customer Service Ph: 1800 126 659

Fax: 1800 706932

www.delonghi.co.au

e-mail: [email protected]

De’Longhi New Zealand Limited

25 Carbine Road

Mt Wellington

Auckland, New Zealand

P.O. Box 58-056 Botany

MANUKAU 2163

Customer Service Ph: 0508 200 300

Fax: 0508 200 301

www.delonghi.co.nz

e-mail:[email protected].nz

Fig.1

Thank you for choosing this De’Longhi radiator. To get

the very best out of your new radiator it is advisable to

read these instructions before using it.This will ensure

that you gain optimum results and use the appliance

safely.

General instructions

Take the radiator out of its packing box and remove any poly-

styrene pieces or any other packaging material that might be

lodged inside it.

Make sure that the radiator has not been damaged during

transit and that the mains cable is in working order. Do not

operate the radiator if damaged.

“Easy wheel”system

Turn the radiator upside-down on a rug or a soft surface in order

to prevent damaging the paint finish. Fully unfold the castors by

turning them outwards (Fig. 1).Turn the radiator back to its upright

position.

Electrical connection

- Before plugging the radiator into the mains, check that

your supply voltage is the same as that shown on the rating

plate of the radiator.

- If using more than one appliance at a time, it is important

to ensure that the ring main is adequate to cope with the

power requirements.

- It is important to ensure that the socket is adequately

earthed.

- THIS APPLIANCE COMPLIES WITH DIRECTIVE

2004/108/EEC ON RADIO INTERFERENCE SUPPRES-

SION.

How to use it

Switching on

Plug the radiator in and position the thermostat slider to

maximum and turn the radiator on as follows using the power

selector:

• Turn the power selector to position 1 to select minimum

output (the light on the left will come on).

• Turn the power selector to position 2 to select medium

output (the light on the right will come on).

• Turn the power selector to position 3 to select maximum

output (both lights will come on).

Adjusting the thermostat

Leave the thermostat at its highest setting until the room has

reached the required temperature.Then slowly turn the ther-

mostat slider back until you hear a click.The temperature

selected in this way will then be regulated automatically and

kept constant by the thermostat.

Frost protection function

With the thermostat slider in the minimum position and a

power selected, the unit maintains the room at a temperature

of about 5˚C, preventing freezing with minimum energy con-

sumption.

Models with 24-hour timer

Using the timer

If you wish to use the timer, position the switch in the middle

position (Fig. 4).

Setting the correct time

Check the time on your watch. If for example it is 4.00 pm.

(16.00), turn the dial in a clockwise direction until the number

16 is lined up with the triangular pointer (fig.2).

N.B.: Never turn the dial in an anti-clockwise direction!

The timer is in effect an electric clock and works only if the

plug is connected to the power supply. Whenever the plug is

disconnected or there is a power failure, the clock must be

re-set.

To program the timer

1) Set the operating times by pushing in with your thumbnail

to the outer rim, the notches on the dial corresponding to

the period required (fig.3) (each notch represents 15 mins.)

2) Make sure that the timer indicates the correct time (see

instructions on setting the correct time).

3) Turn the radiatior on and set it to the heat setting and temper-

ature level on the thermostat as required.

Once programmed in this way, the appliance will repeat the

pre-established program every day, if the selector is in the

position.

Timer override

If you wish to override the timer settings, push the timer

switch to position 1 (fig.4) manual (timer override).To return

to timed operation push the switch back to the middle posi-

tion (fig.4).

Fig.2

fig.3

NOTE: if the timer switch is at the 0position (fig.4), the

heater is off and will not operate).

Cleaning and maintenance

Your oil filled raditor is absolutely free from maintenance, fully

reliable and will give many years of trouble free service.Wipe

radiator with soft damp cloth; do not use detergents or abra-

sives.

If necessary, use a vacuum cleaner to remove any built-up dirt.

Important notes

- Do not use your radiator close to bath, wash-basin, shower and

swimming pool.

- Do not use your radiator to dry laundry.

- Never place the power cable on top of the radiator while it is

hot.

- Only use the radiator in an upright position.

- The heater must be positioned at least 50 cm from furniture or

other objects.

- If the power cable has been damaged, it must be replaced by

the manufacturer or the technical service centre or by a quali-

fied person so as to avoid all risks.

- In order to eliminate the radiator’s “new” smell, set it to maxi-

mum power for at least a few hours when used for the first time.

During this operation, the room in which the radiator is located

must be ventilated.

- The power cord should be fully removed from the cord storage

unit when in use.

- The appliance is not intended for use by persons (including chil-

dren) with reduced physical, sensory or mental capabilities, or

lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a

person responsible for their safety. Children should be super-

vised to ensure that they do not play with the appliance.

- The appliance is fitted with a tilt-switch which turns the appli-

ance off if it should fall over.

To restart the appliance, simply place it upright again.

- It is perfectly normal for the radiator to make “creacking”

fig.4

sounds when used for the first time. (or in the case of unfre-

quent use).

- The radiator must not be located immediately below a fixed

socket-outlet.

- The body of this radiator is filled with a precise quantity of spe-

cial oil, so that repairs requiring the opening of the oil body

must only be made by the service agent. Any oil leakage must

be reported to the service agent.

- Do not use this appliance in rooms having a floor area of less

than 4m2as this can lead to overheating.

- If the appliance is scrapped, provisions on the disposal of oil

must be respected.

- The use of an extension lead is not recommended, as overheat-

ing of the extension lead may occur during the operation of the

radiator.

- As with any electrical appliance, whilst the instructions aim to

cover as many eventualities as possible, caution and common

sense should be applied when operating your appliance, particu-

larly in the vicinity of young children.

A safety device will turn the radiator off. To

reset, contact the technical assistance service.

ATTENTION: in order to avoid any danger caused by an

accidental resetting of the safety system, this appliance must

not be powered through an external timer.

IMPORTANT: Do not cover the radiator during

operation as this could lead to dangerous overheating,

5711010191/11.10

Table des matières

Autres manuels DeLonghi Chauffage

DeLonghi

DeLonghi HCX Series Manuel utilisateur

DeLonghi

DeLonghi HFX25S20 Manuel utilisateur

DeLonghi

DeLonghi MICATHERMIC PANEL HEATER Manuel utilisateur

DeLonghi

DeLonghi TRH0715 Manuel utilisateur

DeLonghi

DeLonghi DCH4120 Manuel utilisateur

DeLonghi

DeLonghi 6507L Manuel d'instructions d'installation

DeLonghi

DeLonghi MCH 710T Manuel utilisateur

DeLonghi

DeLonghi FAN HEATER Manuel utilisateur

DeLonghi

DeLonghi HMH550-3R Manuel utilisateur

DeLonghi

DeLonghi DCH7093ERBCA Manuel utilisateur

DeLonghi

DeLonghi Dragon4 Pro Fiche technique

DeLonghi

DeLonghi EW 7707CM Manuel utilisateur

DeLonghi

DeLonghi HMH 550R Manuel utilisateur

DeLonghi

DeLonghi TRD Series Manuel utilisateur

DeLonghi

DeLonghi HX65L22 Manuel utilisateur

DeLonghi

DeLonghi Radia S TRRS Series Manuel utilisateur

DeLonghi

DeLonghi HFS70B Manuel utilisateur

DeLonghi

DeLonghi FAN HEATER Manuel utilisateur

DeLonghi

DeLonghi DCH4590ER Manuel utilisateur

DeLonghi

DeLonghi OIL FILLED RADIATORS Manuel utilisateur

DeLonghi

DeLonghi HFX30 Series Manuel utilisateur

DeLonghi

DeLonghi DCH5531 Manuel utilisateur

DeLonghi

DeLonghi HVS Series Manuel utilisateur

DeLonghi

DeLonghi HSX Series Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur