D-Link DSL-504T Manuel utilisateur

DSL-504T User’s Manual

D-Link Systems, Inc.

Table of Contents

Table of Contents ...............................................................................................2

Package Contents .............................................................................................. 4

Installation Overview ......................................................................................... 5

Installation Requirements ..................................................................................6

Information you will need from your ADSL service provider ..............................8

Information you will need about your DSL-504T ADSL service router ............... 9

Information you will need about your LAN or computer ................................... 10

Introduction .....................................................................................................11

Features and Benefits .......................................................................................12

Standards Compatibility & Compliance ........................................................... 14

Front Panel Display .......................................................................................... 16

Rear Panel Connections ................................................................................... 17

Hardware Installation .......................................................................................18

Power ON Router ............................................................................................. 19

Network Connections ....................................................................................... 20

Basic Router Configuration ..............................................................................22

Access the Configuration Manager ................................................................... 29

Configure the Router ........................................................................................ 31

Using the Setup Wizard ................................................................................... 33

Configuring the WAN connection ..................................................................... 46

LAN IP Settings ............................................................................................... 55

DHCP Server Settings ......................................................................................56

DNS Server Settings ........................................................................................58

DSL-504T User’s Manual

D-Link Systems, Inc.

Advanced Settings ...........................................................................................60

Tools ................................................................................................................72

Status ..............................................................................................................79

Multiple Virtual Connections ............................................................................ 83

Technical Specifications ..................................................................................85

Appendix A: IP Address Setup ......................................................................... 87

Appendix B: IP Concepts ................................................................................. 90

Appendix C: Microfilters & Splitters ................................................................. 93

Contacting Technical Support ..........................................................................95

Warranty ..........................................................................................................96

Registration .....................................................................................................99

Table of Contents

DSL-504T User’s Manual

D-Link Systems, Inc.

Package Contents

D-Link DSL-504T

ADSL Ethernet Router

One twisted-pair telephone cable used for ADSL connection

One straight-through Ethernet cable

Manualon CD

QuickInstallationGuide

One AC power adapter

If any of the above items are missing, please contact your reseller.

DSL-504T User’s Manual

D-Link Systems, Inc.

Installation Overview

The procedure to install the Router can be described in general terms in the following

steps:

1. Gatherinformationandequipment neededto installthe device.Before youbegin

the actual installation make sure you have all the necessary information and

equipment.

2. Install the hardware, that is, connect the cables (Ethernet and telephone) to the

device and connect the power adapter.

3. Check the IP settings on your computer and change them if necessary so the

computer can access the web-based software built into the Router.

4. Use the web-based management software to configure the device to suit the

requirements of your ADSL account.

DSL-504T User’s Manual

D-Link Systems, Inc.

Installation Requirements

Inordertoestablish aconnectiontotheInternet itwillbenecessaryto provideinformation

to the Router that will be stored in its memory. For some users, only their account

information (Username and Password) is required.For others, various parameters that

control and define the Internet connection will be required.You can print out the two

pages below and use the tables to list this information.This way you have a hard copy

of all the information needed to setup the Router. If it is necessary to reconfigure the

device, all the necessary information can be easily accessed. Be sure to keep this

information safe and private.

Low Pass Filters

Since ADSL and telephone services share the same copper wiring to carry their

respectivesignals,a filteringmechanismmaybe necessarytoavoidmutual interference.

A low pass filter device can be installed for each telephone that shares the line with the

ADSL line.These filters are easy to install passive devices that connect to the ADSL

device and/or telephone using standard telephone cable. Ask your service provider for

more information about the use of low pass filters with your installation.

Operating Systems

The DSL-504T uses an HTML-based web interface for setup and management.The

web configuration manager may be accessed using any operating system capable of

runningwebbrowsersoftware,includingWindows98SE,WindowsME,Windows2000,

and Windows XP.

Web Browser

Any common Web browser can be used to configure the Router using the web

configuration management software.The program is designed to work best with more

recently released browsers such as Opera, Microsoft Internet Explorer® version 5.0,

Netscape Navigator® version 4.7, or later versions. The web browser must have

JavaScript enabled. JavaScript is enabled by default on many browsers. Make sure

JavaScript has not been disabled by other software (such as virus protection or web

user security packages) that may be running on your computer.

Ethernet Port (NIC Adapter)

Any computer that uses the router must be able to connect to it through the Ethernet

port on the Router. This connection is an Ethernet connection and therefore requires

thatyourcomputerbeequippedwith anEthernetportas well.Mostnotebookcomputers

are now sold with an Ethernet port already installed. Likewise, most fully assembled

desktop computers come with an Ethernet NIC adapter as standard equipment. If your

computer does not have an Ethernet port, you must install an Ethernet NIC adapter

before you can use the Router. If you must install an adapter, follow the installation

instructions that come with the Ethernet NIC adapter.

DSL-504T User’s Manual

D-Link Systems, Inc.

Additional Software

It may be necessary to install software on your computer that enables the computer to

access the Internet. Additional software must be installed if you are using the device a

simple bridge. For a bridged connection, the information needed to make and maintain

the Internet connection is stored on another computer or gateway device, not in the

Routeritself.

If your ADSL service is delivered through a Dynamic, PPPoE/PPPoA, Static, or Bridge

connection, the information needed to establish and maintain the Internet connection

can be stored in the Router.In this case, it is not necessary to install software on your

computer.Itmay howeverbenecessaryto changesomesettings inthe device,including

account information used to identify and verify the connection.

All connections to the Internet require a unique global IP address. For bridged

connections, the global IP settings must reside in aTCP/IP enabled device on the LAN

side of the bridge, such as a PC, a server, a gateway device such as a router or similar

firewall hardware.The IP address can be assigned in a number of ways.Your network

service provider will give you instructions about any additional connection software or

NIC configuration that may be required.

DSL-504T User’s Manual

D-Link Systems, Inc.

Information you will need from your ADSL service provider

Username This is the Username used to log on to your ADSL service provider’s

network.It is commonly in the form - user@isp.com.Your ADSL service

provider uses this to identify your account.

Password This is the Password used, in conjunction with the Username above, to

log on to your ADSL service provider’s network.This is used to verify the

identity of your account.

Connection

Protocol This is the method your ADSL service provider uses to send and receive

data between the Internet and your computer.Your Modem supports the

followingconnectionprotocols:Dynamic,PPPoE/PPPoA, Static,orBridge.

Protocol This is the method your ADSL service provider will use to verify your

Username and Password when you log on to their network.Your Modem

supports the PAP and CHAP protocols.

VPI This is theVirtual Path Identifier (VPI). It is used in conjunction with the

Virtual Channel Identifier (VCI) below, to identify the data path between

your ADSL service provider’s network and your computer.

VCI This is the Virtual Channel Identifier (VCI). It is used in conjunction with

the VPI above to identify the data path between your ADSL service

provider’s network and your computer.

DSL-504T User’s Manual

D-Link Systems, Inc.

Information you will need about your DSL-504T ADSL router

Username ThisistheUsernameneededaccessthe Modem’smanagementinterface.

When you attempt to connect to the device through a web browser you

will be prompted to enter this Username.The default Username for the

Modem is admin.This is a default setting and can NOT be changed.

Password This is the Password you will be prompted to enter when you access the

Modem’s management interface.The default Password is admin.This

may be changed by the user.

LAN

Subnet

Mask for

the

DSL-504T

This is the subnet mask used by the DSL-504T, and will be used

throughout your LAN. The default subnet mask is 255.255.255.0. This

can be changed later.

LAN IP

addresses

for the

DSL-504T

This is the IP address you will enter into the Address field of your web

browser to access the Modem’s configuration graphical user interface

(GUI) using a web browser.The default IP address is 192.168.1.1 and it

is referred toas the“ManagementIP”address inthis User’s Manual.This

may be changed to suit any IP address scheme the user desires.This

address will be the base IP address used for DHCP service on the LAN

when DHCP is enabled.

DSL-504T User’s Manual

D-Link Systems, Inc.

Information you will need about your LAN or computer

Ethernet NIC If your computer has an Ethernet NIC, you can connect the

DSL-504T to this Ethernet port using an Ethernet cable.You can

also use the Ethernet port on the DSL-504T to connect to other

Ethernet devices, such as a Wireless Access Point.

DHCP Client

status Your DSL-504T ADSL Modem is configured, by default, to be a

DHCP server.This means that it can assign an IP address, subnet

mask, and a default gateway address to computers on your LAN.

The default range of IP addresses the DSL-504T will assign are

from 192.168.1.2 to 192.168.1.254.Your computer (or computers)

needs to be configured to Obtain an IP address automatically

(that is, they need to be configured as DHCP clients.)

It is recommended that your collect and record this information here, or in some other

secure place, in case you have to re-configure your ADSL connection in the future.

Once you have the above information, you are ready to setup and configure your

DSL-504T ADSL Router.

The Modem may be reset to its factory default settings by performing a

Restore settings operation within the management interface (see System

Commands). If you cannot gain access to the management interface, you

may opt to use the Reset button on the rear panel of the device).

Autres manuels pour DSL-504T

Table des matières

Autres manuels D-Link Routeur réseau

D-Link

D-Link DHP-W311AV Manuel utilisateur

D-Link

D-Link DSL-3890 Manuel utilisateur

D-Link

D-Link Verizon DSL-2750B Manuel utilisateur

D-Link

D-Link DES-1024D Manuel de l'opérateur

D-Link

D-Link DVG-5402G Manuel utilisateur

D-Link

D-Link xStack DXS-3350SR Mode d’emploi

D-Link

D-Link DVG-5402SP Manuel utilisateur

D-Link

D-Link EAGLE PRO AI M15 Manuel utilisateur

D-Link

D-Link AC750 Manuel utilisateur

D-Link

D-Link DWR-953 Manuel utilisateur

D-Link

D-Link DIR-816 Manuel utilisateur

D-Link

D-Link Ethernet Broadband Router DIR-100 Manuel utilisateur

D-Link

D-Link DSL-124 Manuel utilisateur

D-Link

D-Link DSL-2640B Manuel utilisateur

D-Link

D-Link DWR-978 Manuel utilisateur

D-Link

D-Link DIR-865L Manuel utilisateur

D-Link

D-Link DIR-457U Manuel utilisateur

D-Link

D-Link DIR-610N Manuel utilisateur

D-Link

D-Link dgs-8000 SERIES Manuel

D-Link

D-Link DIS-100G-5W Manuel utilisateur

D-Link

D-Link Express EtherNetwork DI-704UP Manuel utilisateur

D-Link

D-Link Amplifi DHP-1565 Manuel utilisateur

D-Link

D-Link DI-804V Manuel utilisateur

D-Link

D-Link DES-1050G Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité