CAS CL5000 Series Manuel utilisateur

01/19/2008 CAS (USA) Corporation 99 Murray Hill Parkway East Rutherford, NJ 07073 CL5000-Series

Installation for Lantronix Internal

Ethernet

1. The internal Ethernet installation kit will contain an Ethernet I/O

board, internal Ethernet board, crossover Ethernet cable, power and

indicator lights cable, and the necessary hardware. Remove the top

cover of the CL5000. There are four chrome screws on the top. One is

under the sealing plate. On the bottom of the scale there are four

brass colored screws along the front edge of the scale. There are

also two at the rear edge of the scale, one in each corner.

2. If the scale has the old style Ethernet set up then the slot PCB as

shown in the left hand picture must be removed. Disconnect the ribbon cable

from the board. Unplug the other end of the ribbon cable from the main

board where it is plugged into the NETWORK BOARD connector. Remove the

cable.

3. Remove the dummy cover from the bottom of the scale.

4. Plug the Ethernet cable and the power/indicator light cable onto the

Ethernet I/O board.

5. Install the Ethernet I/O board into the hole where the dummy plate was

removed threading the cables up into the scale. Secure the mounting plate

with two Phillips head screws included in the hardware package.

6. If standoffs are not installed on the main board at the locations

indicated by the arrows then remove the main board and install the

standoffs using the nuts and standoffs that are part of the hardware

package.

7. Plug the internal Ethernet board into J3, the grey connector. Secure the

board with two Philips head screws included in the hardware package. If the

main board had to be removed reinstall it now.

8. Thread the cables from the Ethernet I/O board to the internal Ethernet

board. Make sure to run the cables under the load cell support bracket as

shown in the picture. When done reassemble the scale.

Autres manuels pour CL5000 Series

3

Ce manuel convient aux modèles suivants

2

Table des matières

Autres manuels CAS Échelle

CAS

CAS WEIGHING SOLUTION SWII PLUS Series Manuel utilisateur

CAS

CAS BF-1255B Manuel utilisateur

CAS

CAS CL8000 Series Manuel utilisateur

CAS

CAS DL-30 Manuel utilisateur

CAS

CAS AP Series Manuel utilisateur

CAS

CAS CL series Manuel utilisateur

CAS

CAS CASTON II Manuel utilisateur

CAS

CAS LP-1000N Series Manuel utilisateur

CAS

CAS PR-C series Manuel utilisateur

CAS

CAS SW-2 Manuel utilisateur

CAS

CAS CL7200 series Manuel utilisateur

CAS

CAS ED Series Manuel utilisateur

CAS

CAS TP Series Manuel utilisateur

CAS

CAS LP-1000N Series Manuel

CAS

CAS ECB Series Manuel utilisateur

CAS

CAS NC-100 Manuel utilisateur

CAS

CAS SW-2 Manuel utilisateur

CAS

CAS K5 Manuel utilisateur

CAS

CAS PW-2H Manuel utilisateur

CAS

CAS CL5200J Series Manuel utilisateur

CAS

CAS DL Series Manuel utilisateur

CAS

CAS CL5000J Series Manuel utilisateur

CAS

CAS ER Series Manuel utilisateur

CAS

CAS LP-II Instructions d'installation et d'entretien

Manuels Échelle populaires d'autres marques

AWS

AWS ZEO-50 Manuel utilisateur

Gima

Gima Glass Body Fat Analyzer Manuel de la liste des pièces

Seca

Seca 374 Manuel utilisateur

TEC

TEC TEC SL59 SERIES Manuel utilisateur

Axis

Axis B/E Series Manuel utilisateur

Alecto

Alecto ACW-40 Manuel utilisateur

Rice Lake

Rice Lake MSI-4260 IS Manuel utilisateur

IKA

IKA RCT basic safety control Manuel utilisateur

ADE

ADE M20011 Manuel utilisateur

Duronic

Duronic KS3000 Manuel utilisateur

Digi

Digi SM-720 Manuel utilisateur

Cardinal

Cardinal CS Series Manuel utilisateur

Korona

Korona Kastella Manuel utilisateur

A&D

A&D FC-50Ki Manuel utilisateur

BDA

BDA CAMARGUE Manuel utilisateur

Tanita

Tanita HD-357 Manuel utilisateur

Leifheit

Leifheit 03173 Manuel utilisateur

Lumme

Lumme LU-1340 Manuel utilisateur