AFe Power Advanced FLOW engineering Manuel utilisateur

®

advanced FLOW engineering

Instruction Manual P/N: 77-43018

Make: Ford Model: F-150 Year: 2011-2014 Engine: V6-3.5L (tt) EcoBoost

®

Label Qty. Description Part Number

A 1 Module R77-43018

B 1 LED Switch 05-70013

C 2 Velcro (2 Inches) 05-01244

D 4 Cable Ties 05-60167

Note: Legal in California for use on race vehicles only. The use of this device on vehicles used on public

streets or highways is strictly prohibited in California and others states that have adopted California

emission regulations.

• Please read the entire instruction manual before proceeding.

• Ensure all components listed are present.

• If you are missing any of the components, call customer support at 951-493-7100.

• Ensure you have all necessary tools before proceeding.

• Do not attempt to work on your vehicle when the engine is hot.

• Disconnect the negative battery terminal before proceeding.

• Retain factory parts for future use.

Page 2

aFepower.com

Page 3

A

B

C

D

®

Refer to Figure A for Step 1.

Step 1: Before installing the aFe POWER Module you must place your vehicles ECU in sleep mode. In

order to place your vehicles ECU in sleep mode you will need to do the following:

-If the engine is cold, open the hood, close the doors, lock the car and wait 30 seconds.

-If the engine is warm, open the hood, close the doors, lock the car and wait 20 minutes.

-If the engine is warm and you can’t wait 20 minutes, disconnect the battery.

NOTE: Do NOT open the doors or start the vehicle when one of the sensor is disconnected.

REMOVAL

Page 4

Figure A

Refer to Figure B for Steps 2-3.

Step 2: Remove engine cover to gain access to the MAP sensor.

Step 3: Locate the MAP and TMAP sensor. The MAP sensor is located on the back of the intake

manifold towards the ﬁrewall. The TMAP sensor is located on the charge intake tube just before

the throttle body.

Figure B

Page 5

REMOVAL

MAP

TMAP

®

Refer to Figures C for Steps 4-5.

Step 4: Locate and disconnect the MAP sensor connector, by pressing down on the locking tab of the

connector, and sliding it out of the sensor.

Step 5: Locate the MAP sensor jumper harness on the aFe module. This is the shorter harness. Plug the

female connector of the module to the stock MAP sensor, then take the male connector of the

module and connect to the female connector of the engine harness.

Figure C

Page 6

INSTALL

aFepower.com

Page 7

Refer to Figure D for Step 6.

Step 6: Check with the pictures to make sure the connectors are correctly connected.

Note: Make sure connections are fully engaged. Usually, connectors make a snapping sound

when fully engaged.

Figure D

INSTALL

®

Page 8

Refer to Figure E for Steps 7-8.

Step 7: Locate and disconnect the TMAP sensor connector, by pressing down on the locking tab of the

connector, and sliding it out of the sensor.

Step 8: Locate the TMAP sensor jumper harness on the aFe module. This is the longer harness. Plug the

female connector of the module into the stock TMAP sensor, then the male connector of the

module into female connector of the engine harness.

Figure E

INSTALL

Page 9

Refer to Figure F for Step 9.

Step 9: Check with the pictures to make sure the connectors are correctly connected.

Note: Make sure connections are fully engaged. Usually, connectors make a snapping sound

when fully engaged.

Figure F

INSTALL

®

Page 10

Refer to Figure G for Steps 10-11.

Step 10: Carefully route the switch cable behind steering wheel cover.

Step 11: Mount the Switch on an open, ﬂat surface.

Figure G

INSTALL

Autres manuels pour advanced FLOW engineering

1

Ce manuel convient aux modèles suivants

1

Table des matières

Autres manuels aFe Power Accessoires automobiles

aFe Power

aFe Power 77-86318 Manuel utilisateur

aFe Power

aFe Power Quantum 2500 Manuel utilisateur

aFe Power

aFe Power 77-46316 Manuel utilisateur

aFe Power

aFe Power 77-47001 Manuel utilisateur

aFe Power

aFe Power Scorcher Manuel utilisateur

aFe Power

aFe Power 77-46309 Manuel utilisateur

aFe Power

aFe Power F1-03003 Manuel utilisateur

aFe Power

aFe Power Scorpion Manuel utilisateur

aFe Power

aFe Power 51-74201 Manuel utilisateur

aFe Power

aFe Power 77-83028 Manuel utilisateur

aFe Power

aFe Power Momentum GT Manuel utilisateur

aFe Power

aFe Power 46-70270 Manuel utilisateur

aFe Power

aFe Power 52-10002D Manuel utilisateur

aFe Power

aFe Power advanced FLOW engineering Manuel utilisateur

aFe Power

aFe Power 77-43023 Manuel utilisateur

aFe Power

aFe Power 46-39102 Manuel utilisateur

aFe Power

aFe Power 77-46306 Manuel utilisateur

aFe Power

aFe Power 77-42008 Manuel utilisateur

aFe Power

aFe Power 46-71180A Manuel utilisateur

aFe Power

aFe Power dfs780 Manuel utilisateur

aFe Power

aFe Power 54-12742 Manuel utilisateur

aFe Power

aFe Power SCORPION 79-21003L Manuel utilisateur

aFe Power

aFe Power advanced FLO engineering Manuel utilisateur

aFe Power

aFe Power 54-82039 Manuel utilisateur

Manuels Accessoires automobiles populaires d'autres marques

James Baroud

James Baroud Odyssey Manuel utilisateur

Motorola

Motorola i50sx Manuel utilisateur

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuel utilisateur

Feniex

Feniex T3 Manuel utilisateur

Renault

Renault 77 11 423 180 Manuel utilisateur

Kia

Kia E8300-4D000 Manuel utilisateur

Brink

Brink 756843 Manuel utilisateur

Whispbar

Whispbar K085W Manuel utilisateur

v.link

v.link CI-VL2-PC-HSD Manuel utilisateur

Viking

Viking Stack-Rack Guide de configuration rapide

Aries

Aries 203015 Manuel utilisateur

Choetech

Choetech AT0005 Manuel utilisateur

ZZ2

ZZ2 ZZAIR-PRO Manuel utilisateur

Holman

Holman 4A80L Manuel utilisateur

Thule

Thule 2075 Manuel utilisateur

Motorola

Motorola T325 Manuel utilisateur

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guide d'installation

DV8

DV8 FBJL-02 Manuel utilisateur