Advantech TPC-650H Manuel utilisateur

TPC-650H

5.7" VGA TFT LCD Intel Atom

Touch Panel Computer

User Manual

TPC-650H User Manual ii

The documentation and the software included with this product are copy-

righted 2010 by Advantech Co., Ltd. All rights are reserved. Advantech

Co., Ltd. reserves the right to make improvements in the products

described in this manual at any time without notice. No part of this man-

ual may be reproduced, copied, translated or transmitted in any form or

by any means without the prior written permission of Advantech Co., Ltd.

Information provided in this manual is intended to be accurate and reli-

able. However, Advantech Co., Ltd. assumes no responsibility for its use,

nor for any infringements of the rights of third parties, which may result

from its use.

Acknowledgements

Intel and Pentium are trademarks of Intel Corporation.

Microsoft Windows and MS-DOS are registered trademarks of

Microsoft Corp.

All other product names or trademarks are properties of their respective

owners.

This Manual Covers the Following Models

• TPC-650H

Part No. 2003065000 1st Edition

Printed in Taiwan May 2010

iii

Product Warranty (2 years)

Advantech warrants to you, the original purchaser, that each of its prod-

ucts will be free from defects in materials and workmanship for two years

from the date of purchase.

This warranty does not apply to any products which have been repaired or

altered by persons other than repair personnel authorized by Advantech,

or which have been subject to misuse, abuse, accident or improper instal-

lation. Advantech assumes no liability under the terms of this warranty as

a consequence of such events.

Because of Advantech’s high quality-control standards and rigorous test-

ing, most of our customers never need to use our repair service. If an

Advantech product is defective, it will be repaired or replaced at no

charge during the warranty period. For out-of-warranty repairs, you will

be billed according to the cost of replacement materials, service time and

freight. Please consult your dealer for more details.

If you think you have a defective product, follow these steps:

1. Collect all the information about the problem encountered. (For

example, CPU speed, Advantech products used, other hardware

and software used, etc.) Note anything abnormal and list any

onscreen messages you get when the problem occurs.

2. Call your dealer and describe the problem. Please have your man-

ual, product, and any helpful information readily available.

3. If your product is diagnosed as defective, obtain an RMA (return

merchandize authorization) number from your dealer. This allows

us to process your return more quickly.

4. Carefully pack the defective product, a fully-completed Repair and

Replacement Order Card and a photocopy proof of purchase date

(such as your sales receipt) in a shippable container. A product

returned without proof of the purchase date is not eligible for war-

ranty service.

5. Write the RMA number visibly on the outside of the package and

ship it prepaid to your dealer.

TPC-650H User Manual iv

This product has passed the CE test for environmental specifications

when shielded cables are used for external wiring. We recommend the

use of shielded cables. This kind of cable is available from Advantech.

Please contact your local supplier for ordering information.

FCC Class A

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interfer-

ence when the equipment is operated in a commercial environment. This

equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may

cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in

which case the user will be required to correct the interference at his own

expense.

Technical Support and Assistance

Step 1. Visit the Advantech web site at www.advantech.com/support

where you can find the latest information about the product.

Step 2. Contact your distributor, sales representative, or Advantech's

customer service center for technical support if you need addi-

tional assistance. Please have the following information ready

before you call:

- Product name and serial number

- Description of your peripheral attachments

- Description of your software (operating system, version, appli-

cation software, etc.)

- A complete description of the problem

- The exact wording of any error messages

Safety Instructions

1. Read these safety instructions carefully.

2. Keep this User's Manual for later reference.

3. Disconnect this equipment from any AC outlet before cleaning.

Use a damp cloth. Do not use liquid or spray detergents for clean-

ing.

4. For plug-in equipment, the power outlet socket must be located

near the equipment and must be easily accessible.

5. Keep this equipment away from humidity.

6. Put this equipment on a reliable surface during installation. Drop-

ping it or letting it fall may cause damage.

7. The openings on the enclosure are for air convection. Protect the

equipment from overheating. DO NOT COVER THE OPENINGS.

8. Make sure the voltage of the power source is correct before con-

necting the equipment to the power outlet.

9. Position the power cord so that people cannot step on it. Do not

place anything over the power cord.

10. All cautions and warnings on the equipment should be noted.

11. If the equipment is not used for a long time, disconnect it from the

power source to avoid damage by transient overvoltage.

12. Never pour any liquid into an opening. This may cause fire or elec-

trical shock.

13. Never open the equipment. For safety reasons, the equipment

should be opened only by qualified service personnel.

14. If one of the following situations arises, get the equipment checked

by service personnel:

a. The power cord or plug is damaged.

b. Liquid has penetrated into the equipment.

c. The equipment has been exposed to moisture.

d. The equipment does not work well, or you cannot get it to work

according to the user's manual.

e. The equipment has been dropped and damaged.

f. The equipment has obvious signs of breakage.

15. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT

WHERE THE STORAGE TEMPERATURE MAY GO BELOW -

TPC-650H User Manual vi

20° C (-4° F) OR ABOVE 60° C (140° F). THIS COULD DAM-

AGE THE EQUIPMENT. THE EQUIPMENT SHOULD BE IN A

CONTROLLED ENVIRONMENT.

16. CAUTION: DANGER OF EXPLOSION IF BATTERY IS

INCORRECTLY REPLACED. REPLACE ONLY WITH THE

SAME OR EQUIVALENT TYPE RECOMMENDED BY THE

MANUFACTURER, DISCARD USED BATTERIES ACCORD-

ING TO THE MANUFACTURER'S INSTRUCTIONS.

The sound pressure level at the operator's position according to IEC 704-

1:1982 is no more than 70 dB (A).

DISCLAIMER: This set of instructions is given according to IEC 704-1.

Advantech disclaims all responsibility for the accuracy of any statements

contained herein.

Caution!

Danger of explosion if battery is incorrectly replaced. Replace only with

the same or equivalent type recommended by the manufacturer. Dispose

of used batteries according to the manufacturer's instructions.

vii Table of Contents

Contents

Chapter 1 General Information ....................................... 2

1.1 Introduction ....................................................................... 2

1.2 Specifications .................................................................... 3

1.2.1 System Kernel ................................................................ 3

1.2.2 I/O Ports ......................................................................... 3

1.2.3 Safety and Environment ................................................. 3

1.3 LCD Specifications ........................................................... 4

1.4 Touchscreen Specifications............................................... 4

1.5 Power................................................................................. 4

1.6 I/O Ports Arrangement ...................................................... 5

Figure 1.1:I/O Port Arrangement ................................... 5

1.7 Panel Mounting ................................................................. 5

Figure 1.2:Panel Mounting ............................................ 5

1.8 Dimensions and Cutout ..................................................... 6

Figure 1.3:Dimensions ................................................... 6

Chapter 2 System Setup.................................................... 8

Figure 2.1:Unpack the Package ..................................... 8

Figure 2.2:Install CompactFlash Memory Card ............ 9

Figure 2.3:Power Connector and Power Lines .............. 9

Figure 2.4:Power Receptor & Button Pin Assignment .. 9

Chapter 3 Features in Windows XP Embedded........... 12

3.1 EWF ................................................................................ 12

3.2 HORM............................................................................. 13

Appendix A Serial Port Settings........................................ 16

A.1 COM1/ COM2 Connector Definition ............................. 16

Appendix B Watchdog Timer Programming..... 18

B.1 Overview ......................................................................... 18

B.2 Watchdog Timer Programming....................................... 19

Figure B.1:Watchdog timer programming procedure .. 19

Table B.1:Watchdog Timer Registers ......................... 20

B.3 Example Programs .......................................................... 21

Appendix C Watchdog Timer

Programming on WinCE 28

C.1 Device I/O Control.......................................................... 28

C.1.1 Parameters .................................................................... 29

C.2 How to Use the Control Code ......................................... 30

C.2.1 IOCTL _WDT_ENABLE: ........................................... 30

C.2.2 IOCTL _WDT_DISABLE: .......................................... 30

C.2.3 IOCTL_WDT_STROBE: ............................................ 30

C.2.4 IOCTL_WDT_GETTIMEOUT: .................................. 31

C.2.5 IOCTL_WDT_SETTIMEOUT: .................................. 31

TPC-650H User Manual viii

C.2.6 IOCTL_WDT_REBOOT: ........................................... 31

C.3 Examples ......................................................................... 32

CHAPTER

General Information

This chapter gives background infor-

mation on TPC-650H.

Sections include:

• Introduction

• Specifications

• I/O Ports Arrangement

• Panel Mounting

• Exploded Diagrams

• Dimensions & Cutout

TPC-650H User Manual 2

Chapter 1 General Information

1.1 Introduction

The TPC-650H touch panel computer is a state-of-the-art HMI (Human

Machine Interface). This operator interface with a 5.7”display is an x86-

based platform with these key features:

• Fanless

By using a low-power processor, the system does not have to rely on

fans, which often are unreliable and causes dust to circulate inside the

equipment.

• Bright Display

The TFT LCD display suits industrial demands for clear interfaces.

• Web-based Terminal Solution

TPC-650H is designed as a Web-based terminal solution, so JavaScript

is included in the Windows operating system.

For Linux systems, we provide Mozilla Firefox.

• Windows CE Support

In addition to the OS support of Windows XP, Advantech offers plat-

form support for Windows CE and Windows XP embedded. The

optional Windows CE operating system specifically for the TPC-650H

is available for Windows CE application program builders.

Table des matières

Autres manuels Advantech Écran tactile

Advantech

Advantech PPC-315W TGL Manuel d'installation et d'exploitation

Advantech

Advantech Intel XScale PXA Touch Panel Computer TPC-66... Manuel utilisateur

Advantech

Advantech PPC-415W Manuel d'installation et d'exploitation

Advantech

Advantech PPC-A84 Manuel utilisateur

Advantech

Advantech TPC-51WP Series Manuel utilisateur

Advantech

Advantech PPC-150 Series Manuel utilisateur

Advantech

Advantech PPC-3100-RE9A Manuel d'installation et d'exploitation

Advantech

Advantech PPC-3060S Manuel utilisateur

Advantech

Advantech IPPC-8151S Series Manuel utilisateur

Advantech

Advantech SPC-515 Series Manuel utilisateur

Advantech

Advantech PPC-3100S Manuel utilisateur

Advantech

Advantech PPC-L106T Manuel utilisateur

Advantech

Advantech IPPC-5211WS Series Manuel utilisateur

Advantech

Advantech PPC-310-RJ60A Manuel d'installation et d'exploitation

Advantech

Advantech TPC-1770 Manuel utilisateur

Advantech

Advantech IPPC-9151 Series Manuel utilisateur

Advantech

Advantech UTC-307GP-ATB0E Manuel d'installation et d'exploitation

Advantech

Advantech PPC-3150SW Manuel utilisateur

Advantech

Advantech PPC-153 Manuel utilisateur

Advantech

Advantech PPC-612 Manuel utilisateur

Advantech

Advantech PPC-3151-650AE Manuel d'installation et d'exploitation

Advantech

Advantech PPC-306 EHL Manuel d'installation et d'exploitation

Advantech

Advantech SPC-821-6 Series Manuel utilisateur

Advantech

Advantech IPPC-6172F Series Manuel utilisateur

Manuels Écran tactile populaires d'autres marques

FlowLine

FlowLine Data loop Manuel utilisateur

ALPEX

ALPEX AEx-8 P Series Manuel utilisateur

Ltech

Ltech E5S Manuel utilisateur

Harman

Harman AMX MODERO S MSD-701-L2 Manuel utilisateur

Acnodes

Acnodes PC 1150 Manuel utilisateur

AIS

AIS IP10IA99 series Manuel utilisateur

IBASE Technology

IBASE Technology ASTUT-152-RE1S Manuel utilisateur

YASKAWA

YASKAWA TP 610C Manuel utilisateur

B&R

B&R Power Panel C Series Manuel utilisateur

Beijer Electronics

Beijer Electronics X2 control Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT321W-521 Manuel utilisateur

TRIDONIC.ATCO

TRIDONIC.ATCO x-touchBOX Manuel utilisateur

Qomo

Qomo QIT1386 Manuel utilisateur

DFI

DFI KS104-CD Manuel utilisateur

AMX

AMX AXP-PPC Mode d’emploi

Sartorius

Sartorius X3 PR 5410 Manuel utilisateur

AMX

AMX Modero X Series Manuel utilisateur

B&R Industries

B&R Industries MAPPC900-ENG Manuel utilisateur