Yamaha NS-10MX Manuel utilisateur

Thank you for selecting this Yamaha NS-10MX speaker system.

NS-10MX Natural Sound

Acoustic-suspension Type

2-Way Speaker System

PRECAUTIONS

Read these precautions carefully before operating

your speaker.

●When using an amplifier with a rated output power

higher than the music input of the speaker, care

should be taken never to exceed the speaker’s

music input.

●Anytime you note distortion, reduce the volume con-

trol on your amplifier to a lower setting. Never allow

your amplifier to be driven into “clipping”.

●Do not place the speaker where it will be exposed to

direct sunlight or excessive humidity to prevent it

from being damaged.

●Do not attempt to clean the speaker with chemical

solvents as this might damage the finish. To clean,

wipe with a dry, soft cloth.

●Placing the speaker on the same shelf or rack as

the turntable can result in feedback.

●Do not place the speaker where it is liable to be

knocked over or struck by falling objects. Stable

placement will also ensure better sound perfor-

mance.

●Secure placing or installing is the owner’s

responsibility.

YAMAHA shall not be liable to any accident

caused by an improper placing or installing of

the speaker.

Note

Do not let the bare speaker wires touch each other

as this could damage the speaker and/or the

amplifier.

BEFORE MAKING CONNECTIONS, MAKE SURE

THAT THE AMPLIFIER IS SWITCHED OFF.

■CONNECTIONS

●Connect the screw-type input terminals at the rear

of the speaker to the speaker output terminals of

your amplifier with the provided speaker cables.

●One side of the speaker cable is marked by a white

line. Connect the (+) terminals on both the amplifier

and the speakers using this white-marked side.

Connect the (–) terminals on both components

using the unmarked side of the cable. If connected

with reversed polarity, the sound will be unnatural

and lack bass.

Procedures:

➀Loosen the terminal knob.

➁Insert the bare wire end properly into the terminal

hole. [Remove approx. 10 mm (3/8”) insulation

from the speaker cable.]

➂Tighten the knob.

➃Test the security of the connection by tugging

lightly on the cable at the terminal.

Black(–)

Loosen Tighten

Red (+)

CONNECTION TO YOUR AMPLIFIER

Speaker cable

SPECIFICATIONS

Type .........................2 way Acoustic-suspension type

speaker system Magnetic-shielding type (EIAJ)

Speaker Unit............................18 cm cone woofer x 1

3.5 cm dome tweeter x 1

Nominal Impedance.........................................8 ohms

Frequency Response..........................60 Hz – 20 kHz

Nominal Input Power............................................60W

Music Input Power..............................................120W

Sensitivity ...................................................90 dB/w/m

Crossover Frequency.......................2 kHz, 12 dB/oct.

Dimensions (WxHxD)..................215 x 382 x 199 mm

(8-7/16” x 15-1/16” x 7-13/16”)

Weight............................................7 kg (15 lbs. 6 oz.)

Accessories............................Speaker cable (4m) x 2

* Specifications subject to change without notice due

to product improvements.

* Care should be taken not to exceed the input power

values noted above.

●Place the speaker on a sturdy, vibration-free sur-

face.

If you cannot obtain good bass quality when the

speaker is placed directly on the floor, insert a block

etc. between the speaker and the floor.

●Better stereo images will be obtained when the

speakers are slightly angled in towards the listener.

Note

Though this speaker is a magnetic shielding type,

there may be an influence on TV picture accord-

ing to the type of TV or the placement of the

speaker. In such a case, place the speaker apart

from the TV so that there is no influence on TV

picture.

PLACING THE SPEAKER REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four

points, and can be removed if desired. To remove the

cover, hold on to both sides and slowly pull straight

away from the speaker. To reattach, line up the four

pegs on the inside surface of the cover with the four

corresponding holes on the speaker and push gently.

Note

When the cover is removed, take care not to touch

the speaker units with your hands or to exert exces-

sive force with tools.

Table des matières

Autres manuels Yamaha Système de haut-parleurs

Yamaha

Yamaha SR-C20ABL Manuel utilisateur

Yamaha

Yamaha SR-C20A Manuel utilisateur

Yamaha

Yamaha NX-E100 Manuel utilisateur

Yamaha

Yamaha NS-C103 Manuel utilisateur

Yamaha

Yamaha YST-C10 Manuel utilisateur

Yamaha

Yamaha BBT110S Manuel utilisateur

Yamaha

Yamaha NS-C525 Manuel utilisateur

Yamaha

Yamaha Soavo-1 Piano Black Manuel utilisateur

Yamaha

Yamaha NS-C200 Manuel utilisateur

Yamaha

Yamaha SR-B20A Manuel utilisateur

Yamaha

Yamaha NS-AC40X Manuel utilisateur

Yamaha

Yamaha NS-AW1 Manuel utilisateur

Yamaha

Yamaha DBR Series Manuel utilisateur

Yamaha

Yamaha SR-B40A Manuel utilisateur

Yamaha

Yamaha YAS-408 Manuel utilisateur

Yamaha

Yamaha NS-100 Manuel utilisateur

Yamaha

Yamaha Installation Series Manuel utilisateur

Yamaha

Yamaha NS-5 Manuel utilisateur

Yamaha

Yamaha NS-P50 Manuel utilisateur

Yamaha

Yamaha NS-C525 Manuel utilisateur

Yamaha

Yamaha NX-B55 Manuel utilisateur

Yamaha

Yamaha NX-M5 Manuel utilisateur

Yamaha

Yamaha VXS3SB Manuel utilisateur

Yamaha

Yamaha NS-C7HX Manuel utilisateur

Manuels Système de haut-parleurs populaires d'autres marques

JVC

JVC CA-MXK5R Manuel utilisateur

LG NB4532B Manuel utilisateur

JVC

JVC CA-FSH100 Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

JVC

JVC NX-PN7 Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur

TCL

TCL 6100 Series Manuel utilisateur