Yamaha NS-5 Manuel utilisateur

Thank you for selecting this Yamaha NS-5 speaker system.

NS-5 Natural Sound

Bass-Reflex Type

2-Way Speaker System

PRECAUTIONS

Read these precautions carefully before operating

your speaker.

●When using an amplifier with a rated output power

higher than the music input of the speaker, care

should be taken never to exceed the speaker’s

music input.

●Anytime you note distortion, reduce the volume con-

trol on your amplifier to a lower setting. Never allow

your amplifier to be driven into “clipping”.

●Do not place the speaker where it will be exposed to

direct sunlight or excessive humidity to prevent it

from being damaged.

●Do not attempt to clean the speaker with chemical

solvents as this might damage the finish. To clean,

wipe with a dry, soft cloth.

●Placing the speaker on the same shelf or rack as

the turntable can result in feedback.

●Do not place the speaker where it is liable to be

knocked over or struck by falling objects. Stable

placement will also ensure better sound perfor-

mance.

●Secure placing is the owner’s responsibility.

YAMAHA shall not be liable to any accident

caused by an improper placing of the speaker.

Note

Do not let the bare speaker wires touch each other

as this could damage the speaker and/or the

amplifier.

* Banana Plug connections are also possible. First

tighten the terminal knobs, and then insert the

Banana Plug connector into the corresponding ter-

minal hole.

BEFORE MAKING CONNECTIONS, MAKE SURE

THAT THE AMPLIFIER IS SWITCHED OFF.

■CONNECTIONS

●Connect the screw-type input terminals at the rear

of the speaker to the speaker output terminals of

your amplifier with the provided speaker cables.

●One side of the speaker cable is marked by a white

line. Connect the (+) terminals on both the amplifier

and the speakers using this white-marked side.

Connect the (–) terminals on both components

using the unmarked side of the cable. If connected

with reversed polarity, the sound will be unnatural

and lack bass.

Procedures:

➀Loosen the terminal knob.

➁Insert the bare wire end properly into the terminal

hole. [Remove approx. 10 mm (3/8”) insulation

from the speaker cable.]

➂Tighten the knob.

➃Test the security of the connection by tugging

lightly on the cable at the terminal.

Black(–)

Loosen Tighten

Red (+)

White line

CONNECTION TO YOUR AMPLIFIER

SPECIFICATIONS

Type ......................2 way bass-reflex speaker system

Magnetic-shielding type (EIAJ)

Speaker Unit............13 cm cone woofer (JA1302) x 1

Tweeter (JA05C6) x 1

Nominal Impedance.........................................6 ohms

Frequency Response...........55 Hz – 30 kHz (–10 dB)

Nominal Input Power............................................40W

Music Input Power................................................80W

Sensitivity ...................................................90 dB/w/m

Dimensions (WxHxD)..................206 x 338 x 250 mm

(8-1/8” x 13-5/16” x 9-13/16”)

Weight.........................................6.5 kg (14 lbs. 5 oz.)

Accessories............................Speaker cable (4m) x 2

* Specifications subject to change without notice due

to product improvements.

* Care should be taken not to exceed the input power

values noted above.

●Place the speaker on a sturdy, vibration-free sur-

face.

If you cannot obtain good bass quality when the

speaker is placed directly on the floor, insert a block

etc. between the speaker and the floor.

●

Since this speaker has an opening on the rear panel

to decrease pressure inside the cabinet, it is recom-

mended to place it at least 10 cm (3-15/16”) apart

from the wall.

●Better stereo images will be obtained when the

speakers are slightly angled in towards the listener.

Note

Though this speaker is a magnetic shielding type,

there may be an influence on TV picture accord-

ing to the type of TV or the placement of the

speaker. In such a case, place the speaker apart

from the TV so that there is no influence on TV

picture.

PLACING THE SPEAKER REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four

points, and can be removed if desired. To remove the

cover, hold on to both sides and slowly pull straight

away from the speaker. To reattach, line up the four

pegs on the inside surface of the cover with the four

corresponding holes on the speaker and push gently.

Note

When the cover is removed, take care not to touch

the speaker units with your hands or to exert exces-

sive force with tools.

This bass-reflex type speaker has an opening on

the rear panel.

Be careful not to obstruct the opening or put some

objects into it. If doing so, the sound will be unnat-

ural or it may cause damage to the speaker

and/or amplifier.

Opening

Table des matières

Autres manuels Yamaha Système de haut-parleurs

Yamaha

Yamaha SR-B40A Manuel utilisateur

Yamaha

Yamaha YAS-105 Manuel utilisateur

Yamaha

Yamaha AEROX NS50 Manuel utilisateur

Yamaha

Yamaha NS-10M Instructions de montage

Yamaha

Yamaha NS-40M Studio Manuel utilisateur

Yamaha

Yamaha NS-625 Manuel utilisateur

Yamaha

Yamaha YAS-103 Manuel utilisateur

Yamaha

Yamaha YSP-1 Manuel utilisateur

Yamaha

Yamaha C112V Manuel utilisateur

Yamaha

Yamaha ATS-B300A Manuel utilisateur

Yamaha

Yamaha YAS-203 Manuel utilisateur

Yamaha

Yamaha IF2108(W) Manuel utilisateur

Yamaha

Yamaha NS-7390 Manuel utilisateur

Yamaha

Yamaha IF2115M/64 Manuel utilisateur

Yamaha

Yamaha IF2108 Instructions de montage

Yamaha

Yamaha NS-B951 Manuel utilisateur

Yamaha

Yamaha NS-C103 Manuel utilisateur

Yamaha

Yamaha s112 IV Manuel utilisateur

Yamaha

Yamaha NS-F101 Manuel utilisateur

Yamaha

Yamaha Electone F-25 Manuel utilisateur

Yamaha

Yamaha STAGEPAS 150M Manuel utilisateur

Yamaha

Yamaha Soavo-2 Manuel utilisateur

Yamaha

Yamaha Electone HS-8 Manuel utilisateur

Yamaha

Yamaha NS-P320 Manuel utilisateur

Manuels Système de haut-parleurs populaires d'autres marques

JVC

JVC CA-MXK5R Manuel utilisateur

LG NB4532B Manuel utilisateur

JVC

JVC CA-FSH100 Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

JVC

JVC NX-PN7 Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur

TCL

TCL 6100 Series Manuel utilisateur