Yamaha NS-C525 Manuel utilisateur

E-1

EspañolEnglish Français Deutsch

Read this before using the speaker.

•To assure the finest performance, please read this

manual carefully. Keep it in a safe place for future

reference.

•Install the speaker in a cool, dry, clean place – away

from windows, heat sources, sources of excessive

vibration, dust, moisture and cold. Avoid sources of

humming (transformers, motors). To prevent fire or

electrical shock, do not expose the speaker to rain or

water.

•To prevent the enclosure from warping or discoloring, do

not place the speaker where it will be exposed to direct

sunlight or excessive humidity.

•Do not place the following objects on the speaker:

Glass, china, etc.

If glass etc. falls by vibrations and breaks, it may cause

personal injury.

A burning candle etc.

If the candle falls by vibrations, it may cause fire and

personal injury.

A vessel with water in it

If the vessel falls by vibrations and water spills, it may

cause damage to the speaker, and/or you may get an

electric shock.

•Do not place the speaker where foreign objects such as

water drips might fall. It might cause a fire, damage to

the speaker, and/or personal injury.

PRECAUTIONS

SUPPLIED ACCESSORIES

NS-C525 Speaker System

OWNER’S MANUAL

URGT

Thank you for selecting this YAMAHA NS-C525 speaker system.

•Do not place the speaker where it is liable to be knocked

over or struck by falling objects. Stable placement will

also ensure better sound performance.

Fastener x 4

•Placing the speaker on the same shelf or rack as the

turntable can result in feedback.

•Never put a hand or a foreign object into the port located

on the rear of the speaker as this might cause personal

injury and/or damage to the speaker.

•When moving the speaker, do not hold the port as it

might cause personal injury and/or damage to the

speaker.

•Any time you note distortion, reduce the volume control

on your amplifier to a lower setting. Never allow your

amplifier to be driven into “clipping”. Otherwise the

speaker may be damaged.

•When using an amplifier with a rated output power

higher than the nominal input power of the speaker, care

should be taken never to exceed the speaker’s

maximum input.

•Do not attempt to clean the speaker with chemical

solvents as this might damage the finish. Use a clean,

dry cloth.

•Do not attempt to modify or fix the speaker. Contact

qualified YAMAHA service personnel when any service

is needed. The cabinet should never be opened for any

reasons.

•Secure placement or installation is the owner’s

responsibility.

YAMAHA shall not be liable for any accident caused

by improper placement or installation of the speaker.

E-2

CONNECTIONS TO YOUR AMPLIFIER

This speaker system is capable of standard connections and bi-wired connections. Before making

connections, make sure that the amplifier is switched off.

•Connect the screw-type input terminals at the rear of the

speaker to the speaker output terminals of the amplifier

(or receiver) with the speaker cable.

•Connect the (+) terminals on the amplifier (or receiver)

and the speaker using one side of the cable. Connect the

(–) terminals on both components using the other side of

the cable.

•Connect the speaker to the center terminals of your

amplifier, making sure not to reverse the polarity (+, –). If

the speaker is connected with reversed polarity, the

sound will be unnatural and lack bass.

How to connect:

1Loosen the knob.

2Remove the insulation coating at the extremity of each

speaker cable by twisting the coating off.

3Insert the bare wire.

4Tighten the knob and secure the cables.

Test the firmness of the connection by pulling lightly on

the cables at the terminal.

Note:

•

Do not let the bare speaker wires touch each other as this

could damage the speaker or the amplifier, or both of them.

• Do not insert the insulation coating into the hole.

The sound may not be produced.

–

CENTER

Amplifier or

Receiver

NS-C525

Tighten

PLACING THE SPEAKER

Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized.

When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points

on the bottom of the speaker and the top of the TV.

Notes:

•

Do not place the speaker on top of the TV whose area is

smaller than the bottom area of the speaker. If placed,

the speaker may drop out causing an injury to you.

•Do not place the speaker on top of the TV with an

inclination.

•Do not touch the adhesive surface after peeling off

the seal as this will weaken its adhesive strength.

Fastener

Front

NS-C525

surround

Subwoofer

•

Thoroughly wipe clean the surface where the fastener is to be

applied. Note that adhesive strength is weakened if the surface is

dirty, oily or wet and that this may cause the center speaker to drop.

•

This speaker features a magnetically shielded design, but

there is still a chance that placing it too close to a TV set

might impair picture color or create a buzzing noise. Should

this happen, move the speaker away from the TV set.

Black (–) Red (+)

surround back

Loosen

Short bar

Leave the short

bars in place

when

connecting.

Insulation coating

Bare wire

E-3

English

When using a banana plug

1Remove the cover by pulling it toward you.

2Tighten the terminal knob.

3Simply insert the banana plug into the terminal.

Banana plug

Bi-Wired Connections

This speaker system is capable of bi-wired connections. To

connect the speaker to the output terminals of the amplifier

(or receiver), two pairs of cables for each of woofer and

tweeter are used instead of standard connections. This type

of connection decreases the modulation distortion caused

by electric resistance of the cables and driving current of

the speakers. Consequently, purer sound quality can be

expected.

To utilize bi-wired connections, remove the short bars from

the terminals first, and then connect the woofer and tweeter

to the amplifier separately using two pairs of cables.

<Bi-wired connections>

–

CENTER

Amplifier or

Receiver

NS-C525

Woofer

terminals

Tweeter

terminals

Remove the short

bars before

connecting.

Short bar

Black (–) Red (+)

E-4

SPECIFICATIONS

Type ............................. 2-way bass reflex speaker system

Magnetic shielding type

Driver ...................................... 13 cm (5”) cone woofer x 2

3 cm (1”) dome tweeter

Impedance ................................................................... 6 Ω

Frequency Response ................... 57 Hz to 50 kHz (-10dB)

Nominal Input Power ................................................... 45W

Maximum Input Power ............................................. 200 W

Sensitivity .................................................. 89 dB/2.83 V/m

Crossover Frequency ................................................ 5 kHz

Dimensions (WxHxD) ...................... 500 x 170 x 226.5 mm

(19-11/16” x 6-11/16” x 8-15/16”)

Weight ................................................. 7.4 kg (16 lbs.5 oz.)

• Specifications subject to change without notice due to

product improvements.

•Care should be taken not to exceed the input power

values noted above.

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four points

and can be removed if desired. To remove the cover, hold

on to both sides and slowly pull straight away from the

speaker. To reattach, line up the four holes on the inner

surface of the cover with the four corresponding pegs on

the speaker and push gently.

Note:

When the cover is removed, take care not to touch the

speaker units with your hands or to exert excessive

force with tools.

Autres manuels pour NS-C525

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Yamaha Système de haut-parleurs

Yamaha

Yamaha ATS-1050 Manuel utilisateur

Yamaha

Yamaha A15W Manuel utilisateur

Yamaha

Yamaha NS-2HX Manuel utilisateur

Yamaha

Yamaha YHT-30 Instructions de montage

Yamaha

Yamaha TRUE X BAR 50A Manuel utilisateur

Yamaha

Yamaha NS-100S Manuel utilisateur

Yamaha

Yamaha KMS-2500 Manuel utilisateur

Yamaha

Yamaha YHT-31 Instructions de montage

Yamaha

Yamaha C215V Manuel utilisateur

Yamaha

Yamaha CBR15 Manuel utilisateur

Yamaha

Yamaha Soavo-900C Manuel utilisateur

Yamaha

Yamaha NS-AW190 Manuel utilisateur

Yamaha

Yamaha S112V Manuel utilisateur

Yamaha

Yamaha YMS-4080 Manuel utilisateur

Yamaha

Yamaha YHT-15 Instructions de montage

Yamaha

Yamaha Digital Sound Projector YSP-900 Manuel utilisateur

Yamaha

Yamaha NS-C80 Manuel utilisateur

Yamaha

Yamaha Electone HS-8 Manuel utilisateur

Yamaha

Yamaha Soavo-900M Manuel utilisateur

Yamaha

Yamaha s112 IV Manuel utilisateur

Yamaha

Yamaha YAS 71 - Air-Surround XTREME Speaker Sys Manuel utilisateur

Yamaha

Yamaha NS-5 Manuel utilisateur

Yamaha

Yamaha YSP-1 Manuel utilisateur

Yamaha

Yamaha YAS-201 Manuel utilisateur

Manuels Système de haut-parleurs populaires d'autres marques

JVC

JVC CA-MXK5R Manuel utilisateur

LG NB4532B Manuel utilisateur

JVC

JVC CA-FSH100 Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

JVC

JVC NX-PN7 Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur

TCL

TCL 6100 Series Manuel utilisateur