Vicon HPOE-100 Manuel utilisateur

HPOE-100

Network Camera Housing

INSTALLATION GUIDE

1.

Mounting Configuration and Dimensions

2.

Component Description

1

January 2016

3.

Power Consumption

D-Fog Heater

Always On (9W)

Heater

15°C On, 25°C Off (10W)

IR LEDs

3W

4.

Installation Recommendations

If you plan to install this camera enclosure into a tropical, sea coastal, or an environment where salt

water or corrosive industrial waste water/moist are present, please seal each stainless steel screws

and fittings with a silicon grease compounds. This will help prevent electrolysis to occur and extend

the life span of the camera and housing.

5.

Installation

A.

Prepare a CAT5e Ethernet cable. Pass it through the waterproofconnectors.

B.

You may need to remove the RJ45 connector, and use a crimping tool to connect the

Ethernet wires to an RJ45 connector inside the enclosure. Use an Ethernet cable ofthe

width of 5 ~ 6.5mm.

2

January 2016

C.

When done, tighten up the waterproof connectors.

D.

Align the buffer pad with the mounting hole at the bottom of the camera

E.

Place the mounting plate on top of buffer pad and then secure it to the camera. You may need

adjust its position so that the lens module can flush align with the tempered glass.

F.

Secure the camera to the enclosure by securing screws through the keyholeslots.

3

January 2016

G.

Connect PoE input to the power unit. Connect a short Ethernet cable between thePoE

output and the Ethernet port on the camera. If using the media converter, connect the

wires to the 12V output on the PSU unit.

H.

Connect the day/night signal lines from the IR unit to the relay connectors on the

camera's terminal block. The day/night mode relay connection enables the

synchronization of IR light and the automated day/night switching mechanism onthe

camera.

I.

Having the wiring done inside the enclosure, you can install the enclosure bracket to a

preferred location at your installation site. Drill mounting holes and a cable routing hole(if

preferred) on a wall. Install the bracket.

J.

Lift the whole enclosure up to the installation position, and pass the Ethernetcable

through the bracket.

PoEINfrom

external

PoEOUTto

12VDCOUT

12Vpowertothe

4

K.

Mount the enclosure on to the installed bracket, and secure the connection bytightening

the 4 socket screws. Due to the weight of the enclosure, it is best to have two men

mounting the enclosure.

January 2016

5

Vicon Industries Ltd

www.vicon-security.com

6

January 2016

Table des matières

Autres manuels Vicon Caméra de sécurité

Vicon

Vicon V922B-W551MIR-A1 Manuel utilisateur

Vicon

Vicon VC-600W Manuel utilisateur

Vicon

Vicon V662V-Series Mode d'emploi

Vicon

Vicon VC-600 Series Manuel utilisateur

Vicon

Vicon V980B Series Manuel utilisateur

Vicon

Vicon Roughneck AI V2008B-W310LPR Manuel utilisateur

Vicon

Vicon SVR-C Manuel utilisateur

Vicon

Vicon IX 8000 IR Manuel utilisateur

Vicon

Vicon SN688D-WIR Manuel utilisateur

Vicon

Vicon SVFT-W35 Manuel utilisateur

Vicon

Vicon V960-N Series Manuel d'instructions

Vicon

Vicon V661D-312IR Mode d'emploi

Vicon

Vicon V992D-N4 Manuel d'instructions

Vicon

Vicon Cruiser SN693V Manuel utilisateur

Vicon

Vicon VC-3000-DSP Manuel utilisateur

Vicon

Vicon V9360 Manuel utilisateur

Vicon

Vicon ROUGHNECK V-CELL-HD-A Manuel utilisateur

Vicon

Vicon SN683D-WIR Manuel utilisateur

Vicon

Vicon VC275-24 Guide de l'utilisateur

Vicon

Vicon Roughneck Pro V2002D-PTZ Manuel utilisateur

Vicon

Vicon I-ONYX VND-970IP Manuel utilisateur

Vicon

Vicon SN680D-A-WNIR Manuel utilisateur

Vicon

Vicon I-ONYX MPD-980DN-O Manuel utilisateur

Vicon

Vicon Roughnec V922D Series Manuel utilisateur

Manuels Caméra de sécurité populaires d'autres marques

Okina USA

Okina USA SIR36-870VF650LP Manuel utilisateur

Divio

Divio NDR155PA Manuel utilisateur

Canon

Canon VB-C500D Manuel utilisateur

Easy Access

Easy Access EasyGuard Manuel utilisateur

Vivotek

Vivotek FD9389-EHV-v2 Manuel utilisateur

TUYA

TUYA COSMO W2 Manuel utilisateur

Eusso

Eusso UNC7500-IR Guide de configuration

urmet domus

urmet domus 1096/204 Manuel utilisateur

VC

VC VC20 series Manuel utilisateur

Axis

Axis Q1614 Manuel utilisateur

ieGeek

ieGeek DD201 Manuel utilisateur

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuel utilisateur

Grundig

Grundig GCH-K0274P Manuel utilisateur

Lorex

Lorex VANTAGE LBC7032 Manuel utilisateur

4xem

4xem WPT Manuel utilisateur

Samsung

Samsung SCV-3082 Manuel utilisateur

Vitek

Vitek VTC-C544 Manuel utilisateur

Lumens

Lumens VC-A50PNW Manuel utilisateur