Ubiquiti LTU-Pro Manuel utilisateur

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

LTU-Pro Mount Bracket Bracket Clamp

Bracket Clamp Carriage Bolts (Qty. 2) Flange Nuts (Qty. 2)

Gigabit PoE (24V, 0.5A) with

Mounting Bracket

Power Cord

Package Contents

Installation Requirements

LTU PtMP AP, such as model LTU-Rocket

13 mm wrench

Surge protection should be used for all outdoor installations. We recommend that you use

two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and the other at the

entry point to the building. The ETH-SP-G2 will absorb power surges and safely discharge

them into the ground.

Note: For guidelines about grounding and lightning protection, follow your local

LTU-Pro Quick Start Guide

×

Click for

Table of Contents

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

electrical regulatory codes.

Outdoor, shielded Category 6 (or above) cabling and shielded RJ45 connectors are

required for all wired Ethernet connections.

Hardware Overview

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

Reset Button

USB-C Port

5 GHz LED

To reset to factory defaults, press and hold the Reset button for more than 10 seconds

while the device is powered on.

Reserved for future use.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

GPS LED

UNMS LED

LAN LED

Power LED

PoE In [24V] Port

Blue The LED will light blue when the link is active.

Blue

The LED will light blue when the GPS signal strength is

sufficient. This requires a minimum of three satellite

connections.

Flashing White Bootup in progress.

White

Ready for use, not connected to Ubiquiti® Network

Management System (UNMS™). See “UNMS

Management”.

Blue Ready for use, connected to UNMS.

Steady Blue with Occasional

Flashing

Ready for use, unable to connect to UNMS, check

connection to UNMS server.

Quickly Flashing Blue Used to locate a device in UNMS.

Alternating

Blue/White Firmware upgrade in progress.

Blue

The LED will light steady blue when an active Ethernet

connection is made to the Ethernet port and flash when

there is activity.

Blue The LED will light blue when the device is connected to a

power source.

This 10/100/1000 Ethernet port is used to connect the power and should be connected to

the LAN and DHCP server. Default IP address: 192.168.1.20

Pole Mounting

1.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

2.

3.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

4.

5.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

6.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

7.

8.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

9.

LTU-Pro Quick Start Guide

http://dl-origin.ubnt.com/qsg/LTU-Pro/LTU-Pro_EN.html[05.02.2020 14:09:00]

10.

Connecting Power

WARNING: The switch port must comply with the power specifications listed in the

“Specifications”.

Table des matières

Autres manuels Ubiquiti Point d'accès sans fil

Ubiquiti

Ubiquiti LTU-Lite Manuel utilisateur

Ubiquiti

Ubiquiti Bullet M5 HP Manuel utilisateur

Ubiquiti

Ubiquiti UniFi UAP-nanoHD Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam AC GENZ Manuel utilisateur

Ubiquiti

Ubiquiti NanoBeam ac Manuel utilisateur

Ubiquiti

Ubiquiti UniFi UAP--AC--HD Manuel utilisateur

Ubiquiti

Ubiquiti LiteBeam LBE-5AC-LR Manuel utilisateur

Ubiquiti

Ubiquiti NBE-5AC-Gen2 Manuel utilisateur

Ubiquiti

Ubiquiti NBE-5AC-Gen2 Manuel utilisateur

Ubiquiti

Ubiquiti UniFi nanoHD AP Manuel utilisateur

Ubiquiti

Ubiquiti airFiber AF-11 Manuel utilisateur

Ubiquiti

Ubiquiti NanoStatonM Series Manuel utilisateur

Ubiquiti

Ubiquiti UniFi HD nano UAP-HD-NANO Manuel utilisateur

Ubiquiti

Ubiquiti AmpliFi MeshPoint HD Manuel utilisateur

Ubiquiti

Ubiquiti PowerBeam AC PBE-5AC-620 Manuel utilisateur

Ubiquiti

Ubiquiti UAP-AC-M Manuel utilisateur

Ubiquiti

Ubiquiti AirMax AC Manuel utilisateur

Ubiquiti

Ubiquiti PrismStation 5AC Manuel utilisateur

Ubiquiti

Ubiquiti UAP-Outdoor-5 Manuel utilisateur

Ubiquiti

Ubiquiti GigaBeam Manuel utilisateur

Ubiquiti

Ubiquiti NBE--2AC--13 Manuel utilisateur

Ubiquiti

Ubiquiti UniFi XG Instructions d'utilisation et d'entretien

Ubiquiti

Ubiquiti airFiber AF-11 Manuel utilisateur

Ubiquiti

Ubiquiti LAP-GPS Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur

Draytek

Draytek VIGORAP 902 Manuel utilisateur

EnGenius

EnGenius EAP350 Manuel utilisateur