Sony AITe90-UL Manuel utilisateur
4-670-383-13(2)
©2002 Sony Corporation
Operating Instructions
AIT Drive
AIT-1 TAPE DRIVE
AITe90-UL
2Safety Regulations
Safety Regulations
Owner’s Record
The model and serial numbers are located on the bottom. Record the serial
number in the space provided below.
Refer to them whenever you call upon your dealer regarding this product.
Model No. Serial No.
Information
WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
MODEL No. for Regulatory Compliance
Your AIT-1 or AIT-2 TAPE DRIVE is assigned the MODEL No. SDX-D420C
or SDX-D520C (respectively) for regulatory compliance certifications. The
number is indicated on the model number label on your drive along with the
rated voltage and current.
For customers in the USA
You are cautioned that any changes or modifications not expressly approved
in this manual could void your authority to operate this equipment.
FCC Compliance
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The shielded interface cable recommended in this manual must be used with
this equipment in order to comply with the limits for a digital device pursuant
to Subpart B of Part 15 of FCC Rules.
Safety Regulations 3
English
CAUTION
The main plug on this equipment must be used to disconnect main power.
Please ensure that the socket outlet is installed near the equipment and shall be
easily accessible.
ACHTUNG
Zur Trennung vom Netz ist der Netzseker aus der Steckdose zu ziehen,
welche sich in der Nähe des Gerätes befinden muß und leicht zugänglich
sein soll.
HINWEIS
Der höchste Schalldruckpegel beträgt 70 dB (A) oder weniger gemäß ISO
7779.
NOTICE
Use the power cord set approved by the appropriate testing organization for
the specific countries where this unit is to be used.
HINWEIS
Die 3-adrige Geräteanschlußleitung muß Typ H05VV-F oder H05VVH2-F
sein und nach DIN VDE 0625 geprüft sein. Der Stecker und die
Gerätesteckdose müssen nach DIN VDE 0620 bzw DIN VDE 0625 geprüft
sein. Der Leitungsquerschnitt kann 0,5 mm2betragen wenn die
Anschlußleitung eine Länge von 2 m nicht überschreitet. Anderenfalls muß
der Leitungsquerschnitt mindestens 0,75 mm2betragen.
If you have any questions about this product, please refer to Sony contact in
the instruction manual.
DECLARATION OF CONFORMITY
Trade Name: SONY
Model: SDX-D420C or SDX-D520C
Responsible Party: Sony Electronics Inc.
Address: 680 Kinderkamack Road, Oradell NJ 07649 USA
Telephone number: 201-930-6972
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Diese Ausrüstung erfüllt die Europäischen EMC-Bestimmungen für die
Verwendung in folgender/folgenden Umgebung(en):
– Wohngegenden
– Gewerbegebiete
– Leichtindustriegebiete
(Diese Ausrüstung erfüllt die Bestimmungen der Norm EN 55022,
Klasse B.)
4Table of Contents
• Sony cannot accept liability for data written to cartridges lost as a result of using this product.
• Sony bears no responsibility for any financial damages, lost profits, or claims made by third parties
arising from the use of this product.
Table of Contents
How to Use this Guide ...................................................................... 5
Chapter 1
Introduction
About the AIT Drive........................................................................... 6
Features....................................................................................................6
System Requirements ..............................................................................7
Useable Cartridges...................................................................................7
Part Names and Functions............................................................... 8
Front Panel...............................................................................................8
Drive Status .............................................................................................9
Rear Panel..............................................................................................10
Chapter 2
Preparation
Supplied Items................................................................................. 11
Interconnections ............................................................................. 12
i.LINK ...................................................................................................13
Chapter 3
Operation
Using the AIT Drive ..............................................................................15
Removing the Cartridge ........................................................................16
Chapter 4
Care and
Maintenance
Taking Care of the Drive................................................................. 17
Safety Considerations ............................................................................17
Avoiding Damage..................................................................................17
Taking Care of Cartridges .............................................................. 19
Usage Precautions .................................................................................19
Storage Precautions ...............................................................................19
Head Cleaning ................................................................................. 20
Cleaning.................................................................................................20
Appendix Specifications.................................................................................. 21
Sony Contacts ................................................................................. 22
How to Use this Guide 5
How to Use this Guide
This guide describes how to use and care for the AITe90-UL AIT drive.
Please read it carefully before using the drive and save it for future reference.
The guide consists of four chapters and an appendix. Refer to the chapters
that relate to your use of the drive.
Chapter 1 Introduction
Describes the features of the drive, system requirements, and the names and
functions of each part.
Chapter 2 Preparation
Describes the necessary connections between the drive and the host
computer. Read this chapter when you install the drive.
Chapter 3 Operation
Describes how to use the drive, including how to turn it on, and how to insert
and remove cartridges. Read this chapter when you are going to use the drive.
Chapter 4 Care and Maintenance
Describes how to take care of the drive and cartridges, and how to clean the
drive heads. Read this chapter before using the drive.
Appendix
Contains the specifications of the drive.
Notation
IEEE 1394 and i.LINK refer to the same type of interface. In this guide, we
have used i.LINK throughout to refer to the interface.
Trademarks
• Microsoft and Windows are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
• i.LINK™ is a designation referring to IEEE 1394-1995 and IEEE 1394a-
2000. i.LINK and the i.LINK logo “ ” are trademarks of Sony
Corporation.
• All other system names, products, and services are either registered
trademarks or trademarks of their respective owners. The ™ or ® marks do
not appear in this manual.
6Chapter 1 Introduction
Chapter 1 Introduction
About the AIT Drive
The AITe90-UL is an external AIT drive using data cartridges that conform
to the AIT-1 format.
Features
The AITe90-UL AIT drive has the following features.
•Uses the Advanced Intelligent Tape (AIT) format AIT-1 data cartridges.
AIT-1 data cartridges provide 35 GB of storage (no compression) on a
230-m tape. The Read After Write function and Third Level Error
Correction Code ensure high data reliability.
•The drive comes with a data compression function, providing a maximum
of 91 GB of storage on an AIT-1 data cartridge (230-m tape).*1
•Stored data is automatically checked for compression. The drive can also
read data recorded with other devices.
•The drive is equipped with a USB and i.LINK (IEEE 1394) interface. You
can therefore connect the drive to either connector to your computer.
Note
You cannot use the USB and i.LINK interfaces simultaneously.
•The drive supports Hot Plug, which means that you can connect and
disconnect it while the drive and/or your computer is on.
*1 Assuming a 2.6:1 hardware compression ratio.
The actual degree of compression during recording depends on the system environment and
the type of data.
Chapter 1 Introduction 7
System Requirements
The following are the minimum system requirements to use the drive.
•PC/AT-compatible computer (300 MHz or faster)
•Running Windows XP, Windows 2000, Windows Me, or Windows 98
Second Edition
•CD-ROM drive (to install the software necessary to the drive)
•i.LINK and/or USB interface
Useable Cartridges
The AITe90-UL can be used with data cartridges marked with the AIT-1 logo.
AIT-1 Logo
AIT-1 Data Cartridges
Name Capacity (no compression)
SDX1-35C 35 GB
SDX1-25C 25 GB
AIT Cleaning Cartridges
Name Description
SDX1-CL AIT drive cleaning cartridge
Note
Be sure to use only data cartridges designed specifically for AIT (do not use
8 mm video cartridges) as this may damage the drive.
8Chapter 1 Introduction
Part Names and Functions
Front Panel
POWER
1
345 6 7
2
Figure 1-2. Front panel
1AIT Data Cartridge Receptacle
See page 15 for information on inserting and removing a AIT data
cartridge.
2POWER Indicator
Lights while the drive is on.
3BUSY Indicator
Lights when data is transferred through the USB or i.LINK interface. It
also lights in the following situations:
•When reading data from or writing data to a data cartridge
•When inserting or ejecting a data cartridge
4TAPE Indicator
When a AIT cartridge is inserted, the indicator lights. It also lights in the
following situations:
5STATUS Indicator
Lights when the data cartridge in the drive is write-protected. It also in
the following situations:
Inserting and removing a cartridge repeated blinking (same on-off
interval).
Cartridge deteriorated alternating long-short blinking.
Drive needs cleaning repeated long on, short off blinking.
End of tape during cleaning repeated blinking (same on-off
interval).
Drive malfunction repeated short on (once or twice),
long off blinking.
Chapter 1 Introduction 9
6EJECT Button
Push to remove a data cartridge from the drive.
7POWER Switch
Press to turn the drive on or off.
Drive Status
The status of the AITe90-UL can be interpreted by reading the indicators as
follows.
1 pulse (3.5 sec on / 0.5 sec off)
1 pulse (0.25 sec on)
2 pulses (0.25 sec on/0.5 sec off)
LED State
BUSY TAPE STATUS Activity Cartridge Other
None None None
✽1None None
Drive
Inserting/Removing
None
Drive
Inserting/Removing
Write-protected
None Inserted
Cleaning tape depleted
None Inserted None
✽1Inserted None
Reading/Writing
Inserted None
Independent
—✽2Inserted Write-protected
Independent Independent
—✽2Inserted Error rate warning✽3
—✽2—✽2—✽2—✽2Cleaning request
—✽2—✽2—✽2—✽2Self-test failure✽4
—✽2—✽2—✽2—✽2Operational error✽4
—✽2—✽2—✽2—✽2Operational error✽5
✽1Data transfer through the USB or i.LINK interface
✽2Not defined
✽3Change cartridges
✽4Reset drive
✽5Eject cartridge
off
on
1 pulse (0.25 sec on / 0.25 sec off)
10 Chapter 1 Introduction
Rear Panel
23 4
1
Figure 1-4. Rear Panel
1AC IN Connector
Connect the supplied power cable here.
2i.LINK Connectors ( )
Connects to the i.LINK connector of the host computer.
3USB Connector ( )
Connects to the USB connector of the host computer or a USB hub.
4Cooling Fan
Table des matières
Autres manuels Sony Stockage
Sony
Sony Personal Content Station Manuel utilisateur
Sony
Sony HD-EG5U Manuel utilisateur
Sony
Sony SF Series Manuel utilisateur
Sony
Sony QDH16 Manuel utilisateur
Sony
Sony MS-M16/TQ Manuel utilisateur
Sony
Sony SDT-7000 Series Manuel utilisateur
Sony
Sony VPCJ111FX Mode d’emploi
Sony
Sony ERA-MS008 Manuel utilisateur
Sony
Sony SDZ-S100 Manuel utilisateur
Sony
Sony Memory Stick PRO Duo MS-MT Series Manuel utilisateur
Sony
Sony SBS-32G1A Manuel utilisateur
Sony
Sony AITE260 - AIT E260/S Tape Drive Manuel utilisateur
Sony
Sony SDX-800V Series Instructions d'installation
Sony
Sony BKMA-U70 Manuel utilisateur
Sony
Sony Memory Stick MSA-32A Manuel utilisateur
Sony
Sony USM64C Manuel utilisateur
Sony
Sony WALKMAN CKL-NWE020 Manuel utilisateur
Sony
Sony MicroVault USM4GP Manuel utilisateur
Sony
Sony SDT 11000 - DDS Tape Drive Manuel utilisateur
Sony
Sony MS-JX8G Manuel utilisateur
Manuels Stockage populaires d'autres marques
Spectra Logic
Spectra Logic T-Series Spectra T50e Manuel utilisateur
Panasonic
Panasonic LKM-F931-1 Manuel utilisateur
Tabernus
Tabernus Enterprise Erase E2400 Manuel utilisateur
Rocstor
Rocstor COMMANDER 3F series Manuel utilisateur
HP
HP P9000 Manuel utilisateur
Western Digital
Western Digital Ultrastar Data60 Manuel utilisateur