Siemens SITRANS LR260 Guide de l'utilisateur

1 of 2

1954 Technology Drive, P.O. Box 4225

Peterborough, Ontario

K9J 7B1 / Canada

Tel.: (705) 745-2431

Fax: (705) 741-0466

www.siemens.com/sensorsystems

Siemens Canada Limited

Siemens Milltronics Process Instruments

G050212

SITRANS LR260/LR250 hybrid use on liquid applications

Equipment: SITRANS LR260 features higher gain microwave electronics, typically 15 dB higher than the

LR250. Configurations of SITRANS LR260 electronics and LR250 with 2” threaded process

connections are available as standard catalog items and others are available by special

request. Contact your Siemens representative.

While every effort was made to verify the following information, no warranty of accuracy or usability is expressed or

implied.

Applications

Appropriate applications for the LR260/250 hybrid are:

1. Longer range applications from 20 m (66 ft) to 30 m (98 ft).

2. Applications with low dielectric AND small process connections.

3. Challenging applications where turbulence or minor foam is present.

Configurations

2 inch threaded connection versions are released and available as standard options on the SITRANS LR260 catalog sheet. Any

other SITRANS LR250 process connection option is available by special request. Contact your Siemens representative.

SITRANS LR260 with 2”NPT process connection and antenna is shown below.

APPLICATION GUIDE

SITRANS LR260/LR250 hybrid use on liquid applications

AG050212 2 of 2

APPLICATION GUIDE

Signal Comparisons (Reference Conditions)

SITRANS LR250 - 2” horn SITRANS LR260 - 2” horn

A signal to noise ratio improvement of 18 dB is shown above. This gain improvement will be obtained on any target distance.

Specifications

All specifications and approvals will be per the SITRANS LR260 except process related specifications such as pressure and

process temperature as these will be derived from the LR250 process connection specification.

LR260 Programming for optimization on liquids

1. Use the Quick start wizard to setup the application then make the following additional changes:

a. Par 2.2.4.1 Algorithm: set to tF.

b. Par 2.2.4.1.2 Echo Position: set to COM.

i. COM (Center of Mass) detection method is recommended for flat surfaces (liquids) and

RE (Rising Edge) detection method is recommended for sloped surfaces (solids)

c. Par 2.2.4.3.7 Reform: set to 0. It is recommended that this filter only be used in solids applications.

Autres manuels pour SITRANS LR260

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Siemens Émetteur

Siemens

Siemens SITRANS P220 Manuel utilisateur

Siemens

Siemens sitrans PROBE LU Manuel d'instructions

Siemens

Siemens SITRANS F MASS 6000 Ex d Manuel utilisateur

Siemens

Siemens SITRANS P310 with HART Guide de l'administrateur

Siemens

Siemens 7MF4033 series Manuel utilisateur

Siemens

Siemens 7ML5431 Manuel utilisateur

Siemens

Siemens sitrans lr 460 Manuel utilisateur

Siemens

Siemens SITRANS P series Guide de l'administrateur

Siemens

Siemens TRANSMAG 2 Manuel utilisateur

Siemens

Siemens SITRANS F M MAG 5000 Manuel utilisateur

Siemens

Siemens SITRANS P series Guide de l'administrateur

Siemens

Siemens SITRANS L LU150 Manuel utilisateur

Siemens

Siemens SITRANS LR260 Manuel utilisateur

Siemens

Siemens SITRANS P DS III Manuel utilisateur

Siemens

Siemens SITRANS L Series Manuel utilisateur

Siemens

Siemens 7MF4333 series Manuel utilisateur

Siemens

Siemens sitrans lr 460 Manuel d'instructions

Siemens

Siemens SITRANS F M MAG 8000 Manuel utilisateur

Siemens

Siemens SITRANS F C MASS 6000 IP67 Manuel d'instructions

Siemens

Siemens sitrans lc 300 Manuel d'instructions

Siemens

Siemens SITRANS P LH300 Guide de l'administrateur

Siemens

Siemens SITRANS LR140 Manuel utilisateur

Siemens

Siemens SITRANS L Series Guide de l'administrateur

Siemens

Siemens CP 1242-7 GPRS V2 Manuel utilisateur

Manuels Émetteur populaires d'autres marques

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manuel du propriétaire

Honeywell

Honeywell 5816WMBR Manuel utilisateur

Kamstrup

Kamstrup READy MTU Mode d'emploi

Omega

Omega ZW Series Manuel utilisateur

ABB

ABB Field 264H Mode d’emploi

Alinco

Alinco DJ-V17T Manuel utilisateur

Dejero

Dejero EnGo 3x Manuel utilisateur

Rosemount

Rosemount 4600 Manuel utilisateur

Speaka Professional

Speaka Professional 2342740 Manuel utilisateur

trubomat

trubomat GAB 1000 Manuel utilisateur

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manuel utilisateur

Rondish

Rondish UT-11 Manuel utilisateur

MG 10JRE Manuel utilisateur

Burkert

Burkert 8177 Manuel utilisateur

Firetide

Firetide HotPort 3203 Manuel

Tele Radio

Tele Radio T9-02 Manuel utilisateur

Rotronic

Rotronic HygroFlex HF3 Series Manuel utilisateur

Jamara

Jamara FCX6 Pro Tel Manuel utilisateur